change time RENAULT KANGOO 2013 X61 / 2.G Instrument Panel Instruments Workshop Manual

83A-6
AFTER REPAIRCheck for correct operation.
V1 MR-376-X76-83A000$010.mif
INSTRUMENT PANEL INSTRUMENTS
Fault finding – Introduction83A
ACCESS TO FAULT FINDING MODE AND CHANGE OF PAGES
This function is viewed:
Version with and without trip computer
Input:
– By pressing and holding the odometer Reset button for 5 seconds when switching on the after ignition feed.
Scrolling:
– To scroll the trip computer information, press the odometer Reset button repeatedly.
Output:
– The fault finding phase ends automatically after 5 minutes.
– The fault finding phase ends after the ignition is switched off.
– The fault finding phase can be ended by pressing and holding the mileage counter reset button, which clears the
stored faults.
DESCRIPTION OF THE NEEDLE INDICATOR TEST SEQUENCE
The needle indicators are activated at the same time.
The speedometer displays, for 1 second in increments of 24 mph (40 km/h), speeds ranging from 0 to 102 mph
(170 km/h).
The rev counter displays, for 1 second in increments of 1000 rpm, values ranging from 0 to 7000 rpm.

83A-22
AFTER REPAIRCheck for correct operation.
V1 MR-376-X76-83A000$060.mif
INSTRUMENT PANEL INSTRUMENTS
Fault finding – Fault Finding Chart83A
ALP 3 The fuel level indicator does not display full
NOTESThe fuel tank must be filled with the ignition switched off (advise the customer to remove
the key).
Ideally the customer must fill the tank with at least 15 litres.
See Wiring Diagrams Technical Note for Kangoo VLL.
Ask the customer if the tank is filled up under the following
conditions:
– the customer filled the tank up to the 3
rd cut-out
– the customer has changed filling station
– the customer filled the tank in a flat-level station (not on
a slope).
Did the customer fill the tank while observing all of
these conditions?Ask the customer to return just after
having filled the tank under the conditions
mentioned above.
With the ignition off, disconnect the fuel sender
connector, component code 199 and then check the
resistance using a multimeter.
The value should be 51 .
Is the value measured in the correct range,
depending on the vehicle equipment?Replace the sender, component code 199
(see MR 374, Mechanical, 19C, Fuel
tank, Pump - Sender: Removal -
Refitting).
If the fault is still present, contact Techline.
NO
YES
NO
A