key OLDSMOBILE AURORA 1996 Owners Manual
[x] Cancel search | Manufacturer: OLDSMOBILE, Model Year: 1996, Model line: AURORA, Model: OLDSMOBILE AURORA 1996Pages: 388, PDF Size: 20.24 MB
Page 31 of 388

0
0 Your vehicle is equipped with a crash sensing and
diagnostic module, which records information about
the air bag system. The module records information
about the readiness of the system, when the sensors
are activated and driver’s safety belt usage at
deployment.
Let only qualified technicians work on your air bag
system. Improper service can mean that your air bag
system won’t work properly. See your retailer for Servicing Your Air Bag-Equipped Aurora
Air bags affect how your Aurora should be serviced.
There are parts of the air bag system in several places
around your vehicle. You don’t want the system to
inflate while someone is working on your vehicle. Your
Aurora retailer and the Aurora Service Manual have
information about servicing your vehicle and the air bag
system.
To purchase a service manual, see “Service and
Owner Publications’’ in the Index.
service.
NOTICE:
~
If you damage the cover for the driver’s or the
right front passenger’s air bag, they may not
work properly.
You may have to replace the air
bag module in the steering wheel or both the air
bag module and the instrument panel for the
right front passenger’s air bag.
Do not open or
break the air bag covers. For up to
10 minutes after the
ignition key is
turned off and the battery is disconnected, an air
bag can still inflate during improper service.
You
can be injured if you are close to an air bag when
it inflates. Avoid wires wrapped with yellow tape
or yellow connectors. They are probably part of
the air bag system. Be sure to follow proper
service procedures, and make sure the person
performing work for
you is qualified to do so.
The air bag system does not need regular maintenance.
ProCarManuals.com
Page 32 of 388

Safety Belt Use During Pregnancy
Safety belts work for everyone, including pregnant
women. Like all occupants, they are more likely to be
seriously injured if they don’t wear safety belts.
A pregnant woman should wear a lap-shoulder belt, and
the lap portion should be worn as low as possible, below
the rounding, throughout the pregnancy. The
best way
to protect the fetus is to protect the
mother. When a safety belt is worn properly, it’s more
likely that the fetus won’t be hurt in
a crash. For
pregnant women, as for anyone, the key to making
safety belts effective is wearing them properly.
Right Front Passenger Position
The right front passenger’s safety belt works the same
way as the driver’s safety belt. See “Driver Position,”
earlier in this section.
When the lap portion of the belt is pulled out all the
way, it will lock.
If it does, let it go back all the way and
start again.
Rear Seat Passengers
It’s very important for rear seat passengers to buckle up!
Accident statistics show that unbelted people in the rear
seat are hurt more often in crashes than those who are
wearing safety belts.
Rear passengers who aren’t safety belted can be thrown
out of the vehicle
in a crash. And they can strike others
in the vehicle who
are wearing safety belts.
ProCarManuals.com
Page 57 of 388

@ Section 2 Features and Controls
m m
Here
you can learn about the many standard and optional
features
on your Aurora, and information on starting,
shifting and braking.
Also explained are the instrument
panel and the warning systems that tell you
if everyhng is
working properly
-- and what to do if you have a problem.
Keys
Leaving young children in a vehicle with the
ignition key is dangerous for many reasons.
A child
or others could be badly injured or even killed.
They could operate power windows or other
controls or even make the vehicle move. Don’t
leave the keys in a vehicle with young children.
I
2-1
ProCarManuals.com
Page 58 of 388

The ignition keys are for the
ignition only.
The door keys are for the
doors and all other locks. When
a new Aurora is delivered, the retailer removes
the plugs from the keys and gives them to the first
owner. However, the ignition key may not have a plug.
If the ignition key doesn’t have a plug, there will be a
bar-coded key tag instead.
Each plug or tag has a code on it that tells your retailer
or a qualified locksmith how to make extra keys. Keep
the plugs or tags
in a safe place. If you lose your keys,
you’ll be able to have new ones made easily using these
plugs or tags. If your ignition keys don’t have plugs or
tags, go to your Aurora retailer for the correct key code
if you need
a new ignition key.
There are
15 alternative PASS-Key@II blanks, to help
discourage theft. Your retailer can he1 determine which
key code you need. (See “PASS-Key
8 11” in the Index.)
NOTICE:
Your Aurora has a number of features that can help
prevent theft. But you can have a lot of trouble
getting into your vehicle if you ever
lock your keys
inside.
You may even have to damage your vehicle
to get in.
So be sure you have extra keys.
2-2
ProCarManuals.com
Page 59 of 388

Door Locks
1
Unlocked doors can be dangerous. Passengers
-- especially children -- can easily
open the doors and
fall out. When a door is
locked, the inside handle won’t open it.
Outsiders can easily enter through an unlocked
door when you slow down
or stop your vehicle.
This may not be
so obvious: You increase the
chance
of being thrown out of the vehicle in a
crash if the doors aren’t locked. Wear safety belts
properly, lock your doors, and you will be
far
better off whenever you drive your vehicle.
There are several ways to lock and unlock your vehicle.
From the outside, use your door key or Remote Lock
Control. From the inside, to lock the door, rotate
the locking
lever forward.
To unlock the door, rotate the locking lever rearward.
There is a red mark on the switch when the door is
unlocked.
Central Door Unlocking System
If the driver’s door key is held in the unlock position for
more than one second, all doors will electronically
unlock.
2-3
.
ProCarManuals.com
Page 61 of 388

Customizing Your Automatic Door Locks Feature
You can program the automatic door locks feature to
change to the following modes:
Mode Operation
0
1
2
3
No automatic door lock or unlock.
All doors automatically lock when shifted out
of PARK (P).
No automatic door unlock.
All doors automatically lock when shifted out
of PARK (P). Only the driver’s door
automatically unlocks when shifted into
PARK (P).
All doors automatically lock when shifted out
of PARK (P). All doors automatically unlock
when shifted into PARK (P). Vehicles
are delivered programmed in Mode
3.
To change modes:
1.
2.
3.
4.
5.
Close all doors and turn the ignition on. Keep all
doors closed throughout this procedure.
Press and hold the driver’s power door lock switch
through Step
4.
Press the LOCK button on the Remote Keyless Entry
transmitter. The automatic door locks will remain in
the current mode.
Press the LOCK button on the transmitter again. Each time the transmitter’s LOCK button is
pressed, the mode will advance by one, going from
3 to 0 to 1, etc.
Release the power door lock switch. The automatic
door locks will remain in the most recent mode
selected.
2-5
ProCarManuals.com
Page 63 of 388

To Cancel the Rear Door Lock
1. Unlock the door from the inside and open the door
from the outside.
2.
3.
Move the lever all the
way down.
Do the same for the
other rear door.
Anti-Lockout Feature
The power door locks will not work if the key is left in the
ignition with the driver’s door open.
You can override this
feature by holding the power door lock switch for more
than three seconds, unless the engine is running.
Leaving Your Vehicle
If you are leaving the vehicle, open your door and set the
locks Erom the inside, then get
out and close the door.
The rear door locks will now work normally.
2-7
ProCarManuals.com
Page 64 of 388

Remote Lock Control
You can lock and unlock
your doors or unlock your
trunk from up to
30 feet
(9 m) away using the key
chain transmitter supplied
with your vehicle.
Your Remote Lock Control operates on a radio
frequency subject to Federal Communications
Commission (FCC) Rules.
This device complies with Part
15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and
(2) This device must accept any interference
received, including interference that may cause
undesired operation. Should interference to this system
occur, try this:
0 Check to determine if battery replacement is necessary.
See
the instructions on battery replacement.
0 Check the distance. You may be too far from your
0 Check the location. Other vehicles or objects may
vehicle. This product has
a maximum range.
be blocking the signal.
See your Aurora retailer or a qualified technician
Changes or modifications to this system by other than an
authorized service facility could void authorization to
use this equipment.
for
service.
2-8
ProCarManuals.com
Page 65 of 388

Operation
The driver’s door will unlock when UNLOCK is pressed.
If pressed again within
25 seconds, all doors will unlock.
Pressing the UNLOCK button will also illuminate the interior lamps. (See “Illuminated Entry”
in the Index.)
All doors will lock when
LOCK is pressed.
The trunk will unlock when the opened trunk symbol is
pressed, but only when the ignition is off. The trunk
symbol will also work when the ignition is on, but only
while in PARK
(P) or NEUTRAL (N).
Panic Mode
When the button with the horn symbol on the key
transmitter is pressed, the horn will sound and the
headlamps and taillamps will flash for up to two
minutes. This can be turned off by pressing the panic
button again, unlocking the vehicle with a key or by
turning the ignition to
on.
If only the panic button works, the transmitter needs to
be resynchronized to the receiver. Do this by pressing
and holding both the
LOCK and UNLOCK buttons for
about eight seconds; you must be within range of the
vehicle. Once the transmitter has been resynchronized,
the horn will chirp and the exterior lamps will flash
once. The system should now operate properly.
Personalization Features
Each key transmitter can be programmed to the driver’s
preference for programmable automatic door locks, key
transmitter response and perimeter lighting. See each
feature in the Index.
The transmitters can also be programmed to move the
driver’s seat and outside mirrors to a set memory position
when the key transmitter’s
UNLOCK button is pressed.
To program the system:
1.
2.
3.
4.
Adjust the driver’s seat to a comfortable position.
Adjust both outside mirrors to suit you. See “Outside
Mirrors” in the Index.
Press the SET button on the driver’s door armrest.
You will hear one beep.
Within five seconds, press one of the two memory
buttons on the armrest. You will hear two beeps
to
confirm that the mirror and the seat positions are
entered into memory.
Press the UNLOCK button on the appropriate
transmitter within five seconds. You will hear
two beeps.
The second key transmitter can be programmed to
record a different seat and mirror position by following
the same steps.
2-9
. -~ ..
ProCarManuals.com
Page 66 of 388

This provides feedback to the driver when the vehicle
receives a command from the key transmitter. The
following modes may be selected:
Mode Transmitter Response
Y' .
0
1
2
3
4
5
No transmitter response when locking or
unlocking vehicle
No transmitter response when locking;
exterior lamps flash when unlocking vehicle
Exterior lamps flash when locking; no
transmitter response when unlocking vehicle
Exterior lamps flash when locking and when
unlocking vehicle
Exterior lamps flash and horn chirps when
locking; no transmitter response when
unlocking vehicle
Exterior lamps flash and horn chirps when
locking; exterior lamps flash when unlocking Vehicles
are delivered programmed in Mode
5. To
change to another mode:
1. Press and hold the power door lock switch.
2. Press the opened trunk button on the transmitter. The
3. Press the opened trunk button again. Each time the
opened trunk button is pressed, the transmitter will
advance to the next mode.
transmitter will remain
in its current mode.
4. Release the power door lock switch.
De ng (Option)
Note: This feature is available only if you request your
retailer
to activate this option. After initial activation,
you can turn this feature
on and off by using the
following procedure.
This feature lets the driver delay the actual locking of
the vehicle. When the power door lock switch is
pressed, with the key removed from the ignition and the
driver's door open, a chime will sound three times to
signal that the lock delay mode is active. When all doors
have been closed, the doors will lock automatically after
five seconds. If any door is opened before this, the
five-second timer will reset itself once all the doors have
been closed again.
ProCarManuals.com