seats MITSUBISHI OUTLANDER XL 2012 User Guide

Seat and restraint systems
2-13
2 Second row seats (60/40 split fold/tumble
seats)
N00402500205
When sitting in the second row seat, adjust the head restraints
to heights at which they lock in position. Refer to “Head
restraints” on page 2-26. To adjust the seat forward or backward (vehicles
with second row seat slide function)Pull the seat adjusting lever and gently rock the seat forward or
backward to the desired position. Release the adjusting lever to
lock the seat in place.NOTE
You can adjust the seat forward or backward on either side
separately.
WA R N I N G
!
To make sure that the seat is securely locked, try to
move it forward or backward without using the
adjusting lever.
CAUTION
!
When sliding (vehicles with second row seat slide
function) or reclining the seat rearward, pay careful
attention to the third row seat passengers.
BK0138000US.book 13 ページ ２０１１年４月１３日　水曜日　午前１１時１７分

2-14 Seat and restraint systems
2
To adjust the seatbacksTo adjust the seatback, lean forward slightly, gently pull the
seatback lock lever, then lean backward to a comfortable posi-
tion and release the lever. The seatback will lock in place.NOTE
You can adjust the seatback forward or backward on either
side separately.
WA R N I N G
!
To reduce the risk of serious injury or death in the
event of an accident or sudden stop, all seatbacks
should be kept in the upright position while the vehi-
cle is in motion.

Seat belt performance during an accident can be
adversely affected if the seatbacks are reclined. The
more a seatback is reclined, the more likely seat belt
performance will be adversely affected. If the seat
belt is not properly positioned against the body dur-
ing an accident, there is increased risk you will slide
under the belt and receive serious injury or death.
When a person is sitting in the middle seating posi-
tion of the second row seats, the two sides of the sec-
ond seats must have the same forward/backward
position (vehicles with second row seat slide func-
tion) and the same seatback angle. Otherwise, the
seat belt for the middle seating position may not be
adequately effective in the event of hard braking or
a collision.
CAUTION
!
The reclining mechanism used in the seatback is
spring loaded, and will cause the seatback to return
quickly to the vertical position when the lock lever is
operated. When pulling the lever, sit close to the
seatback or hold the seatback with your hand to
control its return motion.
WA R N I N G
!
BK0138000US.book 14 ページ ２０１１年４月１３日　水曜日　午前１１時１７分

Seat and restraint systems
2-15
2
Arm rest
N00403000236
Tilt the arm rest down for use as shown.
The arm rest includes a cup holder.NOTE
Never sit on an arm rest.
Doing so could damage the arm rest.
Accessing the underfloor-stowable compact 3rd
row seat (Seating 7 passengers)
N00400100021
Access to the third row seat is possible by folding the second
row seat out of the way. Refer to “Folding the second row
seats” on page 2-30.
BK0138000US.book 15 ページ ２０１１年４月１３日　水曜日　午前１１時１７分

2-16 Seat and restraint systems
2Third row seat (Seating 7 passengers)
N00419500063
The third row seat can be used for two additional passengers.
When the third row seat is not in use, it can be stowed under
the floor to provide more cargo area.
WA R N I N G
!
The third row seats are intended for use by no more
than two belted occupants, each of which does not
exceed 160 cm (63 inches) in height.
Exceeding these limitations can result in an
increased risk of personal injury or death in the
event of an accident.
The third row seats are not intended for use by
infants and small children who must use rear facing
or forward facing child safety seats.
Third row seat operation should always be made
before driving. Operating the seat while driving
could cause the seat to move more than necessary
and result in a serious injury or death.
Before using, check that the third row seat is firmly
secured. If not secured, the third row seat could
move and cause a serious injury or death in an acci-
dent.
The third row seat should not be used when the sec-
ond row seats are folded forward. Third row seat
passengers can suffer a serious or fatal injury if the
second row seats fell backward in a collision or when
heavy breaking is applied.

When using the third row seat, always position and
lock the head restraints on top of the seat back.
See the steps 6 and 7 of the procedure for folding out
the third seat.
For vehicles equipped with the cargo area cover,
when the third row seat is in use, always remove the
cargo area cover to avoid serious injury or death in
the event of an accident.
Refer to “Cargo area cover”, page 3-287.
CAUTION
!
The third row seat should be adjusted only by an
adult. If it is adjusted by a child, an unexpected acci-
dent might occur.
When adjusting the third row seat, keep your hands
and feet away from moving parts and the space
below the seat.
Be careful not to touch the exhaust pipe, because it
will remain hot for some time after the engine is
stopped.
WA R N I N G
!
BK0138000US.book 16 ページ ２０１１年４月１３日　水曜日　午前１１時１７分

2-26 Seat and restraint systems
2
7. While pulling on the strap (H) on the center of the seat-
back, fold the seatback down.
8. Set the cover back in place.
Head restraints
N00404300568
Head restraints can reduce the risk of a whiplash injury if your
vehicle is hit from the rear.
The head restraints are equipped in the illustrated position.
To maximize the effectiveness of the head restraints for the
front and second row seats, adjust the seatback to the upright
position, and the head restraint to the proper position. Sit back
against the seatback with your head close to the head restraint.*: Seating 7 passengers
*
*
BK0138000US.book 26 ページ ２０１１年４月１３日　水曜日　午前１１時１７分

Seat and restraint systems
2-27
2
NOTE
The head restraint height in the third row seats cannot be
adjusted.
For instructions regarding on how to use the third row
seats, refer to “Third row seat (Seating 7 passengers)” on
page 2-16.
Adjustment of the head restraint height (The
front and second row seats)To reduce the risk of injury in an accident, adjust the head
restraint height so that the center of the restraint is at your eye
level when seated. Any person too tall for the restraint to reach
their eye level when seated should raise the restraint to the
highest locked position.

To raise the restraint, pull it straight up.

To lower the restraint, push down on it while pressing the
lock knob (A) in the direction shown by the arrow.

After adjusting the height, push down on the restraint to
make sure it is locked in position.
WA R N I N G
!
Driving without the head restraints in place can
cause you and your passengers serious injury or
death in an accident. To reduce the risk of injury in
an accident, always make sure the head restraints
are installed and properly positioned when the seat
is occupied.
In order to minimize the risk of a neck injury due to
a rear impact, the seatback must be adjusted to the
upright position and the head restraint must be
adjusted to the proper position before vehicle opera-
tion. The driver should never adjust the seat while
the vehicle is in motion.
Never place a cushion or similar device on the seat-
back. This can adversely affect head restraint per-
formance by increasing the distance between your
head and the restraint.
BK0138000US.book 27 ページ ２０１１年４月１３日　水曜日　午前１１時１７分

2-28 Seat and restraint systems
2
To remove (The front and second row seats)Press the lock knob (A) in the direction shown by the arrows.
Then pull the head restraint up and out of the seatback.To install (The front and second row seats)First check that the head restraint is facing in the right direction
as shown in the previous illustration, and then insert it into the
seatback. Push the head restraint down while pressing the lock
knob (A) until the restraint locks into place.
WA R N I N G
!
To help minimize the risk of neck injury in the event
of an accident, the head restraints must be properly
installed and positioned to proper height before
vehicle operation.
CAUTION
!
Check that the lock knob (A) is extended out as
shown in the illustration. Then pull the head
restraint up to make sure that it is locked in place
and will not come out of the seatback.
BK0138000US.book 28 ページ ２０１１年４月１３日　水曜日　午前１１時１７分

Seat and restraint systems
2-29
2 Making a cargo area
N00405500091
CAUTION
!
The shape and size of the head restraint differs
according to the seat. Always use the correct head
restraint provided for the seat and do not install the
head restraint in the wrong direction.
WA R N I N G
!
Never adjust the seats to make a cargo area when
the vehicle is in motion or on a slope. The seats could
move more than necessary or move suddenly and
cause a serious accident.
After folding up a seat or returning a seat back to its
normal position, make sure that the seat is firmly
secured. If the seat is not secured, it could move and
cause a serious accident.
Do not allow anyone to ride in the cargo area while
the vehicle is in motion. People who are not properly
seated and restrained can be seriously injured or
killed in an accident.
The front passenger seat is equipped with weight
sensors. Depending on the weight detected, the front
passenger airbag is disabled or enabled. When fold-
ing the second row seats forward for increased cargo
capacity, the front passenger seat and seat back
must be adjusted to assure they are not contacting
the second row seat. In the event the front seat or
seatback is allowed to contact the folded second row
seat, proper operation of the front passenger airbag
system may be affected.
BK0138000US.book 29 ページ ２０１１年４月１３日　水曜日　午前１１時１７分

2-30 Seat and restraint systems
2
NOTE
When the seatback of a front seat is reclined, return it to
the upright position before driving.
Folding the second row seats
N00405700110
The second row seat can be folded to create an additional cargo
area or to permit access to the third row seat on vehicles with a
third row seat.NOTE
You can separately fold the right and left side of the sec-
ond row seat.

When folding down the seatback, the seat belt buckles can
be stowed in the slits on the seat to avoid leaving marks on
the seat.
“Storing the second row and third row seat belts” on page
2-46.To f o l d u p t h e s e a t1. Lower the head restraints to the lowest position.
Refer to “Head restraints” on page 2-26.
CAUTION
!
In the cargo area, do not load the luggage higher
than the top of the seats and make sure that the lug-
gage is firmly secured. Restricted rear vision or fly-
ing objects entering the passenger compartment
during sudden braking could result in a serious acci-
dent.
Seats should always be folded up and put back into
the normal position by an adult. Seat adjustments
by a child could lead to an unexpected accident.
When adjusting the seats, be careful not to catch
your hand or leg. Personal injury could result.
BK0138000US.book 30 ページ ２０１１年４月１３日　水曜日　午前１１時１７分

Seat and restraint systems
2-31
2
2. Operate the lever (A) or lock release strap (B) on the sec-
ond row seats to fold down the seatbacks.3. For vehicles with 2nd row seat slide function, the seatback
will fall forward and the entire seat will flip up as it slides
forward.Operating the leverOperating the lock release strap
BK0138000US.book 31 ページ ２０１１年４月１３日　水曜日　午前１１時１７分