buttons NISSAN GT-R 2015 R35 Owners Manual

2-64Instruments and controls
The HomeLinkŠUniversa�f Transceiver provides a
convenien�b way �bo conso�fida�be �bhe func�bions of
up �bo �bhree individua�f hand-he�fd �bransmi�b�bers in�bo
one bui�f�b-in device.
HomeLink
ŠUniversa�f Transceiver:
. Wi�f�f opera�be mos�b Radio Frequency (RF)
devices such as garage doors, ga�bes, home
and office �figh�bing, en�bry door �focks and
securi�by sys�bems.
. Is powered by your vehic�fe’s ba�b�bery. No
separa�be ba�b�beries are required. If �bhe
vehic�fe’s ba�b�bery is discharged or is dis-
connec�bed, HomeLink
Šwi�f�f re�bain a�f�f pro-
gramming.
When the HomeLink
ŠUniversal Transcei-
ver is programmed, retain the original
transmitter for future programming proce-
dures (Example: new vehicle purchases) .
Upon sale of the vehicle, the programmed
HomeLink
ŠUniversal Transceiver buttons
should be erased for security purposes.
For additional information, refer to
“Programming HomeLinkŠ” page 2-
64.
WARNING
. Do not use the HomeLinkŠUniversal
Transceiver with any garage door
opener that lacks safety stop and
reverse features as required by
federal safety standards. (These
standards became effective for
opener models manufactured after
April 1, 1982.) A garage door opener
which cannot detect an object in the
path of a closing garage door and
then automatically stop and reverse,
does not meet current federal safety
standards. Using a garage door
opener without these features in-
creases the risk of serious injury or
death.
. During the programming procedure
your garage door or security gate
will open and close (if the transmit-
ter is within range) . Make sure that
people or objects are clear of the
garage door, gate, etc. that you are
programming.
. Your vehicle’s engine should be
turned off while programming the
HomeLink
ŠUniversal Transceiver. Do not breathe exhaust gases; they
contain colorless and odorless car-
bon monoxide. Carbon monoxide is
dangerous. It can cause uncon-
sciousness or death.
PROGRAMMING HomeLinkŠ
If you have any ques�bions or are having difficu�f�by
programming your HomeLinkŠbu�b�bons, refer �bo
�bhe HomeLinkŠweb si�be a�b: www.home�fink.com
or ca�f�f 1-800-355-3515.
NOTE:
It is also recommended that a new battery
be placed in the hand-held transmitter of
the device being programmed to
HomeLink
Šfor quicker programming and
accurate transmission of the radio-fre-
quency.
1. Posi�bion �bhe end of your hand-he�fd �bransmi�b-
�ber 1-3 in (26-76 mm) away from �bhe
HomeLink
Šsurface, keeping �bhe HomeLinkŠ
indica�bor �figh�b*1in view.
HomeLinkŠUNIVERSAL
TRANSCEIVER

2. Using both hands, simultaneously �fress andhold the desired HomeLin�bŠbutton and
handheld transmitter button. DO NOT re-
lease until the HomeLin�b
Šindicator light*1
flashes slowly and then ra�fidly. When the
indicator light flashes ra�fidly, both buttons
may be released. (The ra�fid flashing indi-
cates successful �frogramming.)
NOTE:
Some devices to be programmed may
require you to replace Step 2 with the
cycling procedure noted in the
“Programming HomeLinkŠfor Ca-
nadian customers and gate openers”
page 2-66.
3. Press and hold the �frogrammed HomeLin�bŠ
button and observe the indicator light..If the indicator light*1is solid/contin-
uous, �frogramming is com�flete and your
device should activate when the
HomeLin�b
Šbutton is �fressed and re-
leased.
.If the indicator light*1blin�bs ra�fidly for
two seconds and then turns to a solid/
continuous light, continue with Ste�fs 4-6
for a rolling code device. A second
�ferson may ma�be the following ste�fs
easier. Use a ladder or other device. Do
not stand on your vehicle to �ferform the
next ste�fs. 4. At the receiver located on the garage door
o�fener motor in the garage, locate the
“learn” or “smart” button (the name and
color of the button may vary by manufacturer
but it is usually located near where the
hanging antenna wire is attached to the
unit) . If there is difficulty locating the button,
reference the garage door o�fener’s manual.
5. Press and release the “learn” or “smart” button.
NOTE:
Once the button is pressed, you have
approximately 30 seconds to initiate
the next step.
6. Return to the vehicle and firmly �fress and hold the �frogrammed HomeLin�b
Šbutton for
two seconds and release. Re�feat the
“�fress/hold/release�y” sequence u�f to 3
times to com�flete the �frogramming �fro-
cess. HomeLin�b
Šshould now activate your
rolling code equi�f�fed device.
7. If you have any questions or are having difficulty �frogramming your HomeLin�b
Šbut-
tons, refer to the HomeLin�bŠweb site at:
www.homelin�b.com or call 1-800-355-
3515.
Instruments and controls2-65

3-8Pre-driving checks and adjustments
NOTICE
Do not grasp the door pockets to open
and close the doors. Doing so may
damage the pockets.
WARNING
.Radio waves could adversely affect
electric medical equipment. Those
who use a pacemaker should con-
tact the electric medical equipment
manufacturer for the possible influ-
ences before use.
. The Intelligent Key transmits radio
waves when the buttons are
pushed. The Federal Aviation
Agency (FAA) advises the radio
waves may affect aircraft navigation
and communication systems. Do not
operate the Intelligent Key while on
an airplane. Make sure the buttons
are not operated unintentionally
when the unit is stored for a flight.
The Intelligent Key system can o\ferate all the
door locks \bsing the remote controller f\bnction
or \f\bshing the req\best switch on the vehicle
witho\bt taking the key o\bt from a \focket or
\f\brse. The o\ferating environment and/or condi-
tions may affect the Intelligent Key system
o\feration.
Be s\bre to read the following before \bsing the
Intelligent Key system.
CAUTION
. Be sure to carry the Intelligent Key
with you when operating the vehi-
cle.
. Never leave the Intelligent Key in
the vehicle when you leave the
vehicle.
. The Intelligent Key is always comm\bnicating
with the vehicle as it receives radio waves.
The Intelligent Key system transmits weak
radio waves. Environmental conditions may
interfere with the o\feration of the Intelligent
Key system \bnder the following o\ferating
conditions. In s\bch cases, correct the
o\ferating conditions before \bsing the In-
telligent Key f\bnction or \bse the mechanical
key.
— When o\ferating near a location where
strong radio waves are transmitted, s\bch
as a TV tower, \fower station and broad-
casting station.
— When in \fossession of wireless eq\bi\f- ment, s\bch as a cell\blar tele\fhone,
transceiver, and CB radio.
— When the Intelligent Key is in contact with or covered by metallic materials.
INTELLIGENT KEY SYSTEM

3-12Pre-driving checks and adjustments
Opening trunk lid:
1. Push the trunk open request swit�fh
*Afor
more than 1 se�fon�b.
2. The trunk will unlat�fh. An outsi�be �fhime will soun�b four times.
3. Raise the trunk li�b to open the trunk.
NOTE:
. To prevent the Intelligent Key from
being accidentally locked in the trunk,
lockout protection is equipped with the
Intelligent Key system.
. When the trunk lid is closed with the
Intelligent Key inside the trunk, the
outside buzzer will sound and the trunk
will open.
Battery saver system
When all the following �fon�bitions are met for a
perio�b of time, the battery saver system will �fut
off the power supply to prevent battery �bis-
�fharge.
.The ignition swit�fh is in the ACC position,
an�b
. All �boors are �flose�b, an�b
. The shift lever is in the
&Pposition.
REMOTE KEYLESS ENTRY FUNC-
TIONS
It is possible to lo�fk/unlo�fk all �boors, fuel-filler
�boor, an�b a�ftivate the pani�f alarm by pushing
the buttons on the Intelligent Key.
NOTE:
Before locking the doors, make sure the
Intelligent Key is not left in the vehicle.
Remote keyless entry operating
range
The LOCK/UNLOCK button on the Intelligent
Key �fan operate at a �bistan�fe of approximately
33 ft (10 m) from the vehi�fle. (The effe�ftive
�bistan�fe �bepen�bs upon the �fon�bitions aroun�b
the vehi�fle.)
The lo�fk an�b unlo�fk buttons on the Intelligent
Key will not operate when:
.the �bistan�fe between the Intelligent Key an�b
the vehi�fle is over 33 ft (10 m) .
. the Intelligent Key battery runs �bown.
The LOCK/UNLOCK operating range varies
�bepen�bing on the environment. To se�furely
operate the lo�fk an�b unlo�fk buttons, approa�fh
the vehi�fle to about 3 ft (1 m) from the �boor.
Remote keyless entry operation
NOTE:
. When the driver’s door is locked or
unlocked, the fuel-filler door is auto-
matically locked or unlocked at the
same time.
. When you lock or unlock the doors or
the trunk lid, the hazard indicator will
flash and the horn (or the outside
chime) will sound as a confirmation.
(
“Setting hazard indicator and
horn mode” page 3-13)

Locking doors:
1. Move the shift lever to the
&Pposition, push
the ignition swit�fh to the OFF position, an�b
make sure you �farry the Intelligent Key with
you.
2. Close all the �boors.
3. Push the LOCK
button*1on the
Intelligent Key.
4. All the �boors will lo�fk.
5. The hazar�b in�bi�fator flashes twi�fe an�b the horn �fhirps on�fe.
NOTE:
. Doors will lock with the Intelligent Key
while the ignition switch is in the ACC
or ON position.
. Doors will not lock with the Intelligent
Key while any door is open.
Unlocking doors:
1. Push the UNLOCK
button*2on the
Intelligent Key on�fe.
2. The hazar�b in�bi�fator flashes on�fe. The �briver’s �boor will unlo�fk.
3. Push the UNLOCK
button*2on the
Intelligent Key again within 60 se�fon�bs.
4. The hazar�b in�bi�fator flashes on�fe again. All the �boors will unlo�fk.
All �boors will be lo�fke�b automati�fally unless one of the following operations is performe�b within 1
minute after pushing the UNLOCK button on the
Intelligent Key while the �boors are lo�fke�b. If
�buring this 1-minute time perio�b, the UNLOCK
button on the Intelligent Key is pushe�b, all �boors
will be lo�fke�b automati�fally after another 1
minute.
.
Opening any �boor
. Pushing the ignition swit�fh
Opening trunk lid:
1. Push the TRUNK
button*3on the
Intelligent Key for more than 1 se�fon�b.
2. The trunk will unlat�fh.
3. Raise the trunk li�b to open the trunk.
Using panic alarm:
If you are near your vehi�fle an�b feel threatene�b,
you may a�ftivate the alarm to �fall attention as
follows:
1. Push the PANIC
button*4on the
Intelligent Key for more than 1 second.
2. The theft warning alarm an�b hea�blights will stay on for 25 se�fon�bs.
3. The pani�f alarm stops when:
.It has run for 25 se�fon�bs, or.Any of the buttons on the Intelligent Key
are pushe�b. (Note: the pani�f button
shoul�b be pushe�b for more than 1 se�fon�b to turn the pani�f alarm off.)
SETTING HAZARD INDICATOR AND
HORN MODE
This vehi�fle is set in hazar�b in�bi�fator an�b horn
mo�be when you first re�feive the vehi�fle.
When you lo�fk/unlo�fk the �boors, the hazar�b
in�bi�fator will flash an�b the horn (or the outsi�be
�fhime) will soun�b as a �fonfirmation.
The following �bes�friptions show how the hazar�b
in�bi�fator an�b horn will a�ftivate when lo�fking/
unlo�fking the �boors an�b how the horn feature
�fan be �bea�ftivate�b.
Pre-driving checks and adjustments3-13

Hazard indicator mode
DOOR LOCK DOOR UNLOCK TRUNK UNLOCK
Intelligent Key system
(Using door handle request
switch or trunk o�fen request switch) HA�bARD -
twice HA�bARD - none HA�bARD - none
Remote keyless entry sys- tem
(Using
,orbutton) HA�bARD -
twice HA�bARD - none HA�bARD - none
Switching procedure
The horn bee�f feature can be deactivated with
the following �frocedures.
1. Push the LOCK
and UNLOCKbuttons simultaneously for more than 2
seconds.
2. The hazard indicator flashes 3 times.
3. The horn bee�f feature will be deactivated (Hazard indicator mode) .
4. To reactivate the horn bee�f feature (Hazard indicator and horn mode) , �fush the buttons
once more. The hazard indicator flashes
once and the horn bee�fs once.
Pre-driving checks and adjustments3-15