stop start SUBARU LEGACY 2000 3.G Owner's Guide

8-36n
Driving with a trailer
You should allow for c onsid erab ly more stop p ing d is tanc e when
towing a trailer. Avoid sud d en b raking b ec ause it m ay result in skid -
d ing or jac kknifing and loss of c ontrol. Avoid ab rup t starts and sud d en ac c elerations. If yo ur vehic le has a
manual transmission, always start out in first g ear and release the
c lutc h at mod erate eng ine revolution. Avoid uneven steering , sharp turns and rap id lane c hang es.
Slow d own b efore turning . Make a long er than normal turning
rad ius b ec ause the trailer wheels will b e c loser th an the vehic le
wheels to the insid e of the turn. In a tig ht turn, the trailer c ould hit your
vehic le. Crosswind s will ad versely affec t the hand ling of yo ur vehic le and
trailer, c ausing sway. Crosswind s c an b e d ue to wea ther c ond itions or
the p assing of larg e truc ks or b uses. If swaying oc c urs, firmly g rip the
steering wheel and slow d own immed iately b ut g rad ua lly.
When p assing other vehic les, c onsid erab le d istanc e is req uired
b ec ause of the ad d ed weig ht and leng th c aused b y at tac hing the
trailer to your vehic le. Bac king up with a trailer is d iffic ult and takes p r ac tic e. When b ac k-
ing up with a trailer, never ac c elerate or steer ra p id ly. When turning
b ac k, g rip the b ottom of the steering wheel with on e hand and turn it
to the left for a left turn, and turn it to the rig ht for a rig ht turn.
Left turnRight turn
OM-H2791
If the ABS warning lig ht illuminates while the vehi c le is in motion,
stop towing the trailer and have rep airs p erformed immed iately b y the

In case of emergency9-13
–
CONTINUED –
4
Connec t the other end of the c ab le to the eng ine li fting b rac ket.
Make sure that the c ab les are not near any moving p arts and that
the c ab le c lamp s are not in c ontac t with any other metal.
5. Start the eng ine of the vehic le with the b ooster b attery and run it at
mod erate sp eed . Then start the eng ine of the vehic l e that has the d is-
c harg ed b attery.
6. When finished , c arefully d isc onnec t the c ab les in exac tly the re-
verse ord er.
Engine overheating
WARNING
Never attempt to remove the radiator cap until the engine hasbeen shut off and has fully cooled down. When the engine is hot,the coolant is under pressure. Removing the cap while the engineis still hot could release a spray of boiling hot coolant, which
could burn you very seriously.
If the eng ine overheats, safely p ull off the road a nd stop the vehic le in a
safe p lac e.
If steam is coming from the engine compartment
Turn the eng ine off and g et everyone away from the vehic le until it
c ools d own. If no steam is coming from the engine compartment
1. Keep the eng ine running at id ling sp eed .
2. Op en the hood to ventilate the eng ine c omp artment .
Confirm that the c ooling fan is turning . If the fan is not turning , im-
med iately turn the eng ine off and c ontac t your auth orized d ealer for
rep air.
3. After the eng ine c oolant temp erature has d rop p ed , turn off the en-
g ine.
If the temp erature g aug e stays at the overheated zo ne, turn the en-
g ine off.

Maintenance and service11-11
–
CONTINUED –
12. Reinstall the c over und er the oil filter.
13. Pour the sp ec ified amount of eng ine oil throug h
the filler nec k.
Oil c ap ac ity: 4.2 US q t (4.0 liters, 3.5 Imp q t)
14. Start the eng ine and make sure that no oil leak s ap p ear around
the filter ’s rub b er seal.
15. Run the eng ine until it reac hes the normal op er ating temp erature.
Then stop the eng ine and wait a few minutes to allo w the oil d rain
b ac k. Chec k the oil level ag ain and if nec essary, a d d more eng ine oil.
Recommended grade and viscosity CAUTION
Use only engine oil with the recommended grade and viscosity.
Oil grade: API classification SJ or SH with the words “ENERGY
CONSERVING II ” (if you cannot obtain the oil with SJ
or SH grade, you may use SG grade oil.) or the new API certification mark (Starburst mark) dis-
played on the container.
New API Certification Mark (Starburst Mark)API Service label
1
2
3
1 Ind ic ates the oil q uality b y API d esig nations
2 Ind ic ates the SAE oil visc osity g rad e
3 Ind ic ates that the oil has fuel saving c ap ab ilities

11-16
HBB004FB
HBB007BB
4. Slowly p our the c oolant and fill to the rad iator filler nec k and to the
reserve tank ’s “FULL ” level mark. Do not p our the c oolant too q uic kly,
as this may lead to insuffic ient air b leed ing and t rap p ed air in the sys-
tem.
Coolant c ap ac ity: MT. 7.2 US q t (6.8 liters, 6.0 Imp q t)
AT. 7.1 US q t (6.7 liters, 5.9 Imp q t)
HG0115
Rubber gaskets
5. Put the rad iator c ap b ac k on and tig hten firmly. At this time, make
sure that the rub b er g asket in the rad iator c ap is c orrec tly in p lac e.
6. Start and run the eng ine for more than five minut es at 2,000 to
3,000 rp m.
7. Stop the eng ine and wait until the c oolant c ools d own (122 to
140 F [ 50 to 60 C] ). If there is any loss of c oolant, ad d c oolant t o the

11-30
Recommended clutch fluid
FMVSS No. 116, fresh DOT 3 or 4 brake fluid
Brake booster
If the b rake b ooster d oes not op erate as d esc rib ed b elow, have it
c hec ked b y your SUBARU d ealer.
1. With the eng ine off, d ep ress the b rake p ed al seve ral times, ap p lying
the same p ed al forc e eac h time. The d istanc e the p e d al travels should
not vary.
2. With the b rake p ed al d ep ressed , start the eng ine. The p ed al should
move slig htly d own to the floor.
3. With the b rake p ed al d ep ressed , stop the eng ine a nd keep the p ed al
d ep ressed for 30 sec ond s. The p ed al heig ht should n ot c hang e.
4. Start the eng ine ag ain and run for ab out one minu te then turn it off.
Dep ress the b rake p ed al several times to c hec k the b rake b ooster.
Brake b ooster op erates p rop erly if the p ed al stroke d ec reases with eac h
d ep ression.