jump start JEEP CHEROKEE 2015 KL / 5.G User Guide

CAUTION!
Failure to follow these procedures could result in
damage to the charging system of the booster vehicle
or the discharged vehicle.
Connecting The Jumper Cables
1. Connect the positive(+)end of the jumper cable to the
positive(+)post of the discharged vehicle.
2. Connect the opposite end of the positive(+)jumper
cable to the positive(+)post of the booster battery.
3. Connect the negative(-)end of the jumper cable to the
negative(-)post of the booster battery.
4. Connect the opposite end of the negative(-)jumper
cable to a good engine ground (exposed metal part of
the discharged vehicle’s engine) away from the battery
and the fuel injection system.
WARNING!
Do not connect the jumper cable to the negative (-)
post of the discharged battery. The resulting electri-
cal spark could cause the battery to explode and
could result in personal injury. Only use the specific
ground point, do not use any other exposed metal
parts.
5. Start the engine in the vehicle that has the booster
battery, let the engine idle a few minutes, and then
start the engine in the vehicle with the discharged
battery.
6
WHAT TO DO IN EMERGENCIES 643

6. Once the engine is started, remove the jumper cables
in the reverse sequence:
Disconnecting The Jumper Cables
1. Disconnect the negative(-)end of the jumper cable
from the engine ground of the vehicle with the dis-
charged battery.
2. Disconnect the opposite end of the negative(-)jumper
cable from the negative(-)post of the booster battery.
3. Disconnect the positive(+)end of the jumper cable
from the positive(+)post of the booster battery.
4. Disconnect the opposite end of the positive(+)jumper
cable from the positive(+)post of the vehicle with the
discharged battery.
If frequent jump-starting is required to start your vehicle
you should have the battery and charging system in-
spected at your authorized dealer.
CAUTION!
Accessories plugged into the vehicle power outlets
draw power from the vehicle’s battery, even when not
in use (i.e., cellular phones, etc.). Eventually, if
plugged in long enough without engine operation,
the vehicle’s battery will discharge sufficiently to
degrade battery life and/or prevent the engine from
starting.
FREEING A STUCK VEHICLE
If your vehicle becomes stuck in mud, sand or snow, it
can often be moved using a rocking motion. Turn the
steering wheel right and left to clear the area around the
front wheels. Press and hold the lock button on the shift
lever. Then shift back and forth between DRIVE and
REVERSE, while gently pressing the accelerator.
644 WHAT TO DO IN EMERGENCIES

WARNING!
•Battery fluid is a corrosive acid solution and can
burn or even blind you. Do not allow battery fluid
to contact your eyes, skin, or clothing. Do not lean
over a battery when attaching clamps. If acid
splashes in eyes or on skin, flush the area imme-
diately with large amounts of water. Refer to
“Jump-Starting Procedures” in “What To Do In
Emergencies” for further information.
•Battery gas is flammable and explosive. Keep
flame or sparks away from the battery. Do not use
a booster battery or any other booster source with
an output greater than 12 Volts. Do not allow cable
clamps to touch each other.
•Battery posts, terminals, and related accessories
contain lead and lead compounds. Wash hands
after handling.
CAUTION!
•It is essential when replacing the cables on the
battery that the positive cable is attached to the
positive post and the negative cable is attached to
the negative post. Battery posts are marked positive
(+) and negative (-) and are identified on the
battery case. Cable clamps should be tight on the
terminal posts and free of corrosion.
•If a “fast charger” is used while the battery is in the
vehicle, disconnect both vehicle battery cables be-
fore connecting the charger to the battery. Do not
use a “fast charger” to provide starting voltage.
Air Conditioner Maintenance
For best possible performance, your air conditioner should
be checked and serviced by an authorized dealer at the
start of each warm season. This service should include
cleaning of the condenser fins and a performance test.
Drive belt tension should also be checked at this time.
670 MAINTAINING YOUR VEHICLE

Electric Parking Brake......................511
Electric Remote Mirrors.....................138
Electronic Brake Control System...............519
Electronic Range Select (ERS).................492
Electronic Roll Mitigation (ERM)..............523
Electronic Speed Control (Cruise Control)........187
Electronic Stability Control (ESC)..............533
Electronic Vehicle Information Center (EVIC)......286
Change Engine Oil......................351
Selectable Menu Items....................356
Emergency, In Case of
Hazard Warning Flasher..................615
Jacking...............................628
Jump Starting..........................640
Overheating...........................615
Emission Control System Maintenance..........658
Engine.................................655
Air Cleaner...........................664
Block Heater..........................480
Break-In Recommendations................116
Checking Oil Level......................661
Coolant (Antifreeze).....................728
Cooling..............................686
Exhaust Gas Caution.....................117
Fails to Start...........................474
Flooded, Starting.......................474
Fuel Requirements......................579
Jump Starting..........................640
Oil . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..661
Oil Filler Cap..........................655
Oil Filter.............................664
Oil Selection...........................662
Oil Synthetic..........................663
Overheating...........................615
Starting..............................472
Temperature Gauge......................338
EngineOil Viscosity.......................663
Engine Oil Viscosity Chart...................66310
INDEX 753

Instrument Cluster......................351
Instrument Panel and Controls................328
Instrument Panel Cover.....................702
Instrument Panel Lens Cleaning...............704
Interior Appearance Care....................702
Interior Fuses............................719
Interior Lights...........................176
Intermittent Wipers (Delay Wipers).............180
Introduction..............................4
Inverter, Power...........................306
Jacking Instructions........................632
Jack Location............................629
Jack Operation...........................628
Jump Starting............................640
Key Fob
Arm The Alarm.........................19
Panic Alarm............................25
Programming Additional Key Fobs...........18
Programming Additional Transmitters.........18
Key-In Reminder..........................15
Keyless Enter-N-Go........................38
Keyless Enter-N-Go™
Lock The Vehicle’s Doors..................393
Passive Entry Programming................393
Unlock Liftgate.........................393
Keyless Entry System.......................22
Key, Replacement..........................18
Keys...................................12
Key, Sentry (Immobilizer)....................16
Lane Change and Turn Signals................174
Lane Change Assist........................174
LaneSense..............................223
Lap/Shoulder Belts.........................55
Latches................................121
Hood................................16610
INDEX 757