bonnet RENAULT SCENIC 2009 J84 / 2.G Air Conditioning Climate Control Workshop Manual
[x] Cancel search | Manufacturer: RENAULT, Model Year: 2009, Model line: SCENIC, Model: RENAULT SCENIC 2009 J84 / 2.GPages: 60
Page 52 of 60
62B-52
CLIMATE CONTROL
Fault finding – Fault Finding Chart62B
V3 MR-372-J84-62B000$110.mif
Vdiag No.: 44
ALP 11 Unpleasant odours in the passenger compartment
NOTESOnly consult this customer complaint after a complete check using the
diagnostic tool.
Check that the cabin filter is not blocked or damaged.
Replace it if necessary.
Is the fault still present?
YES
Check that the condensation drain ring (water from the
evaporator) is not obstructed (under the body).
Repair if necessary.
Is the fault still present?
YES
Check the sealing of the heating unit in relation to the engine
compartment:
–Foam seal on the heater matrix coolant pipes fitted and in
good condition.
–Rubber seal on the radiator tank fitted and in good condition
(seal under the bonnet separating the engine compartment
from the windscreen aperture).
–Drain valve on the radiator tank fitted and in good condition.
Repair if necessary.
Is the fault still present?
YES
Remove the cabin filter to apply air conditioning system
cleaner using an extension pipe on the evaporator.
Spray the entire contents of the aerosol.
Leave the product to work for 15 minutes.
NO
NO
NOEnd of fault finding procedure.
End of fault finding procedure.
End of fault finding procedure.
AFTER REPAIRPerform a complete check using the diagnostic tool.
ACREG X84 1.1
Edition 2
Page 53 of 60
62B-53
CLIMATE CONTROL
Fault finding – Fault Finding Chart62B
V3 MR-372-J84-62B000$110.mif
Vdiag No.: 44
ALP 12 Water is present in the passenger compartment
NOTESOnly consult this customer complaint after a complete check using the
diagnostic tool.
Pressurise the cooling circuit.
Is there any coolant leaking into the vehicle?
NO
Check that the evaporator drain ring is not blocked
(under the body).
Repair if necessary.
Is the fault still present?
YES
Check that the scuttle panel (under the windscreen frame) is not filled with water.
If it is, check that the drain valve is fitted to the scuttle panel and is in good condition.
Replace the valve if necessary.
Has the customer just washed the vehicle?
YES
Explain to the customer that when washing the car using a
hose pipe, the water jet must not be left for too long on the air
inlet in the scuttle panel (on the bonnet).
YES
NO
NORepair.
End of fault finding procedure.
End of fault finding procedure.
AFTER REPAIRPerform a complete check using the diagnostic tool.
ACREG X84 1.1
Edition 2