coolant temperature Mercury Mountaineer 2007 s User Guide

Oil overheat can be triggered in severe driving conditions, such as
towing heavy loads over mountainous terrain in extreme hot
temperatures. As oil temperature increases, engine and vehicle speed
will be limited. The transmission will also shift differently.
When the engine oil has cooled, the vehicle will perform normally.
When fail-safe cooling mode is activated
You have limited engine power when in the fail-safe mode, so drive the
vehicle with caution. Remember that the engine is capable of completely
shutting down automatically to prevent engine damage, therefore:
1. Pull off the road as soon as safely possible and turn off the engine.
2. Arrange for the vehicle to be taken to an authorized dealer.
3. If this is not possible, wait approximately 15 minutes for the engine to
cool.
4. Check the coolant level and replenish if low. Look for coolant leakage
in the engine compartment and under the vehicle.
Never remove the coolant reservoir cap while the engine is
running or hot.
5. Restart the engine and take your vehicle to an authorized dealer.
Driving the vehicle without repairing the engine problem
increases the chance of engine damage. Take your vehicle to an
authorized dealer as soon as possible.
FUEL FILTER
For fuel filter replacement, see your authorized dealer. Refer to
scheduled maintenance informationfor the appropriate intervals for
changing the fuel filter.
Replace the fuel filter with an authorized Motorcraft part. The
customer warranty may be void for any damage to the fuel system
if an authorized Motorcraft fuel filter is not used.
WHAT YOU SHOULD KNOW ABOUT AUTOMOTIVE FUELS
Important safety precautions
Do not overfill the fuel tank. The pressure in an overfilled tank
may cause leakage and lead to fuel spray and fire.
2007 Mountaineer(mnt)
Owners Guide (post-2002-fmt)
USA(fus)
Maintenance and Specifications
326

for 15 seconds without cranking the engine. If theindicator blinks
eight times, it means that the vehicle is not ready for I/M testing; if
the
indicator stays on solid, it means that the vehicle is ready for
I/M testing.
The OBD-II system is designed to check the emission control system
during normal driving. A complete check may take several days. If the
vehicle is not ready for I/M testing, the following driving cycle consisting
of mixed city and highway driving may be performed:
15 minutes of steady driving on an expressway/highway followed by 20
minutes of stop-and-go driving with at least four 30 second idle periods.
Allow the vehicle to sit for at least eight hours without starting the
engine. Then, start the engine and complete the above driving cycle. The
engine must warm up to its normal operating temperature. Once started,
do not turn off the engine until the above driving cycle is complete. If
the vehicle is still not ready for I/M testing, the above driving cycle will
have to be repeated.
POWER STEERING FLUID
Check the power steering fluid. Refer toscheduled maintenance
informationfor the service interval schedules.
1. Start the engine and let it run
until it reaches normal operating
temperature (the engine coolant
temperature gauge indicator will be
near the center of the normal area
between H and C).
2. While the engine idles, turn the
steering wheel left and right several
times.
3. Turn the engine off.
4. Check the fluid level in the reservoir.
5. The fluid level should be between the MIN and MAX lines. Do not add
fluid if the level is in this range.
6. If the fluid is low, add fluid in small amounts, continuously checking
the level until it reaches the correct operating range. Be sure to put the
cap back on the reservoir. Refer toMaintenance product specifications
and capacitiesin this chapter for the proper fluid type.
2007 Mountaineer(mnt)
Owners Guide (post-2002-fmt)
USA(fus)
Maintenance and Specifications
337

interior .....................................305
plastic parts ............................303
washing ....................................300
waxing .....................................301
wheels ......................................301
wiper blades ............................303
Climate control (see Air
conditioning or Heating) ............72
Clock adjust
6-CD in dash .............................31
AM/FM/CD .................................25
Compass, electronic
set zone adjustment ...............116
Console ..................................91–92
overhead ....................................90
rear ............................................92
Controls
power seat ...............................144
steering column ........................99
Coolant
checking and adding ..............320
refill capacities ................324, 342
specifications ..........................342
Cruise control
(see Speed control) ....................96
Customer Assistance ................264
Ford Extended Service
Plan ..........................................296
Getting assistance outside the
U.S. and Canada .....................297
Getting roadside assistance ...264
Getting the service you
need .........................................292
Ordering additional owner’s
literature .................................298
Utilizing the
Mediation/Arbitration
Program ...................................296D
Daytime running lamps
(see Lamps) ................................78
Defrost
rear window ..............................75
Dipstick
automatic transmission
fluid ..........................................338
engine oil .................................313
Driveline universal joint and
slip yoke ....................................339
Driving under special
conditions ..................254, 258, 260
sand .........................................259
snow and ice ...........................261
through water .................260, 263
Dual automatic temperature
control (DATC) ...........................72
DVD system .................................43
E
Electronic message center .......106
Emergencies, roadside
jump-starting ..........................284
Emergency Flashers .................266
Emission control system ..........334
Engine ........................................346
cleaning ...................................302
coolant .....................................320
fail-safe cooling .......................325
idle speed control ...................318
lubrication specifications .......342
refill capacities ........................342
service points ..................310–311
starting after a collision .........266
Engine block heater .................238
2007 Mountaineer(mnt)
Owners Guide (post-2002-fmt)
USA(fus)
Index
352