turn signal Peugeot 307 Break 2002.5 Owner's Manual

Take care not to trap the seat
belts.
AIR BAGS
The air bags have been designed
to maximise the safety of the
occupants in the event of serious
collisions. They work in conjunc
tion with the force limiting seat
belts.
Front air bags
These are folded in the centre of
the steering wheel for the driver
and in the fascia for the front pas
senger. They are deployed simul
taneously, except in cases where
the passenger air bag is dis
armed.
Precautions regarding
the passenger air bag ➜disarm the air bag if you
install a rearfacing child
seat,,
➜ arm the air bag for an adult
passenger. Operating check
With the ignition switched
on (2nd notch of the igni
tion), illumination of this
warning light, accompa
nied by an audible signal and the
message ' 'Passenger air bag
disarmed'' on the multi_function
display, indicates that the pas
senger air bag is disarmed (swit
ch in the "OFF"position).
The warning light remains on
throughout the disarming pro
cess.
Side air bags*
and curtain air bags*
The side air bags are incorporat
ed into the seat backs of the front
seats, on the door side.
The curtain air bags are incorpo
rated into the door pillars and the
top of the passenger compart
ment.
They are deployed unilaterally, on
whichever side the col
lision occurs.
* According to country.
132133
Disarming the passenger
air bag* ➜ with the ignition off, insert the
key into slot 1and turn the
passenger air bag switch to
the "OFF" position.
As soon as you remove the child
seat, turn the air bag switch to the
''ON'' position, to activate the air
bag again.
8
YOUR 307 AT A GLANCE
09-09-2002

REAR PARKING AID
(ESTATE)
This system, installed in the rear
bumper, detects any obstacle
(person, vehicle, tree, barrier,
kerb...) situated behind the vehi
cle.
Activation
With the engine running, the sys
tem is activated when reverse
gear is engaged. A bleep indi
cates that it is active.
The proximity information is given
by an audible signal, consisting of
bleeps which become faster as
the vehicle approaches the
obstacle.
When the distance between the
rear of the vehicle and the obsta
cle is less than approxi
mately twentyfive cen
timetres, the audible sig
nal becomes continuous.
When you switch to neu
tral, the system becomes
inactive again.
Storing a speed
When you reach the required
speed, press button
2or 3. The
speed is stored and will be main
tained automatically.
Note: it is possible to accelerate
temporarily without deactivating
the cruise control.
Deactivating the stored speed
If you wish to deactivate the
stored speed:  press button 4or the brake or
clutch pedal.
Recalling the stored speed
Following deactivation, press but
ton 4. Your vehicle will return to
the last speed stored.
Cancelling the stored speed  Place knob 1in the OFFposi
tion or switch off the ignition.
Do not use the
cruise control on
slippery roads or
in heavy traffic.
09-09-2002
131130
10YOUR 307 AT A GLANCE
CRUISE CONTROL
The cruise control makes it possi
ble to maintain, at a constant rate,
the vehicle speed programmed by
the driver, irrespective of the pro
file of the road and without any
action on accelerator or brake
pedal.
To be stored, the vehicle speed
must be in excess of approxi
mately 25 mph.
Activation Place knob 1in the ON
position.
You may store a speed.  Place knob 1in the OFFposi
tion to deactivate the system.

Low coolant level warning light
Linked to the central STOPwarning light.
This comes on for approximately 3 seconds each time the ignition is switched on.
This warning light is accompanied by an audible signal and the message "Top up
coolant " on the multifunction display.
Stop immediately. Central STOP warning light
This light comes on each time the ignition is switched on.
It is linked to the "engine oil pressure", ''oil temperature''
, ''coolant
level low'', ''brake fluid level'', "electronic brake force dist ribution
fault' and ''coolant temperature gauge'' warning lights.
The STOP warning light flashes if one of the doors or the boot is o pen. A diagram appears
on the multifunction display for a few seconds, accompanied by an audible signal.
In this case, it is not essential to stop if this is a delib erate action on the part of
the driver (e.g. transportation of long objects).
Stop immediately if it comes on permanently with the engine running.
Contact a PEUGEOT dealer.
Engine oil pressure warning light
Linked to the central STOPwarning light.
If it comes on with the engine running, it is accompanied b y an audible
signal and the message ''Oil pressure low''or ''Top up engine oil'' on
the multifunction display.
Stop immediately.
If there is a lack of oil in the lubrication circuit, top up the level.
Contact a PEUGEOT dealer without delay.
INSTRUMENTS AND CONTROLS
A permanently lit warning light or one that flashes with the engine running,
indicates an operating fault in the relevant unit. Some war ning lights may
be linked to buzzers and a message on the multifunction di splay. Do not
ignore this warning: contact a PEUGEOT dealer as soon as p ossible.
If the Central STOP warning light comes on when you are d riving, stop
immediately where it is safe to do so. Warning:
Allow the engine to cool
before topping up.
The cooling system is pressurised.
To prevent the risk of scalding,
unscrew the cap by two turns to
allow the pressure to drop.
Once the pressure has dropped,
remove the cap and top up the level.
Contact a PEUGEOT dealer.
Handbrake and low brake
fluid level warning light
Linked to the central STOP
warning light.
This comes on each time the ignition is
switched on.
Illumination of this light is accompa
nied by an audible signal and a
message on the multifunction display
indicating the cause of the warning: ''Handbrake on'', if the handbrake
is applied or has not been released
correctly,
''Low brake fluid level'' if there is
an excessive drop in the brake fluid
(if the light remains on even with the
handbrake released),
''Brake system problem'' is dis
played simultaneously with the ABS
light, indicating a malfunction of the
electronic brake force distribution.
Stop immediately.
Contact a PEUGEOT dealer.
INSTRUMENTS AND CONTROLS
30
09-09-2002

09-09-2002
Passenger air bag disarming indicator light
Illumination of this warning light is accompanied by an audible signal and
the message "Passenger air bag disarmed" on the multifunction dis
play.
If the passager air bag is disarmed, the indicator light comes o n when the igni
tion is switched on and remains on.
In all cases, if the warning light flashes; contact a PEUGEOT d ealer.
Seat belt not fastened warning light
With the engine running, this indicator light comes on whe n the driver's
seat belt is not fastened.
Low fuel level warning light.
The warning light comes on for three seconds when the igniti on
is switched on.
When this light comes on with the engine running, it is a ccompa
nied by an audible signal and the message "Fuel level low"on the multifunc
tion display.
When the warning light comes on, you have enough fuel to drive at least 50 km.
The tank capacity is approximately 60 litres. This light flashes to indicate a
malfunction of the fuel gauge. Contact a PEUGEOT dealer. Air bag warning light
This light comes on for a few seconds when the ignition is sw
itched on.
Illumination of this warning light, with the engine run ning, is accompa
nied by an audible signal and the message "Air bag fault"on the multi
function display indicating:
a fault in the front air bags,
or
a fault in the side air bags or curtain air bags.
Contact a PEUGEOT dealer. Coolant temperature indicator
When the needle is in zone
A,the
temperature is correct.
When the needle is in zone B, the
temperature is too high. The central
STOP warning light flashes, accom
panied by an audible signal and the
message "Coolant temp. high" on
the multi–function display.
You must stop immediately.
Warning : wait for the engine to cool
before topping up the level.
The cooling system is pressurised.
In order to avoid any risk of scalding,
unscrew the cap two turns to allow
the pressure to drop.
When the pressure has dropped,
remove the cap and top up the level.
Contact a PEUGEOT dealer.
INSTRUMENTS AND CONTROLS
32

09-09-2002
Passenger air bag disarming indicator light
Illumination of this warning light is accompanied by an audible signal and
the message "Passenger air bag disarmed" on the multifunction dis
play.
If the passager air bag is disarmed, the indicator light comes o n when the igni
tion is switched on and remains on.
In all cases, if the warning light flashes; contact a PEUGEOT d ealer.
Seat belt not fastened warning light
With the engine running, this indicator light comes on whe n the driver's
seat belt is not fastened.
Low fuel level warning light.
The warning light comes on for three seconds when the igniti on
is switched on.
When this light comes on with the engine running, it is a ccompa
nied by an audible signal and the message "Fuel level low"on the multifunc
tion display.
When the warning light comes on, you have enough fuel to drive at least 50 km.
The tank capacity is approximately 60 litres. This light flashes to indicate a
malfunction of the fuel gauge. Contact a PEUGEOT dealer. Air bag warning light
This light comes on for a few seconds when the ignition is sw
itched on.
Illumination of this warning light, with the engine run ning, is accompa
nied by an audible signal and the message "Air bag fault"on the multi
function display indicating:
a fault in the front air bags,
or
a fault in the side air bags or curtain air bags.
Contact a PEUGEOT dealer. Coolant temperature indicator
When the needle is in zone
A,the
temperature is correct.
When the needle is in zone B, the
temperature is too high. The central
STOP warning light flashes, accom
panied by an audible signal and the
message "Coolant temp. high" on
the multi–function display.
You must stop immediately.
Warning : wait for the engine to cool
before topping up the level.
The cooling system is pressurised.
In order to avoid any risk of scalding,
unscrew the cap two turns to allow
the pressure to drop.
When the pressure has dropped,
remove the cap and top up the level.
Contact a PEUGEOT dealer.
INSTRUMENTS AND CONTROLS
32

09-09-2002
Manual station search
Press the "MAN" button.
Briefly press button Ior Jto increase or decrease the frequency displayed.
By continuing to press the button in the direction selected, you will obtain continuous scrolling of the frequency.
The scrolling stops at the first station found as soon as the button is released.
Pressing the " MAN" button again returns you to automatic station search.
Manual storing of stations in the memory
Select the station required.
Press one of the buttons " 1" to " 6" for more than two seconds.
The sound stops then becomes audible again, confirming that the station has been stored in the memory.
Automatic storing of FM stations in the memory (autostore)
Audio RB3:press and hold the "BND/AST" button for more than two seconds.
Audio RD3: press and hold button "P" for more than two seconds.
Your radio automatically stores the 6 stations with the stronge st signal in FM. These stations are stored in the FMast wave
band.
If it is not possible to find 6 stations, the remaining memo ries are empty.
Recalling stations stored in the memory
For each waveband, briefly press buttons " 1" to " 6" to recall the corresponding station.
YOUR 307 IN DETAIL 45

09-09-2002
Manual station search
Press the "MAN" button.
Briefly press button Ior Jto increase or decrease the frequency displayed.
By continuing to press the button in the direction selected, you will obtain continuous scrolling of the frequency.
The scrolling stops at the first station found as soon as the button is released.
Pressing the " MAN" button again returns you to automatic station search.
Manual storing of stations in the memory
Select the station required.
Press one of the buttons " 1" to " 6" for more than two seconds.
The sound stops then becomes audible again, confirming that the station has been stored in the memory.
Automatic storing of FM stations in the memory (autostore)
Audio RB3:press and hold the "BND/AST" button for more than two seconds.
Audio RD3: press and hold button "P" for more than two seconds.
Your radio automatically stores the 6 stations with the stronge st signal in FM. These stations are stored in the FMast wave
band.
If it is not possible to find 6 stations, the remaining memo ries are empty.
Recalling stations stored in the memory
For each waveband, briefly press buttons " 1" to " 6" to recall the corresponding station.
YOUR 307 IN DETAIL 45