phone JEEP COMPASS 2009 1.G Workshop Manual

Autostick............................ 260
Manual........................14,251,254
Operation........................... 256
Overdrive........................... 259
Selection of Lubricant................... 366
Transmitter Battery Service
(Remote Keyless Entry).................... 25
Transmitter, Garage Door Opener (HomeLink) . . 134
Transmitter Programming
(Remote Keyless Entry).................... 24
Transporting Pets........................ 68
Tread Wear Indicators.................... 294
Trip Odometer.......................... 171
Trip Odometer Reset Button................ 169
Turn Signals......................123,164,381
UCI Connector......................... 224
UConnect(Hands-Free Phone).............. 79
Understanding Your Instrument Panel......... 161Uniform Tire Quality Grades................ 414
Universal Consumer Interface (UCI) Connector . . . 224
Universal Transmitter..................... 134
Unleaded Gasoline....................... 307
Vanity Mirrors........................... 79
Variance, Compass....................... 182
Vehicle Certification Label................. 314
Vehicle Identification Number (VIN)............ 7
Vehicle Loading...................284,314,315
Vehicle Modifications/Alterations.............. 8
Vehicle Storage......................... 377
Vehicle Theft Alarm (Security Alarm).......... 19
Voice Recognition System (VR).............. 107
Warning Lights (Instrument Cluster
Description)........................... 163
Warning, Roll Over........................ 4
Warnings and Cautions..................... 7
INDEX 433
10

INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped. The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.