alarm RENAULT SCENIC 2013 J95 / 3.G Electrical Equipment Immobiliser Workshop Manual
[x] Cancel search | Manufacturer: RENAULT, Model Year: 2013, Model line: SCENIC, Model: RENAULT SCENIC 2013 J95 / 3.GPages: 37, PDF Size: 0.23 MB
Page 10 of 37
82A-10V1 MR-372-J84-82A000$040.mif
82A
SVT
Vdiag No.: 04
SPECIAL COMMANDS
VP001 Enter VIN
This command permits manual entry of the vehicle's VIN into the computer.
Use this command each time the computer is replaced or (re)programmed.
Procedure for writing the VIN
• Establish dialogue with the computer.
• Select the menu repair mode.
• Select the other parameters menu.
• Select the line VP001.
• Enter the VIN.
• Exit fault finding mode.
• Switch off the ignition.
• Wait for the end of power latch.
• Reread the VIN in the Identification menu for confirmation (ID004 "VIN").
RZ001: Clear faults
This command is used for clearing the stored faults from the computer.
CONFIGURATION READING
CF001: CONFIGURE SVT
LC001: External GPS aerial
LC002: Timed + battery feed
LC003: Alarm
ENGINE IMMOBILISER
Fault finding – Configurations and programming
Page 11 of 37
82A-11V1 MR-372-J84-82A000$050.mif
82A
SVT
Vdiag No.: 04
To remove and refit the computer, consult the Repair Manual for the vehicle concerned:
– LOGAN and SANDERO: MR 388, Mechanical, 82A, Immobiliser, Tracking unit: Removal - Refitting.
– DUSTER: MR 451, Mechanical, 82A, Immobiliser, Tracking unit: Removal - Refitting.
– MEGANE II: MR 364, Mechanical, 82A, Immobiliser, Tracking unit: Removal - Refitting.
– SCENIC II: MR 370, Mechanical, 82A, Immobiliser, Tracking unit: Removal - Refitting.
– MASTER II ph2 and ph3: MR 377, Mechanical, 82A, Immobiliser, Tracking unit: Removal - Refitting.
– THALIA 2/SYMBOL 2: MR 423, Mechanical, 82A, Immobiliser, Tracking unit: Removal - Refitting.
– Clio II F6: MR 430, Mechanical, 82A, Immobiliser, Tracking unit: Removal - Refitting.
– KANGOO VLL: MR 374, Mechanical, 82A, Immobiliser, Tracking unit: Removal - Refitting.
Procedure to be applied before repair:
– With the approval of the Techline, read the fault code to determine whether the fault is detected before replacing
the computer.
– Switch off the ignition and remove the computer.
Before replacing the computer, switch off the ignition and wait 1 minute for the system to shut down completely.
Note the current configuration of the computer by reading the configuration LC001 External GPS aerial.
Procedure to be applied after repair:
After replacing the computer, apply the programming command VP001 Enter VIN, check the computer configuration
using LC001 External GPS aerial, LC002 Timed + battery feed and LC003 Alarm and configure the new
computer if necessary using CF001 CONFIGURE SVT.
ENGINE IMMOBILISER
Fault finding – Replacement of components