release Lexus CT200h 2014 (in English) Workshop Manual

4967-3. Do-it-yourself maintenance
CT200h_OM_OM76135E_(EE)
Unplug the connector while
pressing the lock release.
Turn the bulb base counterclock-
wise.
Set the new light bulb.
Align the 3 tabs on the light bulb with
the mounting, and insert. Turn it
clockwise to set.
Set the connector.
After installing the connector, shake
the bulb base gently to check that it is
not loose, turn the fog lights on once
and visually confirm that no light is
leaking through the mounting.
2
3
4
5
CT200h_OM_OM76135E_(EE).book Page 496 Friday, May 30, 2014 11:14 AM

5118-2. Steps to take in an emergency
CT200h_OM_OM76135E_(EE)
8
When trouble arises
If your Lexus is transported by a flat bed
truck, it should be tied down at the
locations shown in the illustration.
If you use chains or cables to tie down
your vehicle, the angles shaded in black
must be 45 °.
Do not overly tighten the tie downs or
the vehicle may be damaged.
Towing with a wheel-lift type truck
XFrom the frontXFrom the rear
Release the parking brake. Use a towing dolly under the front wheels.
Using a flat bed truck
CT200h_OM_OM76135E_(EE).book Page 511 Friday, May 30, 2014 1 1:14 AM

5138-2. Steps to take in an emergency
CT200h_OM_OM76135E_(EE)
8
When trouble arises
Enter the vehicle being towed and start the hybrid system.
If the hybrid system does not start, turn the power switch to ON mode.
Shift the shift position to N and release the parking brake.
■While towing
If the hybrid system is off, the power assist for the brakes and steering will not function,
making steering and braking more difficult.
■Wheel nut wrench
Wheel nut wrench is installed in luggage compartment. ( →P. 540, 552)
WA R N I N G
Observe the following precautions.
Failure to do so may result in death or serious injury.
■When towing the vehicle
■While towing
●When towing using cables or chains, avoid sudden starts, etc. which place excessive
stress on the eyelet, cables or chains. The towing eyelet, cables or chains may
become damaged, broken debris may hit people and cause serious damage.
●Do not turn the power switch off.
This may lead to an accident as the front wheels will be locked by the parking lock.
■Installing towing eyelet to the vehicle
Make sure that towing eyelet is installed securely.
If not securely installed, towing eyelet may come loose during towing.
NOTICE
■To prevent damage to the vehicle when towing using a wheel-lift type truck
When raising the vehicle, ensure adequate ground clearance for towing at the oppo-
site end of the raised vehicle. Without adequate clearance, the vehicle could be dam-
aged while being towed.
■To prevent body damage when towing with a sling-type truck
Do not tow with a sling-type truck, either from the front or rear.
6
7
Be sure to transport the vehicle with the front
wheels raised or with all four wheels raised off
the ground. If the vehicle is towed with the front
wheels contacting the ground, the drivetrain
and related parts may be damaged or electric-
ity generated by the operation of the motor
may cause a fire to occur depending on the
nature of the damage or malfunction.
CT200h_OM_OM76135E_(EE).book Page 513 Friday, May 30, 2014 1 1:14 AM

5158-2. Steps to take in an emergency
CT200h_OM_OM76135E_(EE)
8
When trouble arises
If a warning light turns on or a warning buzzer
sounds
Calmly perform the following actions if any of the warning lights comes on or
flashes. If a light comes on or flashes, but then goes off, this does not necessar-
ily indicate a malfunction in the system. However, if this continues to occur,
have the vehicle inspected by any authorized Lexus dealer or repairer, or
another duly qualified an d equipped professional.
Warning light and warning buzzer list
Warning lightWarning light/Details/Actions
Brake system warning light and warning buzzer (red indicator)*1
Indicates that:
• The brake fluid level is low; or
• The brake system is malfunctioning
This light also comes on when th e parking brake is not released. If
the light turns off after the parkin g brake is fully released, the sys-
tem is operating normally.
→ Immediately stop the vehicle in a safe place and contact any
authorized Lexus dealer or repairer, or another duly qualified
and equipped professional. Continuing to drive the vehicle may
be dangerous.
Brake system warning light (yellow indicator)
Indicates a malfunction in:
• The regenerative braking system; or
• The electronically controlled brake system
→ Have the vehicle inspected by any authorized Lexus dealer or
repairer, or another duly qualified and equipped professional
immediately.
Charging system warning light
Indicates a malfunction in the vehicle’s charging system
→ Immediately stop the vehicle in a safe place and contact any
authorized Lexus dealer or repairer, or another duly qualified
and equipped professional.
Low engine oil pressure warning light
Indicates that the engine oil pressure is too low
→ Immediately stop the vehicle in a safe place and contact any
authorized Lexus dealer or repairer, or another duly qualified
and equipped professional.
CT200h_OM_OM76135E_(EE).book Page 515 Friday, May 30, 2014 1 1:14 AM

5248-2. Steps to take in an emergency
CT200h_OM_OM76135E_(EE)
(If equipped)
Indicates a malfunction in the Lexus parking assist-sen-
sor All the sensor lights come on.
A buzzer also sounds.
→ Have the vehicle inspected by any authorized Lexus
dealer or repairer, or another duly qualified and
equipped professional.
(If equipped)
Indicates that a Lexus parking assist-sensor is dirty or
covered with ice
All the sensor lights flash.
A buzzer also sounds.
→ Clean the sensor.
(If equipped)
Indicates that a Lexus parking assist-sensor is dirty or
covered with ice
All the sensor lights come on.
A buzzer also sounds.
→ Clean the sensor.
Indicates that the accelerator pedal is depressed while
the shift position is in N
A buzzer also sounds.
→ Release the accelerator pedal and shift the shift
position to D or R.
Wa r n i n g m e s s a g eDetails/Actions
(Flashes)
CT200h_OM_OM76135E_(EE).book Page 524 Friday, May 30, 2014 1 1:14 AM

5258-2. Steps to take in an emergency
CT200h_OM_OM76135E_(EE)
8
When trouble arises
Indicates that the accelerator pedal is depressed to stop
the vehicle on an upward slope etc. A buzzer also sounds.
If this continues, the hybrid system may overheat.
→ Release the accelerator pedal and depress the
brake pedal.
Indicates that the traction battery power has dropped
because a long period of time has elapsed after shifting
the shift position to N
A buzzer also sounds.
→ Restart the hybrid system when starting the vehicle.
Wa r n i n g m e s s a g eDetails/Actions
(Flashes)
(Flashes)
CT200h_OM_OM76135E_(EE).book Page 525 Friday, May 30, 2014 1 1:14 AM

5268-2. Steps to take in an emergency
CT200h_OM_OM76135E_(EE)
Indicates a malfunction in the hybrid system
A buzzer also sounds.
→ Immediately stop the vehicle in a safe place and
contact any authorized Lexus dealer or repairer, or
another duly qualified and equipped professional.
Indicates that the traction battery is low
A buzzer also sounds.
→ When stopping the vehicle for a long period of time,
shift the shift position to P. The battery cannot be
charged with the shift position in N.
Indicates that the vehicle is being driven at 5 km/h (3
mph) or more with the parking brake still engaged
A buzzer also sounds.
→ Release the parking brake.
Wa r n i n g m e s s a g eDetails/Actions
(Flashes)
(Flashes)
CT200h_OM_OM76135E_(EE).book Page 526 Friday, May 30, 2014 1 1:14 AM

5298-2. Steps to take in an emergency
CT200h_OM_OM76135E_(EE)
8
When trouble arises
An attempt was made to shift the shift position to R, D or
B with the power switch on (READY indicator turned
off). A buzzer also sounds.
→ After starting the hybrid system, shift the shift posi-
tion to R, D or B
*.
*: When shifting the shift position to B, first shift the
shift position to D, and then shift the shift position to
B.
An attempt was made to shift the shift position from P
with the brake pedal released. A buzzer also sounds.
→ When shifting the shift position from P, depress the
brake pedal.
An attempt was made to shift the shift position from R to
B.
A buzzer also sounds.
The shift position automatically changed to N.
→ Shift the shift position to D, and then shift the shift
position to B.
Wa r n i n g m e s s a g eDetails/Actions
(Flashes)
(Flashes)
(Flashes)
CT200h_OM_OM76135E_(EE).book Page 529 Friday, May 30, 2014 1 1:14 AM

5538-2. Steps to take in an emergency
CT200h_OM_OM76135E_(EE)
8
When trouble arises
Remove the center deck board.
Remove the center auxiliary box.
Emergency tire puncture repair kit components
Bottle
Air pressure gauge
Compressor switch
Air release cap Stickers
Hose
Po w e r p l u g
Insertion key1
2
3
4
5
6
7
8
Taking out the emergency tire puncture repair kit
1
2
CT200h_OM_OM76135E_(EE).book Page 553 Friday, May 30, 2014 1
1:14 AM

5568-2. Steps to take in an emergency
CT200h_OM_OM76135E_(EE)
Remove the valve cap from the valve
of the punctured tire.
Remove the air release cap from the
hose.
Connect the hose to the valve.
Screw the end of the hose clockwise as
far as possible.
Check the specified tire inflation
pressure.
Tire inflation pressure is specified on the
label as shown. (→P. 5 8 5 )
Start the hybrid system. ( →P. 177)
5
6
7
8
9
CT200h_OM_OM76135E_(EE).book Page 556 Friday, May 30, 2014 1 1:14 AM