garage door opener MERCEDES-BENZ G500 2006 W463 Owner's Manual
[x] Cancel search | Manufacturer: MERCEDES-BENZ, Model Year: 2006, Model line: G500, Model: MERCEDES-BENZ G500 2006 W463Pages: 417, PDF Size: 9.99 MB
Page 6 of 417
Contents
Automatic transmission ..................... 149
Gear selector lever position ......... 151
Driving tips ................................... 153
Gear ranges ................................. 154
One-touch gearshifting................. 155
Emergency operation
(Limp Home Mode) ...................... 156
Transfer case ..................................... 157
Transfer case position .................. 157
Switching transfer case................ 157
Differential locks ............................... 159
A few words about differentials
and differential locks.................... 160
Switching differential locks
on and off..................................... 161
Good visibility .................................... 163
Rear view mirrors ......................... 163
Headlamp cleaning system .......... 165
Sun visors .................................... 165
Rear window defroster ................. 166Climate control ................................... 168
Setting the temperature................ 170
Adjusting air distribution
and volume ................................... 171
Defrosting ..................................... 172
Air recirculation ............................ 172
Residual engine heat utilization .... 173
Deactivating the climate control
system .......................................... 173
Air conditioning............................. 174
Rear passenger compartment
adjustable air vents....................... 174
Power windows .................................. 175
Opening and closing the windows. 175
Power tilt/sliding sunroof................... 178
Opening and closing the power
tilt/sliding sunroof ........................ 178
Driving systems .................................. 181
Cruise control ............................... 181
Rear Parking Assist* ..................... 184Loading .............................................. 187
Roof rack ...................................... 187
Cargo compartment cover ............ 187
Enlarged cargo compartment ....... 188
Split rear seat bench .................... 188
Partition net* (MB Accessory) ...... 189
Loading instructions ..................... 192
Cargo tie-down rings..................... 193
Useful features ................................... 194
Storage compartments ................. 194
Ashtrays........................................ 198
Cigarette lighter ............................ 199
Electrical outlet............................. 200
Floormats ..................................... 201
Telephone* ................................... 201
Tele Aid ......................................... 202
Garage door opener ...................... 210
Heated steering wheel .................. 215
Page 31 of 417
30 At a glance
Overhead control panel
ItemPage
1Tele Aid (emergency call
system)202
2Cargo compartment lamps118
3Right front reading lamp116
4Power tilt/sliding sunroof178
5Interior rear view mirror 41
ItemPage
6Signal transmitter buttons
for garage door opener210
7Indicator lamp for garage
door opener210
8Interior lighting control116
9Left front reading lamp116
Page 211 of 417
210 Controls in detail
Useful features
The Response Center will then unlock your
vehicle with the remote door unlocking
feature.Stolen Vehicle Recovery services
In the event your vehicle was stolen:
Report the incident to the police.
The police will issue a numbered inci-
dent report.
Pass this number on to the
Mercedes-Benz Response Center along
with your password issued to you when
you subscribed to the service.
The Response Center will then attempt
to covertly contact the vehicle’s
Tele Aid system. Once the vehicle is lo-
cated, the Response Center will con-
tact the local law enforcement and you.
The vehicle’s location will only be pro-
vided to law enforcement.
Garage door opener
The built-in remote control is capable of
operating up to three separately controlled
devices, for example garage door openers,
gate openers, or other devices compatible
with HomeLink
® or some other systems.
You can program the signal transmitter
buttons.
i
The remote door unlock feature is avail-
able if the relevant cellular phone net-
work is available.
The SOS button will flash and the mes-
sage
EMERGENCY CALL –
CALL CONNECTED
will appear in the mul-
tifunction display to indicate receipt of
the door unlock command.
Once the vehicle is unlocked, a
Response Center specialist will at-
tempt to establish voice contact with
the vehicle occupants.
If the tailgate lock was pressed for
more than 20 seconds before door un-
lock authorization was received by the
Response Center, you must wait
15 minutes before pressing the tailgate
lock again.
Page 212 of 417
211 Controls in detail
Useful features
Remote control integrated into the interior
rear view mirror
1Indicator lamp
2 3 4Signal transmitter button
5Hand-held transmitter button
6Hand-held remote control trans-
mitter (not part of the vehicle
equipment)
Warning!G
Before programming the integrated remote
control to a garage door opener or gate op-
erator, make sure people and objects are
out of the way of the device to prevent po-
tential harm or damage. When programming
a garage door opener, the door moves up or
down. When programming a gate operator,
the gate opens or closes.
Do not use the integrated remote control
with any garage door opener that lacks safe-
ty stop and reverse features as required by
U.S. federal safety standards (this includes
any garage door opener model manufac-
tured before April 1, 1982). A garage door
that cannot detect an object - signaling the
door to stop and reverse - does not meet
current U.S. federal safety standards.
i
Certain types of garage door openers
are incompatible with the integrated
opener. If you should experience diffi-
culties with programming the transmit-
ter, contact an authorized
Mercedes-Benz Light Truck Center, or
call Mercedes-Benz Customer
Assistance Center (in the USA only) at
1-800-FOR-MERCedes, or Customer
Service (in Canada) at
1-800-387-0100.
Page 214 of 417
213 Controls in detail
Useful features
Step 3:
Hold the end of the hand-held remote
control transmitter6 of the device
you wish to train approximately 2 to
5 in (5 to12 cm) away from the surface
of the integrated remote control locat-
ed on the overhead control panel,
keeping the indicator lamp1 in view.
Step 4:
Using both hands, simultaneously
press the hand-held transmitter
button5 and the desired integrated
signal transmitter button (2, 3,
or4). Do not release the buttons until
completing step 5.
The indicator lamp1 on the integrat-
ed remote control will flash, first slowly
and then rapidly.Step 5:When the indicator lamp1 flashes
rapidly, release both buttons.
Step 6:
Press and hold the just-trained inte-
grated signal transmitter button and
observe the indicator lamp1.
If the indicator lamp1 stays on con-
stantly, programming is complete and
your device should activate when the
integrated signal transmitter button is
pressed and released.Step 7:
To program the remaining two buttons,
repeat the steps above starting with
step 3.
Rolling code programming
To train a garage door opener (or other roll-
ing code devices) with the rolling code fea-
ture, follow these instructions after
completing the “Programming” portion
(steps 1 through 6) of this text. (A second
person may make the following training
procedures quicker and easier.)
Step 8:
Locate “training” button on the garage
door opener motor head unit.
i
The indicator lamp1 flashes the first
time the signal transmitter button is
programmed. If this button has already
been programmed, the indicator lamp
will only start flashing after 20 sec-
onds.
i
If the indicator lamp1 blinks rapidly
for about two seconds and then turns
to a constant light, continue with pro-
gramming steps 8 through 12 as your
garage door opener may be equipped
with the “rolling code” feature.
Page 215 of 417
214 Controls in detail
Useful features
Exact location and color of the button
may vary by garage door opener brand.
Depending on manufacturer, the “train-
ing” button may also be referred to as
“learn”or “smart” button. If there is dif-
ficulty locating the transmitting button,
refer to the garage door opener opera-
tor’s manual.
Step 9:
Press “training” button on the garage
door opener motor head unit.
The “training light” is activated.
You have 30 seconds to initiate the follow-
ing step.
Step 10:
Firmly press, hold for two seconds and
release the programmed integrated
signal transmitter button (2, 3,
or4).
Step 11:
Press, hold for two seconds and re-
lease same button a second time to
complete the training process.Some garage door openers (or other rolling
code equipped devices) may require you to
perform this procedure a third time to
complete the training.
Step 12:
Confirm the garage door operation by
pressing the programmed integrated
signal transmitter button (2, 3,
or4).
Step 13:
To program the remaining two buttons,
repeat the steps above starting with
step 3.
Gate operator/Canadian programming
Canadian radio-frequency laws require
transmitter signals to “time-out” (or quit)
after several seconds of transmission
which may not be long enough for the inte-
grated signal transmitter to pick up the sig-
nal during programming. Similar to this
Canadian law, some U.S. gate operators
are designed to “time-out” in the same
manner. If you live in Canada or if you are having dif-
ficulties programming a gate operator (re-
gardless of where you live) by using the
programming procedures, replace step 4
with the following:
Step 4:
Continue to press and hold the inte-
grated signal transmitter button (2,
3, or4) while you press and re-press
(“cycle”) your hand-held remote con-
trol transmitter6 every two seconds
until the frequency signal has been
learned. Upon successful training, the
indicator lamp1 will flash slowly and
then rapidly after several seconds.
Proceed with programming step 5 and
step 6 to complete.
Page 398 of 417
397 Index
Fuels, coolants, lubricants, etc.
Capacities 376
Functions (control system) 125, 127
Resetting 133
Fuse box 362, 363, 364
Fuses 362
Fuse box in battery box 362
Fuse box in front passenger
footwell 363
Fuse box in middle tunnel 364
Fuse box in passenger
compartment 362
G
Garage door opener 30, 210
Gasoline see Fuel
Gasoline additives 379
GAWR 274
Gear range 385
Automatic transmission 154
Limiting 154
Shifting into optimal 155
Transfer case 157
Gear range limit
Canceling 155Gear selector lever
Cleaning 287
Position 151
Position (automatic
transmission) 149
Global
Locking 94
Unlocking 94
Global Positioning System (GPS) 385
Glove box 23, 194
Closing 194
Opening 194
Good visibility 163
GPS 385
Gross Axle Weight Rating see GAWR
Gross Trailer Weight see GTW
Gross Vehicle Weight Rating see GVWR
Gross Vehicle Weight see GVW
GTW 274
GVW 274
GVWR 274H
Hard plastic trim items
Cleaning 287
Hazard warning flasher 115
Head restraints 101
Power seats 39
Synchronizing 102
Headlamp cleaning system 249
Headlamps
Automatic control 111
Cleaning 285
Cleaning system 165, 249
Switching off 58
Switching on 51
Washer fluid 382
Washer system 382
Headlight switch-off delay see Delayed
switch-off, exterior lamps
Headliner
Cleaning 287
Heated seats 104
Heated steering wheel 215
Height adjustment
Head restraints 39
Seat belts 48
Steering wheel 40