fold seats MITSUBISHI CARISMA 2000 1.G Owners Manual

SEATS AND SEATBELTS
3–5
G21E025a
Lumbar support adjustment
(driver’s side only)
EG21E–L
A lumbar support adjustment is located in
the seatback of the driver’s seat. the support
has a two position adjustment.
1-Strong
2- Weak
G02C064a
Rear seatEG02CAJ
Folding the seatback forward
The right and left seatbacks can be folded
forward separately.
Push the seatback forward
Push the seatback until it clicks and check
if the seatback is locked.
NOTE
The passenger and luggage compart-
ments can be joined by folding the rear
seatback forward. This is useful for carry-
ing long objects. (Sedan only)
G02C074a
Folding the seat (Hatchback)EG02C–Za
1. Remove the rear shelf panel and rear
head restraints.
Refer to the description of “Rear shelf
panel” on page NO TAG and “Head re-
straints” on page 3–7.

SEATS AND SEATBELTS
3–6
G02C026a
2. Pull the band (between the seat
cushion and seatback) to raise the
seat cushion.
G02C021a
NOTE
After raising the seat cushion, lay the head
restraints, removed from the rear seat, on the
floor as shown in the illustration.
G02C065a
3. Push the button to fold the seatback.

SEATS AND SEATBELTS
3–7
G02C066a
Anti-theft lockEG02D–Aa
The anti-theft lock is located on the top of the
rear seatback. The cylinder is operated with
the master key (A).
When the lock is in the “LOCK” position, the
seatback cannot be folded down by using
the seatback release button.
This feature is useful to help prevent theft
when the vehicle is parked in an exposed
area, because the “trunk through” feature
does not then apply.
The seatback can be folded down when the
lock is turned to the “FREE” position.
1-Lock
2-Free
At other times, leave the lock at the “FREE”
position.
Head restraintsEG26AAP
WARNING
(1) The head restraints can only pro-
tect you if they are correctly ad-
justed.
(2) A cushion or similar device
should not be placed on the seat-
back as it may increase the dis-
tance between your head and the
head restraint and reduce the ef-
fectiveness of the restraint.
G26A075a
Height adjustment
Adjust the head restraint height so that the
centre of the restraint is as close as possible
to eye level to reduce the chances of injury
in the event of collision. Any person too tall
for the restraint to reach their seated eye
level, should adjust the restraint as high as
possible.
To raise the head restraint, move it upward.
To l o w e r the restraint, move it downward
while pushing the height adjusting knob (A)
in the direction of the arrow. After adjustment,
push the head restraint downward and make
sure that it is locked.