battery replacement Mercury Villager 1997 Owner's Manuals

116
[CF74400(ALL)01/96]
13-1/2 pica
art:0040305-A
Replacing the batteries
[CF74500(ALL)05/96]
Remove the two batteries by snapping open the lid of the
remote transmitter. The transmitter can be snapped apart by
twisting a thin coin between the two halves of the transmitter.
Replace the batteries with new ones as shown in the above
illustration. Close the lid securely. Press both the LOCK and the
UNLOCK button two or three times to test the remote
transmitter operation.
[CF74600(ALL)01/96]
If the batteries are removed for any reason other than
replacement, repeat the steps inReplacing the batteriesto test
your remote transmitter(s).
[CF74700(ALL)01/96]
n
An improperly disposed battery can hurt the environment.
Always confirm local regulations for battery disposal.
[CF74800(ALL)01/96]
n
The remote transmitter is waterproof; however, if it does get
wet, immediately wipe it completely dry.
[CF75000(ALL)01/96]
n
The operational range of the remote transmitter extends to
approximately 49 feet (15 meters) from the vehicle. This
range may vary with conditions.
File:05vxcfn.ex
Update:Thu May 30 09:49:09 1996

Maintenance and Care
297
%*
[MC21050(ALL)05/96
]
NOTE: Always dispose of used automotive fluids in a
responsible manner. Follow your community's
standards for disposing of these types of fluids. Call
your local recycling center to find out about recycling
automotive fluids.
*
[MC21060(ALL)01/96]
NOTE: Always use Motorcraft MERCONHor equivalent
MERCONHautomatic transaxle fluid when you refill
your automatic transaxle fluid.
%*
[MC21310(ALL)01/96]
Battery
[MC21315(ALL)05/96]
The Motorcraft low-maintenance battery requires periodic
service as detailed below. The low-maintenance battery has
removable vent caps for checking the electrolyte level and for
adding water, if needed. For longer, trouble-free operation, keep
the top of the battery clean and dry. Also, make certain the
battery cables are tightly fastened to the battery terminals.
*
[MC21320(ALL)05/96]
If you see any corrosion on the battery cables or terminals,
remove the cables from the terminal and clean them both with a
wire brush. You can neutralize the acid with a solution of
baking soda and water. Reinstall the cables when you are done
cleaning them, and apply a small quantity of grease to the top
of each battery terminal to help prevent corrosion.
*
[MC21325(ALL)01/96]
Battery replacement
[MC21330(ALL)05/96]
If your original equipment battery requires replacement while
under warranty, it may be replaced by a Motorcraft
low-maintenance battery. The low-maintenance battery has
removable vent caps for checking the electrolyte level and for
adding water, if needed.
[MC21335(ALL)05/96]
Check the electrolyte level of each cell (there are six) at least
every 12 months or 12,000 miles (20,000 km). Keep the
electrolyte level between the MAX and MIN lines that are on
the side of the battery (you will have to remove the battery
cover to see the fill lines on the battery). Do not overfill the
File:11vxmcn.ex
Update:Mon Jun 10 15:17:05 1996

318
%*
[MC38590(ALL)03/96
]
How to Prepare Your Vehicle for
Inspection/Maintenance (I/M) Testing
*
[MC38595(ALL)05/96]
In some localities it may become a legal requirement to pass an
Inspection/Maintenance (I/M) test of the On-Board Diagnostic
(OBD) II system. If the vehicle's powertrain system or its battery
has just been serviced, the OBD II system is reset to a not ready
for I/M testing condition. To prepare for I/M testing, the law
specifies that additional mixed city and highway driving is
required to complete the check of the OBD II system.
*
[MC38602(ALL)03/96]
The driving modes required to reach the ready condition consist
of a minimum of 30 minutes of city and highway driving as
described below.
*
[MC38607(ALL)03/96]
n
20 minutes of driving in stop and go city-type traffic with at
least four idle periods.
*
[MC38612(ALL)03/96]
n
10 minutes of driving on an expressway or highway.
*
[MC38617(ALL)05/96]
Before completing the above driving modes, the engine must be
warmed up and at operating temperature. Once started, the
vehicle must not be turned off during the above driving modes.
If the vehicle owner is unable to meet the I/M requirements by
using these driving patterns, an authorized service center can
perform a detailed OBD II drive cycle as it would any other
type of repair work.
%*
[MC38700(ALL)03/96]
Lights and Bulb Replacement
*
[MC38800(ALL)01/96]
It is a good idea to check the operation of the following lights
frequently:
*
[MC38900(ALL)01/96]
n
headlamps
*
[MC38950(ALL)01/96]
n
high-mount brakelamp
*
[MC39000(ALL)01/96]
n
tail lamps
*
[MC39100(ALL)01/96]
n
brakelamps
File:11vxmcn.ex
Update:Mon Jun 10 15:17:05 1996

402
U
Used engine oil, disposal..............278, 297
V
Variable interval wipers................. 89
Vehicle Identification Number (VIN).......... 356
Vehicle loading
calculating the load................. 234
understanding loading information.......... 229
Vehicle storage.................... 336
Ventilating your vehicle (see Climate control)....... 56
Viscosity (see Engine oil)................ 281
Voltmeter (see Battery voltage gauge)........... 13
W
Warning chimes
headlamps on.................... 17
key in ignition.................... 17
safety belt...................... 11
Warranties, radio.................... 52
Warranty Information Booklet.............. 3
Washer fluid...................... 89
warning light..................... 17
Weight limits (GAWR, GVWR)............. 229
Wheel and tire matching................ 305
Wheel bearings lubricant specifications......... 343
Wheel dollies (see Towing)............... 274
Wheels
anti-theft lugnuts.................. 263
cleaning...................... 334
covers....................... 260
inspection and maintenance............. 301
lug nuts...................... 260
replacement.................... 305
File:vxixn.ex
Update:Fri Jun 14 07:38:49 1996