Transmission repair TOYOTA CAMRY 1999 Service User Guide

IN0253
WRONG CORRECT
IN0252
WRONG CORRECT IN±6
± INTRODUCTIONREPAIR INSTRUCTIONS
6 Author: Date:
(k) Care must be taken when jacking up and supporting the
vehicle. Be sure to lift and support the vehicle at the prop-
er locations (See page IN±8).
Cancel the parking brake on the level place and
shift the transmission in Neutral (or N position).
When jacking up the front wheels of the vehicle at
first place stoppers behind the rear wheels.
When jacking up the rear wheels of the vehicle at
first place stoppers before the front wheels.
When either the front or rear wheels only should be
jacked up, set rigid racks and place stoppers in front
and behind the other wheels on the ground.
After the vehicle is jacked up, be sure to support it
on rigid racks . It is extremely dangerous to do any
work on a vehicle raised on a jack alone, even for
a small job that can be finished quickly.
(l) Observe the following precautions to avoid damage to the
following parts:
(1) Do not open the cover or case of the ECU unless
absolutely necessary. (If the IC terminals are
touched, the IC may be destroyed by static electric-
ity.)
(2) To disconnect vacuum hoses, pull off the end, not
the middle of the hose.
(3) To pull apart electrical connectors, pull on the con-
nector itself, not the wires.
(4) Be careful not to drop electrical components, such
as sensors or relays. If they are dropped on a hard
floor, they should be replaced and not reused.
(5) When steam cleaning an engine, protect the elec-
tronic components, air filter and emission±related
components from water.
(6) Never use an impact wrench to remove or install
temperature switches or temperature sensors.
(7) When checking continuity at the wire connector, in-
sert the tester probe carefully to prevent terminals
from bending.
(8) When using a vacuum gauge, never force the hose
onto a connector that is too large. Use a step±down
adapter for adjustment. Once the hose has been
stretched, it may leak air.

Toyota Supports ASE CertificationPage 1 of 1
TC002±99Title:
REVISED DRIVE SHAFT GREASE
Models:
RAV4, Tercel, Corolla, Celica, Camry & Supra
Technical Service
BULLETIN
April 9, 1999

The greases supplied in replacement Inboard and Outboard Drive Shaft Boot Kits for the
following models has been revised.
With this revision, the grease compositions have been changed and are now both the
same color. To correctly lubricate each joint, consult the Service Repair Manual as to
which size packet of grease is designated for each Drive Shaft Joint Assembly.
NOTE:
Although Inboard and Outboard greases are now the same color, their compositions
are different.
All RAV4, Tercel, Corolla, Celica, Camry and Supra Models.
As outlined in the Service Repair Manual.
Refer to the appropriate Repair Manual for installation and lubrication information for
Drive Shaft Joint Assemblies.
OP CODEDESCRIPTIONTIMEOPNT1T2
N/ANot Applicable to Warranty ±±±±
TRANSMISSION & CLUTCH
Introduction
Affected
Vehicles
Required
Tools and
Material
Repair
Procedure
Warranty
Information