glove box Ram 2500 2011 Owner's Manual
[x] Cancel search | Manufacturer: RAM, Model Year: 2011, Model line: 2500, Model: Ram 2500 2011Pages: 622
Page 92 of 622
▫Sunroof Maintenance................. 160
▫Sunroof Fully Closed.................. 160
Electrical Power Outlets................. 160
Cigar Lighter And Ash Receiver —
If Equipped.......................... 163
Power Inverter — If Equipped............ 164
Cupholders.......................... 166
▫Front Instrument Panel Cupholders —
(40–20–40 Seats)..................... 166
▫Front Instrument Panel Cupholders — Floor
Mounted Shifter..................... 166
▫Rear Cupholder — Quad Cab.......... 167
▫Rear Cupholder — Crew Cab........... 167Storage............................. 168
▫Glove Box Storage................... 168
▫Door Storage....................... 170
▫Center Storage Compartment —
If Equipped........................ 171
▫Second Row In-Floor Storage Bin —
If Equipped........................ 173
▫Seatback Storage..................... 174
▫Storage (Regular Cab)................. 174
▫Storage And Seats (Crew Cab)........... 174
▫Plastic Grocery Bag Retainers (Regular Cab
Models)........................... 175
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 91
Page 169 of 622
STORAGE
Glove Box Storage
The glove box is located on the passenger side of the
instrument panel and features both an upper and lower
storage area.
Glove Box
1 — Upper Glove Box
2 — Lower Glove Box 168 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 170 of 622
To open the upper glove box push upward on the handle
release. The glove box door will automatically open.To open the lower glove box, pull on the handle to release
the latch and lower the door.
Upper Glove BoxLower Glove Box
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 169
Page 195 of 622
Disconnecting the Rear Camera — If Equipped
1. Open the tailgate to access the rear camera connector
bracket located on the rear sill.
2. Remove the connector bracket from the sill by press-
ing inward in the locking tab.3. Disconnect the chassis wiring harness, ensuring the
connector bracket does not fall into the sill.
4. Connect the chassis plug and bracket (provided in the
glove box) to the chassis wiring harness and insert the
bracket back into the sill.
Connector Bracket
Locking Tab
194 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 196 of 622
5. Connect the tailgate plug (provided in the glove box)
to the tailgate wiring harness to ensure that the terminals
do not corrode.
6. Tape the tailgate harness and bracket against the
forward-facing surface of the tailgate. This will prevent
damaging the connector and bracket when storing or
reinstalling the tailgate.
Removing the Tailgate
1. Disconnect the wiring harness for the rear camera (if
equipped), refer to “Disconnecting the Rear Camera — If
Equipped” in this section.
2. Unlatch the tailgate and remove the support cables by
releasing the lock tang from the pivot.3. Raise the tailgate to a 45 degree angle.
4. Raise the right side of the tailgate until the right side
pivot clears the hanger bracket.
5. Slide the entire tailgate to the right to free the left side
pivot.
Locking Tang
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 195