airbag SUBARU OUTBACK 2000 3.G User Guide

Seat, seatbelt and SRS airbags1-9
–
CONTINUED –
HB1073BB
HB1019BB
To turn on the seat heater, p ush the “LO ” or “HI ” p osition on the switc h,
as d esired , d ep end ing on the temp erature. LO: Normal heating
HI: Rap id heating
The ind ic ator loc ated on the switc h c omes on when t he seat heater is in
op eration. When the vehic le ’s interior is warmed enoug h or b efore you
leave the vehic le, b e sure to turn the switc h off.
Rear seats
WARNING
Seatbelts provide maximum restraint when the occupant sits
well back and upright in the seat. Do not put cushions or any other
materials between occupants and seatbacks or seat cushions. If
you do so, the risk of sliding under the lap belt and of the lap belt
sliding up over the abdomen will increase, and both can result in
serious internal injury or death. Never allow passengers to ride on the folded rear seatback, in
the cargo area. Doing so may result in serious injury or death. Never stack luggage or other cargo higher than the top of the
seatback because it could tumble forward and injure passengersin the event of a sudden stop or accident.

Seat, seatbelt and SRS airbags1-11
–
CONTINUED –

Loading long objects
WARNING
Secure long objects properly to prevent them from shooting
forward and causing serious injury during a sudden stop or
sharp cornering. Tie long objects down with a rope or somethingequivalent. Avoid loading objects longer than 6.6 ft (2 m) and heavier than
55 lb (25 kg). Such objects can interfere with the driver ’s proper
operation of the car, possibly causing an accident and serious
injury.
HB1053BA
HB1052BA
Fold ing d own the armrest and op ening the seatb ac k p anel afford s a
load ing sp ac e for long ob jec ts.
To op en the seatb ac k p anel, p ull the p anel d own whi le p ressing the
release tab d own.
Folding down the rear seat — Station wagon
WARNING
After returning the rear seat to its original position, be certain
to place all of the seatbelts and the tab attached to the seat cush-ion above the seat cushion. And make certain that the shoulderbelts are fully visible. Never permit anyone to ride in the cargo area.

Seat, seatbelt and SRS airbags1-13
–
CONTINUED –
4. Store the seatb elts in the seatb elt p oc ket to p re
vent them from fal-
ling b elow the c ushion.
HB1074BB
HB1076BB
5. Raise the seat c ushion b y p ulling up the tab .
Make c ertain that the rear p asseng er ’s c up hold er is fully retruc ted
b efore raising the seat c ushion.
HB1025BA

Seat, seatbelt and SRS airbags1-15
–
CONTINUED –
Seatbelts
Seatbelt safety tips
WARNING
All persons in the vehicle should fasten their seatbelts BE-
FORE the vehicle starts to move. Otherwise, the possibility of se-
rious injury becomes greater in the event of a sudden stop or ac-cident. All belts should fit snugly in order to provide full restraint.
Loose fitting belts are not as effective in preventing or reducing
injury. Each seatbelt is designed to support only one person. Never
use a single belt for two or more persons — even children. Other-
wise, in an accident, serious injury or death could result. Replace all seatbelt assemblies including retractors and at-
taching hardware worn by occupants of a vehicle that has been ina serious accident. The entire assembly should be replaced evenif damage is not obvious. Put children aged 12 and under in the rear seat properly re-
strained at all times. The SRS airbag deploys with considerablespeed and force and can injure or even kill children, especially ifthey are 12 years of age and under and are not restrained or im-properly restrained. Because children are lighter and weaker than
adults, their risk of being injured from deployment is greater. Forthat reason, we strongly recommend that ALL children (includingthose in child seats and those that have outgrown child restraint
devices) sit in the REAR seat properly restrained at all times in achild restraint device or in a seatbelt, whichever is appropriate forthe child ’s height and weight.
Secure ALL types of child restraint devices (including forwardfacing child seats) in the REAR seats at all times.
NEVER INSTALL A REARWARD FACING CHILD SEAT IN THE
FRONT SEAT. DOING SO RISKS SERIOUS INJURY OR DEATH TOTHE CHILD BY PLACING THE CHILD ’S HEAD TOO CLOSE TO
THE SRS AIRBAG.

Seat, seatbelt and SRS airbags1-17
–
CONTINUED –

Automatic Locking Retractor (ALR) function
When sec uring a c hild restraint system on the p asse ng ers’ seats, the
seatb elt must b e c hang ed over to the Automatic Loc k ing Retrac tor (ALR)
mod e.
When the c hild restraint system is removed , make su re that the retrac tor
op erates as an Emerg enc y Loc king Retrac tor (ELR).
For instruc tions on how to c onvert the retrac tor to the ALR mod e and re-
store it to the ELR mod e, see the “Child restraint systems ” sec tion in this
c hap ter. Seatbelt warning light and chime
Your vehic le is eq uip p ed with a seatb elt warning d e vic e at the d river’s
seat.
This d evic e c auses the seatb elt warning lig ht on th e instrument p anel to
lig ht up for ab out six sec ond s when the ig nition sw itc h is turned to the
“ ON ” p osition to remind the d river to wear the seatb elt . If the d river’s
seatb elt is not fastened , a warning c hime sound s at the same time.
Fastening the seatbelt
WARNING
Never use a belt that is twisted or reversed. In an accident, this
can increase the risk or severity of injury. Never place the shoulder belt under the arm or behind the
back. If an accident occurs, this can increase the risk or severity
of injury. Keep the lap belt as low as possible on your hips. In a colli-
sion, this spreads the force of the lap belt over stronger hipbones instead of across the weaker abdomen. Seatbelts provide maximum restraint when the occupant sits
well back and upright in the seat. To reduce the risk of sliding un-der the seatbelt in a collision, the front seatbacks should be al-ways used in the upright position while the vehicle is running. Ifthe front seatbacks are not used in the upright position in a colli-
sion, the risk of sliding under the lap belt and of the lap belt slid-

Seat, seatbelt and SRS airbags1-19
–
CONTINUED –

Front and rear seatbelts (except rear center seatbelt on station wagon)
OM-H0044OM-H0043
1. Ad just the seat p osition:
Driver’ s seat: Ad just the seatb ac k to the up rig ht p osition. Move the
seatb ac k as far from the steering wheel as p rac tic a l while still main-
taining full vehic le c ontrol.Front passenger ’s seat: Ad just the seatb ac k to the up rig ht p osition.
Move the seat as far b ac k as p ossib le.
2. Sit well b ac k in the seat.
3. Pic k up the tong ue p late and p ull the b elt out sl owly. Do not let it
g et twisted . If the b elt stop s b efore reac hing the b uc kle, return the
b elt slig htly and p ull it out more slowly. If the b elt still c annot b e un-
loc ked , let the b elt retrac t slig htly after g iving a strong p ull on it, then
p ull it out slowly ag ain.
4. Insert the tong ue p late into the b uc kle until you hear a c lic k.
5. To make the lap p art tig ht, p ull up on the should er b elt. And p lac e
the lap b elt as low as p ossib le on your hip s, not o n your waist.
Rear center seatbelt on station wagon
WARNING
Fastening the seatbelt with the webbing twisted can increase
the risk or severity of injury in an accident. When fastening the
belt after it is out from the retractor, especially when inserting thesmaller tongue plate into the mating buckle (smaller one on right-

Seat, seatbelt and SRS airbags1-21
–
CONTINUED –
HB1033BA
2. After c onfirming that the web b ing is not twisted , insert the smaller
tong ue p late attac hed at the web b ing end into the b uc kle (smaller
one on the rig ht-hand sid e) until a c lic k is heard . If the b elt stop s b e-
fore reac hing the b uc kle, return the b elt slig htly and p ull it out more
slowly. If the b elt still c annot b e unloc ked , let t he b elt retrac t slig htly
after g iving a strong p ull on it, then p ull it out slowly ag ain.
HB1034BAHB1035BA
3. Insert the larg er tong ue p late in the larg er b uc k le marked “CEN-
TER ” on the left-hand sid e until it c lic ks. To make the lap p art tig ht,
p ull up on the should er b elt. And p lac e the lap b el t as low as p ossib le
on your hip s, not on your waist.

Seat, seatbelt and SRS airbags1-23
–
CONTINUED –

Unfastening the seatbelt Except station wagon models ’ rear center seatbelt
HB0303
Push
Push the b utton on the b uc kle.
Before c losing the d oor, make sure that the b elts a re retrac ted p rop er-
ly to avoid c atc hing the b elt web b ing in the d oor. Rear center seatbelt on station wagon
HS0317
Push
Push the release b utton of the larg er b uc kle (on th e left-sid e) to unfas-
ten the seatb elt. NOTE When the seatback is folded down for greater cargo space, it is
necessary to disconnect the smaller tongue plate from thebuckle.

Seat, seatbelt and SRS airbags1-25
–
CONTINUED –
store the tong ue p lates in the rec ess in the retrac
tor neatly and then
insert the smaller tong ue p late into the slot loc at ed at the front of the
rec ess. NOTE When folding down the rear seat cushion, store the seatbelts in the seatbelt pocket to prevent them falling below the cushion.
HB1074BB
HB1076BB

Seat, seatbelt and SRS airbags1-27
–
CONTINUED –
the front seat oc c up ant.
When a seatb elt p retensioner is ac tivated , an op era
ting noise will b e
heard and a small amount of smoke will b e released . These oc c ur-
renc es are normal and not harmful. This smoke d oes not ind ic ate a
fire in the vehic le.
Onc e the seatb elt p retensioner has b een ac tivated , the seatb elt re-
trac tor remains loc ked . Conseq uently, the seatb elt c an not b e p ulled
out and retrac ted . NOTE Seatbelt pretensioners are not designed to activate in minor
frontal impacts, in side or rear impacts or in roll-over accidents. The driver ’s seat and passenger ’s seat pretensioners and fron-
tal airbag operate simultaneously. Pretensioners are designed to function on a one-time-only ba-
sis. In the event that a pretensioner is activated, both the driver ’s
and front passenger ’s seatbelt retractor assemblies must be re-
placed and only by an authorized SUBARU dealer. When replac-
ing seatbelt retractor assemblies, use only genuine SUBARUparts. If either front seatbelt does not retract or cannot be pulled out
due to a malfunction or activation of the pretensioner, contactyour SUBARU dealer as soon as possible. If the front seatbelt retractor assembly or surrounding area
has been damaged, contact your SUBARU dealer as soon as pos-sible. When you sell your vehicle, we urge you to explain to the buy-
er that it has seatbelt pretensioners by alerting him to the con-tents of this section.