light Seat Alhambra 2019 Owner's Guide

Lights and visibility
Windscreen wiper and win-
do w wiper syst
ems
Contr
ol lamp 
It lights up
Windscreen wiper level too low.
Top up the windscreen wiper r
eservoir as soon as
possible

Operation
Headlight wash/wipe system
The headlight w ashers/wipers cl
ean the
headlight l
enses.
After the ignition is switched on, the first and
every fifth time the windscreen washer is
switched on, the headlights are also washed.
Therefore, the windscreen wiper lever should
be pulled towards the steering wheel when
the dipped beam or main beam are on. Any
encrusted dirt (such as insects) should be
cleaned regularly (e.g. when refuelling).
To ensure the headlight washers work cor-
rectly in winter, any snow which has got into
the bumper jet supports should be cleaned
away. If necessary, remove snow with an an-
ti-icing spray. Note
The wiper will try to wipe away any obsta-
cles that ar e on the windscr

een. The wiper
will stop moving if the obstacle blocks its
path. Remove the obstacle and switch the
wiper back on again. Rain sensor*
Fig. 148
Windscreen wipers lever: adjust the
r ain sensor A .
Fig. 149
Rain sensor sensitive surface The rain sensor controls the frequency of the
windscr
een wiper int erv

als, depending on the
amount of rain

Lights and visibility
reduce the effectiveness of the rain sensor or
mak e it r
eact mor
e slowly, later or not at all.

Lights and visibility
Synchronised mirror adjustment

Air conditioning
The LED on each control lights up to indicate
that the r espectiv
e function of a contr
ol has
been switched on.
Some Climatronic controls may also be on
the air conditioner control panel located in
the rear centre console. These controls are
used to make the appropriate settings for the
rear seats. Note

Air conditioning
burn any fuel remaining in the auxiliary heat-
er . The e
xhaust gases ar
e also extracted from
the system.
Remote control Fig. 201
Independent heater: remote control. Fig. 201 Meaning
 Switch the auxiliary heater on.
 Switch the auxiliary heater off:
A Aerial.
B Light.
The auxiliary heater may accidentally switch
on if a butt
on is pr
essed on the r

emote control
by mistake. This may also occur outside the
range of the remote control or if the light
flashes. Remote control light
The remote contr

ol light provides users with
different information at the push of a button: Battery light
Fig. 201
B Meaning
Lights up green for
around tw o seconds. The auxiliary heat

er has
been switched on using the

 button.
Lights up red for
around tw o seconds. The auxiliary heat

er has
been switched off using the

button.
Slowly flashes green
for ar ound tw

o sec-
onds. No on
a)
signal has been re-
ceived.
Quickly fl
ashes
green f or ar

ound two
seconds. The independent heating is
block
ed.
P

ossible causes: the fuel tank
is almost empty, the battery
charge is very low or there is
a fault.
Flashes red for
around two seconds. No off
a)
signal has been r
e-
ceived.
Lights up or
ange for
around two seconds,
then gr

een or red. The remote control battery is
almost flat. How
ever, the on
or off signal has been re-
ceived, respectively.
Lights up orange for
around two seconds,
then fl

ashes green
or red. The remote control battery is
almost flat. The on or off sig-
nal has not been receiv
ed,
respectively. Battery light
Fig. 201
B Meaning
Flashes orange for
around five seconds. The r

emote control battery is
flat. The on or off signal has
not been r eceiv
ed, respec-
tively. a)
Within its range, the remote control might not re-
ceive the signal sent by the v ehicl

e receiver. In this
case, the remote control will send an error message
whether the auxiliary heater is on or off. Come closer
to the vehicle and press the corresponding button on
the remote control once again.
Replace the battery of the remote control
If the light

Driving
m
It lights up yellow
ASR deactivated manually.
Connect the ASR

Start and driving
F
It lights up yellow
Hindered operation of the electromechanic steering.
The steering syst em shoul
d be checked by a special-
ised workshop as soon as possible. If, after restarting
the engine and driving for a short distance, the yel-
low warning lamp no longer comes on, it will not be
necessary to take the vehicle to a specialised work-
shop.
The battery of the vehicle was disconnected and it
has been connected again.
Driv e a short dist

ance at around 15-20 km/h
(9-12 mph). F
Flashes red
Fault in the steering column electronic lock.

Driver assistance systems
to the presence of metallic objects (e.g. rails
on the r oad or sheets used in r
oad w
orks).
The area in front of and around the radar
sensor should not be covered with adhesives,
additional or similar headlights, as this may
negatively affect Front Assist operation.
If the front of the vehicle is not properly re-
paired or structural modifications are made
to it, for example if the suspension is lowered,
Front Assist operation may be affected. SEAT
recommends visiting a SEAT dealership for
this purpose. CAUTION
If you have the sensation that the radar
sensor is damaged or has lost its settings, disconnect the Fr ont Assist. This will av

oid
possible dangerous situations caused by a
system malfunction. If this occurs have it
adjusted.

Driving
Control lamps Control lamp in external rear view mirrors:
"
It lights up
It lights up once briefly: the blind spot detector is ac-
tivated and r eady to operate.
It lights up: blind spot detector has detected a vehi-
cle in the blind spot. "
Flashes
The blind spot detector has detected a vehicle in the
blind spot and the turn signal has been t urned on in
the dir

ection of the detected vehicle