lock OPEL CORSA 2009 Owner's Manual

36 Keys, doors, windows, sun roof
Picture no: 16968t.tif
Luggage compartment To unlock
Press button q on the remote control, the
luggage compartment and the doors will
be unlocked.
Picture no: 18158s.tif
To open
The luggage compartment is opened by
operating the button beneath the handle.
After fitting certain accessories, it might
not be possible to keep the tailgate in the
open position.
Picture no: 18246s.tif
To close
Close the tailgate using the handle on the
inside of the tailgate.
Do not press the release button under the
trim strip while closing as this will unlock it
again.
9
Warning
Do not drive with the tailgate open or
ajar, e.g. when transporting bulky
objects, since toxi c exhaust gas could
penetrate the interior.
Back to overview

37
Keys, doors, windows, sun roof
Picture no: 17042t.tif
To lock
Press button p on radio remote control.
Anti-theft alarm system
3
monitors
zDoors, tailgate, bonnet,
z The ignition.
Picture no: 17043t.tif
To activate
All doors and the bonnet must be closed.
Press the remote control button p again at
the latest 10 seconds after locking.
If the ignition was swit ched on, the driver’s
door must be opened and closed once so
that the anti-theft alarm system can be
switched on.
9
Warning
Do not use the system if there are people
in the vehicle! The doors cannot be
unlocked from the inside.
Back to overview

38 Keys, doors, windows, sun roof
Picture no: 18286s.tif
Light emitting diode (LED)
During the first 10 seconds of anti-theft
alarm system activation:
After the first 10 seconds of anti-theft
alarm system activation:
Contact a workshop for assistance if
problems are encountered.
Picture no: 16968t.tif
To deactivate
Press button q on remote control
– or –
Switch on ignition. In the case of a malfunction in the remote
control, use the key to unlock the vehicle
3
35.
If the alarm is triggered when the driver’s
door is opened, deactivate the anti-theft
alarm system by switching on the ignition.
Alarm
When triggered, the alarm gives off an
acoustic signal (horn) and a visual signal
(hazard warning flashers). The number
and duration of the alarms are stipulated
by legislation.
The alarm can be silenced by pressing a
button on the remote co ntrol or by switching
on the ignition. The anti-theft alarm system
is deactivated at the same time.
z LED comes on
=Test, delayed
switch-on,
z LED flashes
rapidly = Door, tailgate or
bonnet open, or
system fault.
z LED flashes
slowly =System switched on.
Back to overview

39
Keys, doors, windows, sun roof
Picture no: 18287s.tif
Child safety locks
3
Turn rotary knob at rear door lock from
vertical position using key: door cannot be
opened from the inside.
Personalised key
Store personalised settings or
vehicle-specific functions in the
vehicle key If the vehicle is used by a number of drivers,
each driver can store his or her own
preferred settings and vehicle functions
using their key. These settings and
functions are then activated when the
relevant key is used.
A total of up to five vehicle keys can be
programmed separately and used. Automatically saved settings
The last settings selected
z
the climate control system 3,
z the information display 3,
z the infotainment system 3,
z the instrument illumination,
are automatically stored depending on the
vehicle key used.
Different settings are stored for each
vehicle key. Use of a specific vehicle key will
activate the settings associated with it.
The settings are stored once more every
time the vehicle is locked.
9
Warning
Use the child safety lock whenever chil-
dren are occupying the rear seats.
Back to overview

40 Keys, doors, windows, sun roofProgrammable functions
The vehicle-specific functions P1 to P7
listed in the following table can be
activated and deactivated.
The setting selected is automatically stored
depending on the vehicle key used.
Different settings are stored for each
vehicle key. Use of a specific vehicle key will
activate the settings associated with it.
A total of up to five vehicle keys can be
programmed separately.
Programming permits the technical
prerequisite of the relevant function. To
activate and deactivate the functions and
set the functions, please see the relevant
sections. For page re ferences, see the
following table.
Programming:

z Turn the ignition off, the key must be in
the ignition lock,
Picture no: 18401s.tif
zPull turn signal st alk and wiper stalk
simultaneously to the steering wheel
until you hear a confirmation signal
(approx. 3 seconds),
z The kilometre display shows P1,
Picture no: 18411s.tif
zPush the turn signal stalk (left) up
or down and select the desired
function P1- P7 , see the following table,
Back to overview

41
Keys, doors, windows, sun roof
Picture no: 18412s.tif
z Push the wiper stalk (right) up or down
and select status On or OFF , or input a
value for speed (P6) or value for volume
(P7),
z Pull turn signal stalk (left) and wiper stalk
(right) simultaneously to the steering
wheel until you hear a confirmation
signal (approx. 3 seconds).
The selected settings are now stored for the
key in the ignition lock. To activate and
deactivate the functions and set the
functions selected, please see the relevant
sections. For page references, see the
following table.
Repeat the procedure to program
additional keys.
Overview of programmable functions
Function
designation Function
Status ex works Description
P 1 Switch on the extern al lighting using the
remote control (lead-me-to-the-car
lighting function) OFF
3113
P 2 Automatic rear windscreen wiper when
reverse gear is selected OFF
313
P 3 Lane change indication: three flashes
when the lever is moved slightly On
311
P 4 Automatic locking OFF334
P 5 3
Selective unlocking OFF333
P 6 Speed warning OFF392
P 7 Volume of the acoustic turn signal 3 3110
Back to overview

49
Seats, Interior
Picture no: 18161s.tif
Adjust height of seat 3
Operate lever on the door side of seat.
Pump action of lever
Picture no: 18480s.tif
Tilting the backrests forward 3
To tilt the backrests forward, lift release
lever and tilt backrest forward. Lower
release lever and backrest engages in
lowered position 3. Slide seat forwards 3.
To push the seat back to upright, it
engages in its original position 3 . Lift the
locking lever 3, move the backrest back to
upright, lower the locking lever, backrest
engages.
Folding the backrest forwards is possible
only when the backrest is in an upright
position.
Do not operate handwheel to adjust
backrest with backrest tilted forward.
Picture no: 18465s.tif
Tilting backrests forward, Corsa OPC
Remove seat belt from belt mount on
backrest.
To tilt the backrest forward, pull
release lever on rear of backrest and
tilt backrest forward. Release the release
lever andbackrest engages in the lowered
position 3. Slide seat forward 3.
To move the backrest upright, slide seat
back and it will engage in its original
position 3. Pull release lever 3, move
backrest upright, release the release lever,
backrest engages.
Folding the backrest forwards is possible
only when the backrest is in an upright
position.
Do not operate handwheel to adjust
backrest with backre st tilted forward.
Upwards = Seat higher
Downwards = Seat lower
Back to overview

53
Seats, Interior
Picture no: 18278s.tif
Luggage compartment
extension
3
Adjust angle of rear backrests
The rear backrest, in a single unit or split 3,
can also be locked in an upright position
for transporting bulky items.
Pull the unlocking hand le, pull the backrest
forwards to the vertical position and allow
to engage. When unlocking, a red marking appears
next to the unlocking lever. The backrest is
only engaged correctly when the red bolt is
no longer protruding.
If the backrest is split
3, unlock the relevant
side, and unlock at both sides if it is a single
unit.
Picture no: 18288s.tif
Folding the backrest
Remove luggage compartment cover and
push rear headrests down as far as they
will go 352.
Move the seat belts to protect them against
damage by means of side supports on the
release lever. When folding the backrests,
pull the seat belts along with them.
Back to overview

54 Seats, Interior
Picture no: 18282s.tif
Disengage the backrest (single or split 3)
using the release lever and fold it down
onto the seat cushion.
If the backrest is split 3, unlock the relevant
side, and unlock at both sides if it is a single
unit.
I f t h e v e h i c l e i s t o b e l o a d e d v i a a r e a r d o o r ,
take the seat belt out of the seat backrest
guide, roll it up and insert the latch plate
into the side shade retainer.
Picture no: 18373s.tif
Restoring backrest to an upright position
Move rear seat backrests upright and allow
locking mechanisms to audibly engage at
both sides. Once the backrests are locked
the red mark must no longer protrude.
The rear seat backrests can be locked in
two positions.
Do not trap the seat belt when moving the
backrest to the upright position.
Install the luggage compartment cover.
Stowage compartment beneath double
load-bay floor 3382.
Luggage compartment cover Do not place any heavy or sharp-edged
objects on the cover.
To remove, unhook the retaining straps
from the tailgate.
Back to overview

58 Seats, InteriorThree-stage safety system Comprising:
zThree-point seat belts.
z Belt tensioners at the front seats.
z Airbag systems for driver seat, front
passenger seat 3 and outboard rear
seats 3.
The three stages are activated in sequence
depending on the severity of the accident:
z The automatic seat belt locking devices
prevent the belt strap from being pulled
out and thus ensure that the vehicle
occupants are retained in their seats.
z The front seat belts are pulled down at
the belt locks and at the lower, outer
attachment points 3. This tensions the
seat belt so the occupants are slowed
down with the vehicle early as the vehicle
stops, thus reducing stresses on the
body.
z The airbag systems are also triggered in
the event of severe accidents and form a
safety cushion for the occupants. Read the instructions supplied with the
child restraint system.
Picture no: 18533t.tif
Three-point seat belts The seat belts have an automatic retractor,
so that the belt is spring tensioned and
always lies against the body.
Information on correct seat position
350.
The safety belts lock when the vehicle
accelerates or decelerates rapidly. This
prevents the belt from extending and
keeps the occupant in his or her seat.
9
Warning
The airbag systems serve to supplement
the three-point seat belts and belt ten-
sioners. The seat belts must therefore
always be worn. Disregard of these
instructions may lead to injuries or
endanger life. Vehicle passengers
should be informed accordingly.
Back to overview