clock LINCOLN MARK VIII 1998 User Guide

9. Remove the headlamp bulb
retaining nuts.
10. Remove the headlamp bulb
assembly.
11. Slide the headlamp level and
bracket off the bulb assembly and
remove.
12. Twist headlamp housing
counterclockwise to remove
headlamp bulb from socket.
Maintenance and care
148

To install the new low beam headlamp bulb:
1. Insert the new bulb into the
socket and twist clockwise to lock
into place.
2. Pull the headlamp level and
bracket over the bulb assembly and
snap into place.
3. Insert the bulb assembly into the
socket opening.
4. Install the retaining nuts. Tighten
them 1/4 turn past finger tight.
Maintenance and care
149

5. Position the low beam headlamp
housing cover over the bulb
assembly and rotate clockwise to
lock into place.
6. Match the remaining wire
connectors with their proper mates
and reinstall.
7. Reinstall the top bolts. Tighten
1/2 turn past finger tight.
8. Reinstall the retaining screw at
the corner of the headlamp
assembly.
Maintenance and care
150

9. Replace the sight shield.
10. Reconnect the battery ground
cable and close the hood.
Replacing the high beam headlamp bulb
To remove the high beam headlamp bulb:
1. Make sure the headlamp switch is
in the OFF position.
2. Lift the hood and remove the
sight shield located above the
headlamps.
3. Remove the high beam headlamp
housing cover by rotating it 1/4 turn
counterclockwise.
Maintenance and care
151

4. Rotate the plastic bulb base
counterclockwise and pull the bulb
assembly out of the housing.
5. Pull the bulb socket retaining clip
outward while carefully pulling up
on the plastic base of the bulb.
To install the new high beam headlamp bulb:
1. Hold the bulb by its plastic base
and insert it into the socket.
Maintenance and care
152

2. Push the bulb down into the
socket until the retaining clip snaps
over it.
3. Carefully insert the bulb assembly
into the headlamp housing while
aligning the locking tabs.
4. Rotate the bulb assembly
clockwise to lock it into place.
5. Position the headlamp cover over
the bulb assembly. Align the tabs
and rotate clockwise to lock into
place.
6. Replace the sight shield and close
the hood.
Maintenance and care
153