diagram NISSAN 300ZX 1984 Z31 Steering System Workshop Manual

POWER STEERlNG OIL PUMP
Inspection
Wash clean all disassembled parts (inside pump) in
suitable cleaning solvent.
PULLEY AND PULLEY SHAFT
0
0
If pulley is cracked or deformed, replace it.
If an oil leak IS observed around pulley shaft oil
seal, replace it.
If serration of pulley or pulley shaft IS de-
formed
or worn, replace it.
0
OIL PRESSURE SWITCH
(Non-turbocharged model)
Operation High-pressure side hydraulic
line pressure kPa (kglcm', psi) ~~
I Turn ON Increasing to 1,961 - 2,942
(20- 30,284 ~ 4271
Turn OFF Decreasing to Approx
981 .2,942 (10 - 30,142 - 427)
Refer to "Hydraulic
System Check" in "POWER
STEERING SYSTEM
- Checking"
Assembly
Assemble 011 pump in the reverse order of dts-
assembly, noting the following instructions
Before installing O-rings and oil seal, apply a
thin coat of power steering fluid to them.
Make certain that O-rings and oil
seal are
installed properly.
Discard old O-ring and oil
seal and install new
ones Be careful of
oil seal direction.
Wiring Diagram -Oil Pressure Switch
FUSE BLOCK
IGNITION SWITCH
I a
Y
Ln v)
E
ENGINE ROOM E I R HARNESS HARNESS
IWhnsl d'
POWER STEERING OIL PRESSURE
SST222A
ST-1 6