key Lexus ES300 1999 s (in English) Owner's Guide

KEYS AND DOORS
25
Locking with power door lock switch
11E005±2

1Lock 2Unlock
To lock all the doors simultaneously, push the power
door lock switch on the front side. Pushing on the
rear side will unlock them.
The same switch is also equipped on the front
passenger's side.

KEYS AND DOORS
26
Locking with rear door child±protector
11E006±2

1Lock 2Unlock
Whenever small children are in the vehicle, lock the
rear door so that it does not open from the inside.
To do this, move the knob to the lock position as
shown on the label next to the knob.

KEYS AND DOORS
27

SWITCHES
30The automatic light control sensor is on top of the
driver's side instrument panel.
Do not place anything on the instrument panel, and/or do
not affix anything on the windshield to block this sensor.
When the headlights come on, the lights automatically
turn off about 30 seconds after any of the doors is
opened and closed with the ignition key turned to the
ºACCº or ºLOCKº position. To turn them on again, turn
the ignition key to the ºONº position, or turn the headlight
switch off
and then twist the knob until the first or second
clickstop. If you are going to park for over one week,
make sure the headlight switch is off.
When the headlight switch is on with all the doors locked,
pushing the ºLOCKº button on the wireless remote
control transmitter turns off the headlights.
Daytime Running Light System
The headlights turn on at reduced intensity when the
parking brake is released with the engine started, even
with the light switch in the ºOFFº position. They will not
go off until the ignition switch is turned off.
To turn on the other exterior lights and instrument panel
lights, twist the knob to the first clickstop.
Twist the knob to the second clickstop to turn on the
headlights to full intensity for driving at night.
When setting the knob to the third clickstop (ºAUTOº),
the headlights will automatically adjust to full intensity
and/or turn on the other lights depending on the darkness of the surroundings. Likewise, as the
surroundings be
come brighter, the headlights will turn to
reduced intensity, ultimately turning off the other lights.
NOTICE
To prevent the battery from being discharged, do not leave the lights on longer than necessarywhen the engine is not running.

SWITCHES
32
12E004±1
For signaling turns, move the lever up or down in the
conventional manner.
The ignition key must be in the ºONº position.
The turn signal is self±cancelling after a turn, but after a
lane change, you may have to cancel it by hand. You can
also signal a lane change by moving the turn signal lever
partway and holding it there.
If the green light in the instrument cluster flashes faster
than normal, it indicates that the front or rear turn signal
bulb has burned out. If this indicator light does not come
on, the fuse or the indicator light itself has probably
failed.

SWITCHES
34

1Interval adjuster 2Washer on
To turn the wipers on, move the lever down until you
reach the desired speed setting.
The ignition key must be in the ºONº position.
There are 3 settings:
ºINTº position: Intermittent operation
ºLOº position: Low speed operation
ºHIº position: High speed operation
Twist the interval adjuster upward to increase the
wiping time interval between sweeps, and
downward to decrease it.
The wiper lever must be in the ºINTº position.
To make the washer squirt, pull the lever toward you
and release it.
Also, the wipers will automatically operate a couple of
times after the washer squirts even with the lever in the
ºOFFº position.
The low washer fluid warning light in the instrument
cluster comes on when the fluid level in the tank
becomes nearly empty. For information on adding
washer fluid, see ºAdding washer fluidº on page 432.
In cold weather, warm the windshield with the defroster
before using the washer. This will help prevent icing,
which could block your vision.NOTICE
Do not operate the wipers if the windshield is dry.
It may scratch the glass.

SWITCHES
38
REAR WINDOW AND OUTSIDEREAR VIEW MIRRORDEFOGGER SWITCH
12E011±1
To turn the electric rear window and outside rear
view mirror defogger on, push the switch.
The ignition key must be in the ºONº position.
The thin heater wires on the inside of the rear window
and the heater panels in the outside rear view mirrors will
quickly clear the surface. An indicator light is on when
the defogger is operating.
The system will automatically shut off when the defogger
has operated about 15 minutes.

SWITCHES
40

1For driver's window
2For front passenger's window
3For left rear window
4For right rear window
To raise or lower the windows, use the switch on
each door. The passengers' windows can also be
controlled by the switches on the driver's door.
The ignition key must be in the ºONº position. However,
even if the ignition key is turned to the ºACCº or ºLOCKº
position with all the doors closed, the window can be
operated until a front door is opened (or for about 45
seconds).
12L010

SWITCHES
42
Operating the driver's and front
passenger's windows from outside the
vehicle
The windows can be operated using an ignition key.
12E036
Insert the ignition key into the key hole on the
driver's side.
To close the windows: Turn the key in the locking
direction and hold it.
After the door is locked, the window begins to close. To
stop in the middle, return the key.
To open the windows: Turn the key in the unlocking
direction and hold it.
After the door is unlocked, the window begins to open.
To stop in the middle, return the key.

SWITCHES
43
Jam protection function
During automatic raising operation, key off raising
operation or raising operation using the ignition key from
the outside, the window stops and is lowered if
something gets caught between the window and window
frame.
If an impact is given to the window, this function may
work without anything caught.
CAUTION
 Never try jamming any part of your body to make the
jam protection function work intentionally.
 The jam protection function may not work when
something gets caught just before the window fully
closed.
CAUTION