engine Peugeot 406 C 2004 Owner's Manual
[x] Cancel search | Manufacturer: PEUGEOT, Model Year: 2004, Model line: 406 C, Model: Peugeot 406 C 2004Pages: 141, PDF Size: 1.8 MB
Page 3 of 141
02-02-2004
THE KEYS The keys allow you to switch on the ignition and to independentlyoperate the locks on the frontdoors, the fuel filler cap, the glovebox and the passenger air bagdisarming switch. Central lockingFrom the doors, the keys allow you to lock, deadlock and unlockthe doors and boot and close thewindows by holding the key in thelock in the locking position for afew seconds. If one of the front doors or the boot is open, it is impossible tooperate the central locking; anaudible signal indicates this whenlocking by remote control. The remote control performs the same functions at a distance, except automaticclosing of the windows.The remote control key Deadlocking Deadlocking renders the internal and external door locking controls inoperative. Press button
Ato deadlock the
vehicle.This is confirmed by fixed lighting of the direction indicators forapproximately two seconds.
A second press on button Ain
the five seconds following dead- locking, changes deadlocking tonormal locking .
This is confirmed by fixed lightingof the direction indicators forapproximately two seconds. Unlocking Press button
Bto unlock the vehi-
cle.This is confirmed by rapid flashing of the direction indicators.
ELECTRONIC ENGINE IMMOBILISER This locks the engine control sys- tem a few moments after the igni-
tion has been switched off andtherefore prevents starting of thevehicle by anyone who does not
have the key. Operation Each key has an electronic chip which has a special code. When the ignition is switched on, the key code is recognised andstarting is possible. If the key does not have a code or
has a different code from that
stored in the system memory, thevehicle will not start.
YOUR 406 COUPE AT A GLANCE
4
84
Normal key
Remote
control key
Page 4 of 141
Steering lock Before starting, unlock the steer-
ing if necessary, by gently turningthe steering wheel at the same
time as you turn the key. It is advisable to press the clutch
pedal while operating the starter
to make starting easier. Starting a petrol engine
Do not press the accelerator.
Operate the starter, without
releasing the key, until the engineturns.
Starting a diesel engine
Do not press the accelerator.
Turn the key to the second notch.If the engine is warm enough, the pre-heat light does not come on
and you can start immediately. If the pre-heat light comes on, wait for it to go out before operat-
ing the starter. If the engine stalls, it is necessary
to return the key to the STOPposition before restarting. Never race a coldengine. Never run the engine in a confined space.
Do not make any modifications tothe steering lock.
STARTING
STOP position:
The ignition is off.
1st notch, Accessories position:
The ignition is off but the acces- sories can be used. 2nd notch, Running position: The ignition is on. Starting position:
Operates the starter. YOUR 406 COUPE AT A GLANCE
5
02-02-2004
Page 11 of 141
Moving Off
With the engine running, to move off from position P:
press the brake pedal to change out of position P (shift lock),
select the required position ( R, D, 3, 2or 1) then gradually release the brake pedal; the vehicle moves off
immediately.
You can also move off from position N:
release the handbrake, keeping your foot on the brake pedal,
select the required position ( R, D, 3, 2or 1) then gradually release the brake pedal; the vehicle moves off
immediately.
The four speed automaticgearbox offers a choice between the comfort of integral operation,enhanced by a
sport programme (switch A) and a snowprogramme (switch B).
Gear selection gate Move the lever in the gate to select a position.
Once the position is selected, the indicator light for that position illuminates on the instrument panel display.
P ark: for immobilising the vehicle and starting the engine , with the handbrake on or off.
R everse: for reversing (select this position with the vehicle stationary, engine at idle).
N eutral: for starting the engine and for parking, with the handbrake on.
D rive: for driving in autoadaptive mode (automatic changing of the four gears).
3 : for driving in townor on winding roads (automatic changing of the first 3 gears only).
2 : for driving in the mountainsor for towing a trailer (automatic changing of the first 2 gears only).
1 : for tackling steep gradients (selection of first gear only).
Special feature of the gearbox (2 litre petrol engine) Selection of first gear is by pressing switch Cwith the selector lever in
position 2.
To change out of first gear, pressswitch Cagain or move
the gear lever.
AUTOMATIC AUTOADAPTIVE GEARBOX
2 litre engine
YOUR 406 COUPE AT A GLANCE
12
V6 engine
124
02-02-2004
Page 12 of 141
CRUISE CONTROL The cruise control makes it possible to maintain a constant vehicle speed
programmed by the driver, whatever the condition of the road and withoutaction on the accelerator or brake pedal.
To be memorised, the vehicle speed must be above 25 mph (40 km/h) or 37 mph (60 km/h), depending on the engine, with at least 4th gearengaged (2nd gear for the automatic gearbox). Operation Place knob 1in the ONposition.
A speed can be memorised. Place knob 1in the OFFposition to deactivate the system.
Memorising a speed When you reach the required speed, press button 2or 3. The speed is
memorised and will be maintained automatically.Note: it is possible to accelerate temporarily without deactivating the
cruise control.
Deactivation of the memorised speedIf you wish to deactivate the memorised speed: press button 4or the clutch or brake pedal.
Recalling the memorised speedFollowing deactivation, press button 4. Your vehicle resumes
the last speed memorised. Do not use the cruise control on slippery roadsor in heavy traffic.
YOUR 406 COUPE AT A GLANCE 13
127
Modifying a memorised speed
To memorise a speed greater than the previous speed:
press button 3;
release it when you havereached the required speed.
To memorise a speed lower thanthe previous speed: press button 2;
release it when you reach therequired speed.
Cancelling the memorised speed Place knob 1in the OFFposi-
tion or switch off the ignition.
02-02-2004
Page 13 of 141
02-02-2004
FUEL FILLER FLAP
To open:firmly pull the handle on
the floor to the outside of the driver's seat.
To close: from outside the vehi-
cle, push back the flap and check
that it is secured correctly. Filling with fuel Switch off the engine.
A filler cap hook is provided.
A label on the inside of the flap shows which fuels are permitted and which are not. The capacity of the tank is approximately 15.4 gallons (70 litres).
Low fuel level warning lightFrom the time this light comes on, the range remaining is approximately 30 miles (50 km).
Outside the vehicle:Raise the catch andopen the bonnet.
OPENING THE BONNET Inside the vehicle:Pull the handle.
YOUR 406 COUPE AT A GLANCE
14
9191
Page 14 of 141
02-02-2004
PEUGEOT SERVICING
Your vehicle benefits from extended service intervals.
¥ For petrol engines: every 20,000 miles (30 000 km) or every two years.
¥ For direct injection diesel engines: every 12,000 miles (20 000 km) or every two years. The service indicator informs you when each service is due; the point at which it is due is calculated from the last indicator zero reset (see corresponding section). This point is determined by two parameters: - the distance travelled,- the time elapsed since the last service. Note:the distance remaining may be weighted by the time factor, in accordance with the driver's style of driving.
The extension of the service intervals means that the engine oil level must be checked regularly: topping up of the oil between oil changes is normal. It is for this reason that the PEUGEOT network invites you to an intermediate visit between regular services.
The date of this service is not shown by the service indicator. It is to be carried out at least every 10,000 miles (15 000 km) for petrol engines and every 6,000 miles (10 000 km) for direct injection diesel engines.
A PEUGEOT dealer will carry out a quick check, and will top up the levels if necessary (oil, coolant, screenwash up to 2 litres). If the oil level is too low there is a risk of serious damage to the engine: check the engine oil level at least every 2,000 miles (3 000 km) or 3,000 miles (5 000 km), depending on the conditions of use The extended service intervals have been made possible by technical modifications to the vehicles and lubricants:
THUS IT IS ESSENTIAL TO ONLY USE LUBRICANTS WHICH ARE SUITED TO YOUR ENGINE AND RECOMMENDED BY
THE MANUFACTURER (see pages on "Lubricants").
MAINTENANCE OF YOUR 406 COUPE
18
Page 15 of 141
02-02-2004
SPECIAL FEATURES Some of your vehicle's vital components have specific servicing schedules. The brake fluid must be replaced every 36,000/40,000 miles (60,000 km) or every 2 years.
The passenger compartment filter must be checked at each visit to the PEUGEOT dealer (intermediate visits and regular services).
Replacement of the timing belt:consult your PEUGEOT dealer.
MAINTENANCE OF YOUR 406 COUPE 19
Arduous conditions of use If the vehicle is used in certain particularly arduous conditions:
¥ Continuous door-to-door use.
¥ Town use (e.g. taxi).
¥ Repeated short journeys, with the engine cold in low temperatures. Or for long stays in the following conditions:
¥ Hot countries with temperatures often above 30 degrees Celsius.
¥ Cold countries with temperatures often below minus 15 degrees Celsius.
¥ Countries with a dusty atmosphere.
¥ Countries whose lubricants or fuels do not conform to our recommendations. It is necessary to follow an "Arduous conditions" servicing schedule, which includes special operations and shorter ser- vice intervals:
¥ Every 12,000 miles (20,000 km) or every year for petrol engine vehicles.
¥ Every 9,000 miles (15,000 km) or every year for Direct Injection Diesel engine vehicles.
Page 16 of 141
02-02-2004
SPECIAL FEATURES Some of your vehicle's vital components have specific servicing schedules. The brake fluid must be replaced every 36,000/40,000 miles (60,000 km) or every 2 years.
The passenger compartment filter must be checked at each visit to the PEUGEOT dealer (intermediate visits and regular services).
Replacement of the timing belt:consult your PEUGEOT dealer.
MAINTENANCE OF YOUR 406 COUPE 19
Arduous conditions of use If the vehicle is used in certain particularly arduous conditions:
¥ Continuous door-to-door use.
¥ Town use (e.g. taxi).
¥ Repeated short journeys, with the engine cold in low temperatures. Or for long stays in the following conditions:
¥ Hot countries with temperatures often above 30 degrees Celsius.
¥ Cold countries with temperatures often below minus 15 degrees Celsius.
¥ Countries with a dusty atmosphere.
¥ Countries whose lubricants or fuels do not conform to our recommendations. It is necessary to follow an "Arduous conditions" servicing schedule, which includes special operations and shorter ser- vice intervals:
¥ Every 12,000 miles (20,000 km) or every year for petrol engine vehicles.
¥ Every 9,000 miles (15,000 km) or every year for Direct Injection Diesel engine vehicles.
Page 19 of 141
02-02-2004
SERVICE LEVELS Each vehicle has its own servicing cycle, based upon the engine type.
The servicing cycle consists of alternating 2 types of service A and C, intermediate visits, and a few additional operations depending on your vehicle; these correspond to key stages in the life of your 406. Level B service is designed for less recent vehicles.When the first service is carried out and at each subsequent service, your dealer will advise you of the type and content of the next service due.
MAINTENANCE OF YOUR 406 COUPE
20
These fixed operations are carried out with synthetic based oil; Fuel Economy
oil or synthetic oil may also be used.
* Whichever comes first. Intermediate visit.
THE MAINTENANCE CYCLE FOR YOUR 406 COUPE PETROL ENGINE
2 litre 16V and 2.2 litre 16V Petrol Engine: Service every 20,000 miles (30 000 km) or 2 years
1st service at 6,000 miles
(10 000 km) or 6 months*. This is necessary
in order to benefit
from the warranty.
MILES (KM) 20,000 (30 000) 40,000 (60 000) 60,000 (90 000)
80,000 (120 000) 100,000 (150 000) 120,000 (180 000) 140,000 (210 000) 160,000 (240 000)
Page 20 of 141
02-02-2004
80,000 (120,000) 100,000 (150,000) 120,000 (180,000) 140,000 (210,000) 160,000 (240,000)MILES (KM) 20,000 (30,000) 40,000 (60,000) 60,000 (90,000)
These fixed operations are carried out with
synthetic based oil; Fuel Economy oil or
synthetic oil may also be used.
* Whichever comes first. Intermediate visit.
THE MAINTENANCE CYCLE FOR YOUR 406 COUPE PETROL ENGINE
V6 24V Petrol injection Engine : Service every 20,000 miles (30,000 km) or 2 years
1st service at 6,000 miles
(10 000 km) or 6 months*. This is necessary
in order to benefit
from the warranty.
+ replacement of air filter
+ replacement of fuel filter
+ replacement of air filter
+ replacement of fuel filter
MAINTENANCE OF YOUR 406 COUPE 21