AUX RENAULT KANGOO 2012 X61 / 2.G Owners Manual
[x] Cancel search | Manufacturer: RENAULT, Model Year: 2012, Model line: KANGOO, Model: RENAULT KANGOO 2012 X61 / 2.GPages: 237, PDF Size: 8.62 MB
Page 79 of 237
headlight beam adjustment .................. (up to the end of the DU)
lights adjustment ...................................... (up to the end of the DU)
1.73
ENG_UD6424_2
Réglage électrique de la hauteur des faisceaux (X61 - F61 - K61 - Renault)
ENG_NU_813-11_FK61_Renault_1
Réglage électrique de la hauteur des faisceaux
eLeCTRICAL ADJUSTMeNT OF THe DIppeD BeAM HeADLIGHTS
Control knob 1 is used to adjust the
height of the headlight beams accord -
ing to the load.
Turn control knob 1 downwards to
lower the headlights and upwards to
raise them.
Unladen, control knob 1 should be at 0.
When the vehicle is partially or com -
pletely laden, the headlight beam
should be set to light the road at be -
tween 50 and 100 metres. Then use
positions 1 to 4 on the control knob.
AB
100 m 50 m
A Incorrect setting: the lights are set
too high and could dazzle other
drivers. Turn the control knob
downwards to lower the beam.
B Correct setting: the beam’s maxi -
mum range is between 50 and 100
metres.
1
Page 160 of 237
levels .................................................... (up to the end of the DU)
levels: brake fluid ........................................................ (current page)
brake fluid .............................................................. (current page)
4.8
ENG_UD25825_5
Niveaux / Filtres (X61 - F61 - K61 - Renault)
ENG_NU_813-11_FK61_Renault_4
Jaune NoirNoir texte
Levels
levelS (1/3)
Brake fluid level
This should be checked frequently,
and immediately if you notice even the
slightest loss in braking efficiency.
The level should be read with the engine
switched off and on level ground. level 1
It is normal for the level to drop as the
brake shoes become worn, but it must
never drop lower than the
“MInI" warn-
ing line.
If you wish to check the disc and drum
wear yourself, you should obtain the
document explaining the checking pro-
cedure from our network or from the
manufacturer’s website. t
opping up
After any operation on the hydraulic cir-
cuit, a specialist must replace the fluid.
Only use fluids approved by our
Technical Department (and taken from
a sealed container).
Replacement intervals
Refer to the Maintenance Document for
your vehicle.
The engine may be hot
when carrying out opera -
tions in close proximity. In
addition, the engine cooling
fan can come on at any moment.
Risk of injury.
1
Consult your approved dealer at
once if you notice an abnormal or
repeated drop in any of the fluid
levels.Deactivate the Stop and
Start function for any opera -
tion performed in the engine
compartment.
Page 161 of 237
levels:coolant ............................................................. (current page)
engine coolant ....................................................... (current page)
JauneNoirNoir texte
4.9
ENG_UD25825_5
Niveaux / Filtres (X61 - F61 - K61 - Renault)
ENG_NU_813-11_FK61_Renault_4
levelS (2/3)
Coolant
The level when cold should be be -
tween the MINI and MAXI marks on the
coolant reservoir 2.
Top this level up when cold before it
reaches the MINI mark.
The level should be read with the engine
switched off and on level ground. Checking intervals
Check the coolant level regularly
(very severe damage is likely to be
caused to the engine if it runs out of
coolant).
If the level needs to be topped up, only
use products approved by our Technical
Department which ensure:
–
antifreeze protection;
– anticorrosion protection of the cool -
ing system.
No operations should be
carried out on the cooling
circuit when the engine is
hot.
Risk of burns.
Replacement intervals
Refer to the Maintenance Document for
your vehicle.
Consult your approved dealer at
once if you notice an abnormal or
repeated drop in any of the fluid
levels.
2
Page 162 of 237
levels:windscreen washer reservoir ........................... (current page)
filter ........................................................................\
(current page)
windscreen washer fluid ........................................ (current page)
4.10
ENG_UD25825_5
Niveaux / Filtres (X61 - F61 - K61 - Renault)
ENG_NU_813-11_FK61_Renault_4
levelS (3/3)/FIlteRS
Filters
Windscreen washer reservoir
t opping up
– Unscrew cap 3;
– fill until you can see the fluid;
– close the cap. liquid
Screen wash product (product with
antifreeze in winter).
Jets
To adjust the height of the windscreen
washer jets, use a tool such as a flatb-
lade screwdriver.
Filters
The replacement of filter elements (air
filter, cabin filter, diesel fuel filter, etc.)
is scheduled in the maintenance opera
-
tions for your vehicle.
Replacement intervals for filter el -
ements: refer to the Maintenance
Document for your vehicle.
The engine may be hot
when carrying out opera -
tions in close proximity. In
addition, the engine cooling
fan can come on at any moment.
Risk of injury.
3
Deactivate the Stop and
Start function for any opera -
tion performed in the engine
compartment.
Page 191 of 237
bulbschanging ......................................... (up to the end of the DU)
changing a bulb .................................... (up to the end of the DU)
indicators .............................................. (up to the end of the DU)
indicators: direction indicators .......................... (up to the end of the DU)
bulbs changing ......................................... (up to the end of the DU)
side indicator lights changing bulbs ................................ (up to the end of the DU)
5.21
ENG_UD6417_2
Répétiteurs latéraux : remplacement des lampes (X61 - F61 - K6\
1 - Renault)
ENG_NU_813-11_FK61_Renault_5
Répétiteurs latéraux : remplacement des lampes
Turn bulb holder 2 a quarter of a turn
and take out the bulb.
Bulb type: wy5w .
Replace the bulb and refit the indicator
light.
Unclip indicator light 1 on the door side,
using a flat-blade screwdriver type tool.
InDIcat
Or lIghts: changing bulbs
12