display SKODA KODIAQ 2017 Owner´s Manual

BDepending on the search mode, the following
symbols are displayed

The navigation announcements provided may vary
from the actual situations, e.g. due to out-of-date
navigation data.
Route overview
During route guidance the display of a route over-
view is possible.

Pedestrian detection system
Functionality
Pedestrian recognition helps to prevent a collision
with crossing pedestrians by enabling automatic
braking interventions.
Status display in the instrument cluster display or
lights up - Danger of collision
Risk of collision in a speed range of 5-30 km/h
The system triggers automatic braking.
Risk of collision in a speed range of 30-60 km/h
The system warns of a collision hazard first. If the
driver does not respond, the vehicle is automatically
braked.
Operating conditions
q Front Assist activated.
q Driving speed between 5-60 km/h.
Speed limiter Functionality
The speed limiter controls the maximum driving
speed according to the set speed limit.
If the limit is exceeded when driving downhill, brake
the vehicle with the brake pedal.
Status display in the instrument cluster display illuminated - the cruise control is activated.
When the control starts,
is highlighted and the
set limit is displayed.
illuminated - cruise control is active
flashing - the set limit is exceeded
Operating conditions
q The driving speed is higher than 30 km/h.
Operation
Variant without GRA
A Activate limiter (control inactive)
Deactivate limiter
Interrupt control (sprung position)
B Resume control 1)
/Increase limitC Start control with current speed/Reduce
limit
Variant with GRA
A Activate GRA (condition for the subsequent
activation of the limiter).
To enable the speed limiter , press the key D
and in the instrument cluster choose the menu
item
Speed limit
.
Deactivate limiter
Interrupt control (sprung position)
B Resume control 1)
/Increase limitC Start control with current speed/Reduce
limitD Show menu of assist systems - Possibility of
switching between GRA and speed limiter
Switching to GRA interrupts the control.
Adjusting the speed limit with the buttons
B
and
C
By pressing in steps of 1 km/h.
By holding in steps of 10 km/h.
1)
If no speed limit is set, the current speed is set as the speed limit.
176Driver assist systems

Line A appears in the
display, indicating the
change in distance.

Settings
Activation/deactivation in the instrument cluster
In the display in the Assist systems menu item
Setting in Infotainment
In the following menu.

Or:

Troubleshooting
Message regarding system unavailability

Park Assist systems
Park Pilot parking aid Functionality
If an obstacle is detected, the Infotainment will dis-
play a visible message and an audible signal will
sound.
The interval between the signals becomes shorter as
the clearance is reduced. At a distance of less than
30 cm from the obstacle, a continuous tone sounds.
If the driver does not respond to the warning, the
system triggers automatic emergency braking at
speeds below 10 km/h in order to reduce the impact.
Automatic braking can be activated and deactivated
in the infotainment.
Display
The recorded areas vary according to the equipment.
ARoute controlled at the current steering angleAcoustic signals on/o

Front camera viewAMode for transverse parking
The orientation lines are used for estimating dis-
tance as well as for displaying the route, which is
controlled at the current steering angle.BMode for monitoring the area in front of the ve-
hicle (wide view)
The area right in front of the vehicle is marked
by the blue lines.CDistance monitoring mode
The red line marks the distance of about 40 cm
from the vehicle.
Side camera view
ALeft sideBRight sideCLeft and right side
The yellow line is shown at a distance of about
40 cm from the vehicle.
Operating conditions
q The ignition is switched on.
q The driving speed is lower than 15 km/h.
Operation
Switching on

Vehicle in collision area - danger of collision!
Approaching vehicle
Vehicle without Park Pilot
If an approaching vehicle is detected in the area be-
hind your vehicle, the a warning is displayed in the in-
strument cluster display, indicating to the driver to
monitor the traffic behind. At the same time, an
acoustic signal sounds.
Operating conditions
q No accessories are connected to the trailer sock-
et.
Function restriction
Manoeuvre Assist

Changing the parking mode
If a suitable parking space is found, the following
Park modes can be shown in the display.Park backwards longitudinallyPark backwards crosswisePark forwards across
The parking mode can be changed by pressing the
button .
Press the button again
and the system is switch-
ed o

Maintaining and cleaningService events
Service intervals
Compliance with service intervals is crucial for the
life and value of the vehicle.
The service events symbol
and the corresponding
message on the instrument cluster display indicate
that a service appointment is due.
The specialist garage will inform you of the type of
service interval, the option of changing this and the
scope of service.
All services and the replacement or refilling of op-
erating fluids are chargeable to the customer, even
during the warranty period, unless the