Viscosity Ram 2500 2014 Diesel Supplement

ENGINE BREAK-IN RECOMMENDATIONS
The diesel engine does not require a break-in period due
to its construction. Normal operation is allowed, provid-
ing the following recommendations are followed:
•Warm up the engine before placing it under load.
•Do not operate the engine at idle for prolonged
periods.
•Use the appropriate transmission gear to prevent
engine lugging.
•Observe vehicle oil pressure and temperature indica-
tors.
•Check the coolant and oil levels frequently.
•Vary throttle position at highway speeds when carry-
ing or towing significant weight.NOTE:Light duty operation such as light trailer towing
or no load operation will extend the time before the
engine is at full efficiency. Reduced fuel economy and
power may be seen at this time.
The engine oil installed in the engine at the factory is a
high-quality energy conserving type lubricant. Oil
changes should be consistent with anticipated climate
conditions under which vehicle operations will occur.
The recommended viscosity and quality grades are
shown under “Fluids, Lubricants and Genuine Parts”,
under “Maintaining Your Vehicle” in this manual. NON-
DETERGENT OR STRAIGHT MINERAL OILS MUST
NEVER BE USED.
14 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

•Climatized Ultra Low Sulfur Diesel Fuel is a blend of
Number 2 Ultra Low Sulfur and Number 1 Ultra Low
Sulfur Diesel Fuels which reduces the temperature at
which wax crystals form in fuel.
•The fuel grade should be clearly marked on the pump
at the fuel station.
•The engine requires the use of“Ultra Low Sulfur
Diesel Fuel”. Use of incorrect fuel could result in
engine and exhaust system damage. Refer to “Fuel
Requirements” in “Starting And Operating” for fur-
ther information.
Engine Oil Usage
Refer to “Maintenance Procedures” in “Maintaining Your
Vehicle” for the correct engine oil viscosity.
Engine Warm-Up
Avoid full throttle operation when the engine is cold.
When starting a cold engine, bring the engine up to
operating speed slowly to allow the oil pressure to
stabilize as the engine warms up.
If temperatures are below 32°F (0°C), operate the engine
at moderate speeds for five minutes before full loads are
applied.
Engine Idling
Avoid prolonged idling, long periods of idling may be
harmful to your engine because combustion chamber
temperatures can drop so low that the fuel may not burn
completely. Incomplete combustion allows carbon and
varnish to form on piston rings, cylinder head valves,
and injector nozzles. Also, the unburned fuel can enter
the crankcase, diluting the oil and causing rapid wear to
the engine.
4
STARTING AND OPERATING 65

mark. The total capacity from the MIN mark to the MAX
mark is 1.3 qts (1.2 L).
CAUTION!
Overfilling or underfilling the crankcase will cause
oil aeration or loss of oil pressure. This could damage
your engine.
NOTE:It is possible for your oil level to be slightly
higher than a previous check. This would be due to diesel
fuel that may temporarily be in the crankcase due to
operation of the diesel particulate filter regeneration
strategy. This fuel will evaporate out under normal
operation.
Never operate the engine with oil level below the “MIN”
mark or above the upper “MAX” mark.
Change Engine Oil
Refer to the “Maintenance Schedule” for the proper
maintenance intervals.
Engine Oil Viscosity (SAE Grade)
CAUTION!
Your vehicle is equipped with an advanced technol-
ogy Diesel Engine and an emission device designed
to limit Diesel Particulate Emissions from being
released into the atmosphere. The durability of your
engine and life expectancy of this diesel particulate
filter emission device is highly dependent on the use
of the correct engine oil.
5
MAINTAINING YOUR VEHICLE 103

Engine Oil Usage
Refer to “Maintenance Procedures” in “Maintaining Your
Vehicle” for the correct engine oil viscosity.
Winter Front Usage
A winter front or cold weather cover is to be used in
ambient temperatures below 32°F (0°C), especially dur-
ing extended idle conditions to reduce condensation
build-up within engine crankcase. If a winter front or
cold weather cover is to be used, a percentage of the total
grille opening area must be left uncovered to provide
sufficient air flow to the charge air cooler and automatic
transmission oil cooler. The percentage of opening must
be increased with the increasing ambient air temperature
and/or engine load. If the cooling fan can be heard
cycling frequently, increase the size of the opening in the
winter front. A suitable cold weather cover is available
from your MOPAR® dealer.
Battery Blanket Usage
A battery loses 60% of its cranking power as the battery
temperature decreases to 0°F (-18°C). For the same de-
crease in temperature, the engine requires twice as much
power to crank at the same RPM. The use of 120 VAC
powered battery blankets will greatly increase starting
capability at low temperatures. Suitable battery blankets
are available from your authorized MOPAR® dealer.
Engine Warm-Up
Avoid full throttle operation when the engine is cold.
When starting a cold engine, bring the engine up to
operating speed slowly to allow the oil pressure to
stabilize as the engine warms up.
NOTE:High-speed, no-load running of a cold engine can
result in excessive white smoke and poor engine perfor-
mance. No-load engine speeds should be kept under
1,200 RPM during the warm-up period, especially in cold
ambient temperature conditions.
216 STARTING AND OPERATING

Oils with a high ash content may produce damaging
deposits on cylinder head valves and/or aftertreatment
system damage. A maximum sulfated ash content of 1.00
mass % is recommended for all oil used in the engine.
The same oil change interval is to be followed for
synthetic oil as for petroleum based oil. Also, synthetic oil
must meet the same performance specifications as petro-
leum oil.
CAUTION!
Do not use chemical flushes in your engine oil as the
chemicals can damage your engine. Such damage is
not covered by the New Vehicle Limited Warranty.
Engine Oil Viscosity (SAE Grade)
In ambient temperatures above 0°F (-18°C), we recom-
mend you use SAE 15W-40 engine oil such as MOPAR,
Shell Rotella and Shell Rimula that meets FCA USMaterial Standard MS-10902 and the API CJ-4 engine oil
category is required. Products meeting Cummins CES
20081 may also be used. The identification of these
engine oils is typically located on the back of the oil
container.
In ambient temperatures below 0°F (-18°C), SAE 5W-40
we recommend you usesyntheticengine oil such as
MOPAR, Shell Rotella and Shell Rimula that meets FCA
US Material Standard MS-10902 and the API CJ-4 engine
oil category is required.
CAUTION!
Failure to use SAE 5W-40 synthetic engine oil in
ambient temperatures below 0°F (-18°C) could result
in severe engine damage.
294 MAINTAINING YOUR VEHICLE

Engine oil not designated by the FCA US or Cummins
Material Standards and API CJ-4 should not be used, as
engine and exhaust system durability may be compro-
mised. The engine oil filler cap also shows the recom-
mended engine oil viscosity for your engine. For infor-
mation on engine oil filler cap location, refer to “Engine
Compartment” in “Maintaining Your Vehicle” for further
information.
Synthetic Engine Oils
You may use synthetic engine oils if the recommended oil
quality requirements are met and the recommended
maintenance intervals for oil and filter changes are
followed.
Materials Added To Engine Oil
The manufacturer strongly recommends against the ad-
dition of any additives (other than leak detection dyes) to
the engine oil. Engine oil is an engineered product and its
performance may be impaired by supplemental addi-
tives.
Engine Oil Filter
Refer to “Fluids, Lubricants, and Genuine Parts” in
“Maintaining Your Vehicle” for further information. The
engine oil filter should be changed at every engine oil
change.
6
MAINTAINING YOUR VEHICLE 295

Oil, Engine..............................102
Capacity.............................121
Change Interval........................103
Dipstick..............................102
Disposal..............................104
Filter............................104 , 122
Filter Disposal.........................104
Materials Added to......................104
Recommendation.......................102
Viscosity.............................103
Overheating, Engine........................20
Radiator Cap (Coolant Pressure Cap)...........113
Remote Starting System......................12
Schedule, Maintenance.....................128
Seat Belts
Reminder..............................22
Selection of Coolant (Antifreeze)...............122Signals, Turn.............................19
Speedometer.............................23
Starting.................................59
Automatic Transmission...................60
Engine Block Heater...................62,68
Remote...............................12
Starting Procedures.........................59
Starting Procedures (Diesel Engines).............59
Tachometer..............................18
Tip Start................................60
Ti re s
Pressure Warning Light....................24
Tongue Weight/Trailer Weight.................78
Towing.................................74
Guide................................78
Weight...............................78
Trailer Towing............................74
Cooling System Tips......................90
INDEX - RAM 1500 349

Hitches...............................77
Minimum Requirements...................79
Trailer and Tongue Weight.................78
Wiring................................87
Trailer Towing Guide.......................78
Trailer Weight............................78
Transfer Case
Fluid................................125
Transmission
Turn Signals..............................19
Viscosity, Engine Oil.......................103
Voltmeter................................63
Warning Lights (Instrument Cluster Description)....18
Water Separator, Diesel Fuel..................105
350 INDEX - RAM 1500

Materials Added to......................295
Recommendation.......................293
Synthetic.............................295
Viscosity.............................294
Overdrive...............................237
Overdrive OFF Switch......................237
Overheating, Engine.......................156
Perform Service Indicator, Reset...............336
Power
Take-Off Adapter.......................244
Take-Off Operation......................244
PTO (Power Take-Off)......................244
Radiator Cap (Coolant Pressure Cap)...........311
Remote Starting System.....................146
Resetting Perform Service Indicator............336Seat Belts
Reminder.............................159
Selection of Coolant (Antifreeze)...............328
Shifting................................225
Automatic Transmission..................227
Manual Transmission....................239
Signals, Turn............................155
Speedometer.............................159
Starting................................202
Automatic Transmission..................203
Engine Block Heater.................207 , 222
Manual Transmission....................203
Remote..............................146
Starting Procedures........................202
Starting Procedures (Diesel Engines)............202
Synthetic Engine Oil.......................295
Tachometer..............................154
INDEX - RAM 2500 / 3500 / 4500 / 5500 355

Tip Start................................203
Ti re s
Pressure Warning Light...................160
Tongue Weight/Trailer Weight................266
Torque Converter Clutch....................238
Towing................................261
Guide...............................266
Weight...............................266
Traction Control..........................317
Trailer Towing...........................261
Cooling System Tips.....................278
Hitches..............................265
Minimum Requirements..................267
Trailer and Tongue Weight.................266
Wiring...............................275
Trailer Towing Guide.......................266
Trailer Weight............................266
Transfer Case
Fluid................................330Transmission
Automatic............................227
Fluid................................330
Manual..........................203 , 239
Shifting..............................225
Turn Signals.............................155
Viscosity, Engine Oil.......................294
Voltmeter...............................214
Warning Lights (Instrument Cluster Description) . . .154
Water Separator, Diesel Fuel..................300
356 INDEX - RAM 2500 / 3500 / 4500 / 5500