light Peugeot Traveller 2016 Manual PDF

502
Traveller-VP_en_Chap11_index-alpha_ed01-2016
Warning lamp, SCR emissions control system ....................25
W
arning lamp, seat belts
.............................. 16

6
Warning lamp, Service ....................................26
Warning lamp, Stop
........................................ 16
W

asher jets, heated
.............................. 13

1, 157
Weights


................................................. 324-326
Welcome lighting ........................................... 149
Wheel, spare


........................ 258, 284, 291, 292
Windows, rear


............................................... 118
Windscreen, heated


..............................131, 157
Wiper blades (changing)
....................... 1

5 7, 2 6 9
Wiper, rear ............................................. 155, 15 6
Wipers


............................................. 27, 15 4, 155
Wipers, automatic rain sensitive


...........15 4, 155
Alphabetical index

18
Driving
Traveller_VP_complement_sieges_enfant_en_Chap10_securite_ed01-16
This system, also called automatic emergency
braking, aims to reduce the speed of impact
or avoid a frontal collision by your vehicle
(between 3 and 87 mph (5 and 140 km/h)
where the driver fails to react.
Using a radar and a camera, this system acts
on the vehicle's braking system.
Active Safety Brake
The driver can take back control of the vehicle
at any time by sharply turning the steering
wheel and/or pressing the accelerator pedal.Operation of the system may be felt by
slight vibration in the brake pedal.
If the vehicle comes to a complete stop,
the automatic braking is maintained
for 1 to 2 seconds.
If your vehicle has a manual gearbox, in
the event of the automatic emergency
braking bringing the vehicle to a
complete stop, the engine may stall.
If your vehicle has an automatic
gearbox, in the event of the automatic
emergency braking bringing the vehicle
to a complete stop, the vehicle will
move off again; press the brake pedal.
If automatic emergency braking is
not activated, you are alerted by the
fixed display of this warning lamp
accompanied by a message. The point at which braking is triggered
may be adjusted according to the
reaction from the driver, such as
movement of the steering wheel or
pressing the accelerator pedal. If the radar and the camera have
confirmed the presence of a vehicle
or a pedestrian, this warning lamp
flashes when the system is operating.
Important
: if operation of the
automatic emergency braking is
triggered, you should take back
control of your vehicle and brake
with the pedal to add to or finish the
automatic braking.
Intelligent emergency
braking assistance
If the driver does not brake sufficiently
to avoid an accident, this system will
complete the braking.
This emergency braking system will not
act if you press the brake pedal.

19
6
Driving
Traveller_VP_complement_sieges_enfant_en_Chap10_securite_ed01-16
Deactivation / Activation of
the alert and the braking
By default, the function is automatically
activated at every engine start.
The deactivation or activation of the function is
done in the vehicle configuration menu.
With the audio system
In the" Personalisation-configuration "
menu, activate/deactivate " Auto. emergency
braking ".
With the touch screen
In the vehicle settings menu, activate/
deactivate " Collision risk alert and automatic
braking ". In the event of a fault, you are alerted
by the illumination of this warning
lamp, accompanied by an audible
signal and a message.
Contact a PEUGEOT dealer or a
qualified workshop.
Operating fault
There may be interference in the
operation of the camera or it not work at
all in the following situations:
- poor visibility (inadequate street
lighting, falling snow or rain, fog, ...),
- dazzle (headlamps of an approaching vehicle on the other
side of the road, low sun, reflection
on a wet road, leaving a tunnel,
alternating between light and
shade, ...),
- the area in front of the windscreen: dirty, misty, frosty, snow-covered,
damaged or covered by a sticker.
The operation of the radar, located in
the front bumper, may be disturbed
in certain weather conditions: with
accumulations of snow, ice, mud, ...
Clean the front bumper, removing the
snow, mud, ... If one of the two sensors (camera
or radar) is masked or its visibility
is reduced, while the other sensor
is able to work normally, the system
still operates, but at a lower level of
per formance. This is not indicated by a
message or a warning lamp.
To ensure correct operation of the radar
radar, do not paint over the paintwork
on the vehicle's bumper.
Keep the windscreen in front of the
camera clean.
Do not allow snow to accumulate on
the bonnet or roof of the vehicle as this
could mask the camera's view.

171
Transversal-Peugeot_en_Chap03_RD6_ed01-2016
To modify the contacts saved in the
system, press MENU then select
" Telephone " and confirm.
Select " Directory management "
and confirm.
Yo u c a n :
-
"Consult an entr y ",
-
"Delete an entry ",
-
"Delete all entries ".
Make a long press on SRC/TEL .
The system accesses the telephone's
contacts directory, depending on
its compatibility, and while it is
connected by Bluetooth.
With certain telephones connected
by Bluetooth you can send a contact
to the directory of the audio system.
Contacts imported in this way are
saved in a permanent directory
visible to all, whatever the telephone
connected.
The menu for the directory is not
accessible if it is empty.
Select "
Directory " to see the list of
contacts.
Directory
Confirm with OK.
OR
Voice recognition
This function allows you to use your
smartphone's voice recognition via the system.
To start voice recognition, depending on the
type of steering mounted controls:
Make a long press on the end of the lighting
control stalk.Press this button.
Voice recognition requires the use of a
compatible smartphone first connected
to the vehicle by Bluetooth.
.
Audio and Telematics

109
13
12
10
11
9
14
4
4
5
5
Transversal-Peugeot_en_Chap02_RCC-2-2-0_ed01-2016
Level 1Level 2 Level 3 Comments
Applications
i-Cockpit Amplify Relax
Boost
OR
i-Cockpit Amplify Relax
Boost Settings
Fragrance
Select a fragrance.
Lighting Adjust the intensity of the ambience lighting.
Ambience Adjust the sound ambience.
Driver massage Select and configure the driver massage.
Passenger Massage Select and configure the passenger massage.
Dynamic Set the driving mode.
Save settings Save the settings.
Reset the mode Reset the ambience parameters.
Confirm the selections and settings.
Deactivate Deactivate the "i- Cockpit Amplify function.
Profile management Profile 1
Configure the profiles.
Profile 2
Profile 3
Common profile Save the settings.
Confirm the selections and settings.
.
Audio and Telematics