wiring diagram RENAULT SCENIC 2006 J84 / 2.G Tyre Pressure Monitoring Workshop Manual

TYRE PRESSURE MONITOR
Fault finding - Introduction
35B
35B-2
UCH
Program no.: 350 and higher
Vdiag No: 48-4C-4D-4F-50
135BTYRE PRESSURE MONITOR
Fault finding - Introduction
1. SCOPE OF THE DOCUMENT
This document presents the fault finding procedure applicable to all computers with the following specifications:
2. PREREQUISITES FOR FAULT FINDING
Documentation type
Fault finding procedures (this document):
–Assisted fault finding (integrated into the diagnostic tool), Dialogys.
Wiring diagrams:
–Visu-Schéma (CD-ROM).
Diagnostic tools type:
–CLIP
Special tooling required:
3. REMINDERS
Procedure
To run fault finding on the vehicle's computers, switch on the ignition in fault finding mode (forced + after ignition
feed).
Proceed as follows:
–vehicle card in reader,
–Press and hold start button (longer than 5 seconds) with start-up conditions not fulfilled,
–Then connect the diagnostic tool and perform the desired operations. Vehicle(s): SCENIC II
Function concerned: Tyre Pressure MonitorName of computer: UCH
Program no.: 0350 and higher
Vdiag No: 48, 4C, 4D, 4F, 50
Special tooling required
Multimeter
Elé. 1681Universal bornier
Ms. 1607Valve exciter
Pressure gauge
Tyre inflation system
SSPP_V48_PRELI /SSPP_V4C_PRELI/SSPP_V4D_PRELI/SSPP_V4F_PRELI/SSPP_V50_PRELI
Edition 4

List of monitored parts: Computer, valves, receivers
FAULT FINDING LOG
System: Tyre Pressure MonitorPage 1 / 2
●Administrative identification
Date 2 0
Log completed by
VIN
Engine
Diagnostic tool CLIP
Update version
●Customer complaint
1794 Tyre Pressure Monitor
orange warning light flashing:
text or icon
1797 Tyre Pressure Monitor
orange warning light lit
continuously: text or icon
1795 Puncture red warning light
lit: text or icon

1798 No pressure display 1796 Faulty display
1793 Wheels disappear from the display 1792 Wheels flashing on the display
OtherYour comments: (specify the tyre affected by the customer complaint):
●Conditions under which the customer complaint occurs
001 When cold 002 When warm 003 When stationary
004 Intermittently 005 While driving 009 Sudden fault
011 When ignition is switched on
OtherYour comments:
●
Documentation used in fault finding
Fault finding procedure used
Type of fault finding manual:Workshop Repair Manual: Technical Note Assisted fault finding
ALP followed: no...
Fault finding manual no:
Wiring diagram used
Wiring Diagram Technical Note No:
Other documentation
Title and/or part number:
FD 23
Fault finding log
page to print or photocopy - page to print or photocopy - page to print or photocopy