hood release JEEP COMPASS 2007 1.G Owners Manual
[x] Cancel search | Manufacturer: JEEP, Model Year: 2007, Model line: COMPASS, Model: JEEP COMPASS 2007 1.GPages: 408, PDF Size: 1.71 MB
Page 123 of 408
Passing Light
You can signal another vehicle with your headlights by
lightly pulling the Multi-Function Control Lever toward
you. This will cause the headlights to turn on at high
beam and remain on until the lever is released.
NOTE:If the Multi-Function Control Lever is held in
the flash to pass position for more than 15 seconds, the
high beams will shut off. If this occurs, wait 30 seconds
for the next flash to pass operation.
TO OPEN AND CLOSE THE HOOD
To open the hood, two latches must be released. First pull
the hood release lever located on the left kick panel.Primary Hood Latch
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 123
3
Page 331 of 408
WARNING!
Fluid level should be checked on a level surface and
with the engine off to prevent injury from moving
parts and to insure accurate fluid level reading. Do
not overfill. Use only manufacturers recommended
power steering fluid.
If necessary, add fluid to restore to the proper indicated
level. With a clean cloth, wipe any spilled fluid from all
surfaces. Refer to Fluids, Lubricants, and Genuine Parts
for correct fluid types.
Front Suspension Ball Joints
There are two front suspension lower ball joints that are
permanently lubricated. Inspect these ball joints when-
ever under vehicle service is done. Damaged seals and
their corresponding potentially damaged ball joints must
be replaced.
Body Lubrication
Locks and all body pivot points, including such items as
seat tracks, doors, liftgate and hood hinges, should be
lubricated periodically to assure quiet, easy operation
and to protect against rust and wear. Prior to the appli-
cation of any lubricant, the parts concerned should be
wiped clean to remove dust and grit; after lubricating
excess oil and grease should be removed. Particular
attention should also be given to hood latching compo-
nents to insure proper function. When performing other
underhood services, the hood latch, release mechanism
and safety catch should be cleaned and lubricated.
The external lock cylinders should be lubricated twice a
year, preferably in the fall and spring. Apply a small
amount of a high quality lubricant such as MoparLock
Cylinder Lubricant directly into the lock cylinder.
MAINTAINING YOUR VEHICLE 331
7
Page 398 of 408
Hands-Free Phone (UConnectâ„¢).............. 83
Hazard Warning Flasher................... 298
Head Restraints......................... 112
Headlights............................ 355
Cleaning............................ 348
High Beam........................122,167
High Beam/Low Beam Select Switch........ 122
Passing............................. 123
Replacing............................ 355
Switch .............................. 119
Heated Seats........................... 113
Hitches
TrailerTowing ........................ 287
HomeLink(Garage Door Opener) Transmitter . . . 132
Hood Release.......................... 123
Hoses................................ 338
Ignition............................... 12
Key ................................. 12Ignition Key Removal..................... 12
Immobilizer (Sentry Key)................. 14,31
Infant Restraint.......................... 64
Information Center, Vehicle................. 176
Inside Rearview Mirror.................... 79
Instrument Cluster....................... 166
Instrument Panel and Controls.............. 164
Instrument Panel Cover................... 349
Instrument Panel Lens Cleaning............. 349
Integrated Power Module (Fuses)............ 350
Interior Appearance Care.................. 347
Intermittent Wipers (Delay Wipers)........... 127
Introduction............................. 4
Jack Location........................... 301
Jack Operation.......................301,302
Jacking Instructions...................... 302
Jump Starting.......................... 305
398 INDEX