service schedule TOYOTA CAMRY V20 1986 Service Information
[x] Cancel search | Manufacturer: TOYOTA, Model Year: 1986, Model line: CAMRY V20, Model: TOYOTA CAMRY V20 1986Pages: 2389, PDF Size: 84.44 MB
Page 1912 of 2389

Maintenance services indicated by a star (*) or asterisk (*) are required under the terms of the Emission Control Systems Warranty. See Owner's Guide or Warranty Booklet
for complete warranty information.
* For vehicles sold in California
* For vehicles sold outside California
(1) Applicable to vehicles operated under conditions of extensive idling and /or low speed driving for long distances such as police, taxi or door±to±door delivery use.
(2) Applicable when operating mainly on dusty roads. If not, follow SCHEDULE B.
(3) Includes inspection of fuel tank band and vapor vent system.
(4) Also applicable to lining drum for parking brake.
(5) Check for leakage.
(6) Check for oil leaks from steering gear housing.
(7) Applicable only when operating mainly on rough, muddy roads. The applicable parts are listed below. For other usage conditions, refer to SCHEDULE B.
w
Front and rear suspension member to body
w
0 Strut bar bracket to body bolts
w
Bolts for sheet installation
MAINTENANCE SCHEDULESCHEDULE A
CONDITIONS:
wTowing a trailer, using a camper or car top carrier.
wRepeated short trips less than 5 miles (8 km) and outside temperatures remain below freezing.
wExtensive idling and/or low speed driving for a long distance such as police, taxi or door±to±door delivery use.
wOperating on dusty, rough, muddy or salt spread roads.Maintenance operations: A = Check and adjust if necessary;
R = Replace, change or lubricate;
I = Inspect and correct or replace if necessary
Maintenance services beyond 60,000 miles (96,000 km) should continue to be performed at the same intervals shown for each
maintenance schedule.
Service interval
(Odometer reading or
months, whichever
comes first)
Maintenance items
Manual transaxle, automatic transaxle
and differential Brake pads and discs (Front and rear)
Bolts and nuts on chassis and bodyExhaust pipes and mountings
Steering gear housing oily Brake line pipes and hosesFuel lines and connections
Ball joints and dust coversEngine oil and oil filter
Spark plugs (platinum tipped)MA±4 (item 2)
MA±6 (item 6)
Brake linings and drumsFuel tank cap gasket
Drive shaft boots
MA±14 item 221 MA±10 (item 20) MA±5 (item 3,4)
Steering linkageMA±7 (item 12)
MA±8 (item 14) Valve clearance
MA±8 (item 16)
MA±9 (item 19) MA±7 (item 13) MA±7 (item 11
MA±7 (item 10)
MA±9 (item 18) Charcoal canister
MA±9 (item 17) MA±8 (item 151
See page
(item No.)
Engine coolant
MA±6 (item 9) MA±4 (item 1)
MA±4 (item 2)
MA±5 (item 5)
MA±8 (item 8) AAA±6 (item 7)
Air filter¿21*
Spark plugsTiming belt
Drive belts
IGNITION
CHASSIS BRAKESENGINESystem
EVAP FUEL
± MAINTENANCEMaintenance ScheduleMA±2
Page 1913 of 2389

Maintenance services indicated by a star (*) or asterisk (*) are required under the terms of the Emission Control Systems Warranty.
See Owner's Guide or Warranty
Booklet for complete warranty information.
For vehicles sold in California
* For vehicles sold outside California
(1) Includes inspection of fuel tank band and vapor vent system.
(2) Also applicable to drum lining for parking brake.
(3) Check for leakage.
(4) Check for oil leaks from steering gear housing.
(5) The applicable part are listed below
wFront and rear suspension member to body
wStrut bar bracket to body bolts
wBolts for sheet installation
Maintenance service beyond 60,000 miles (96,000 km) should continue to be performed at the same intervals shown
for each maintenance schedule.
SCHEDULE BCONDITIONS: Conditions other than those listed for SCHEDULE A.
Service interval
(Odometer reading or
months, whichever
comes first)
Maintenance items
Manual transaxle, automatic
transaxle and differential (3) Brake pads and discs (Front and rearBolts and nuts on chassis and body 17)Exhaust pipes and mountings
Steering gear housing oil 1s) Brake linings and drums (4)
Brake line pipes and hoses Fuel lines and connections (31
Ball joints and dust covers Engine oil and oil filterSpark plugs (platinum tippedFuel tank cap gasket
MA±14 (item 22) MA±10 (item 20)
Charcoal canister
Steering linkage
Drive shaft boots
MA±7 (item 11)
MA±9 (item 19) MA±9 (item 18) MA±7 (item 13) MA±7 (item 10)
MA±8 (item 14) MA±7 (item 12)
MA±8 (item 16) MA±8 (item 15) See page
(item No.)
Engine coolant
MA±9 (item 17)
Valve clearance
MA±6 (item 8) MA±4 (item 2)
MA±6 (item 9) MA±6 (item 7)
MA±6 (item 7)
MA±5 (item 5) MA±5 (item 4)
Drive belts
Air filterSpark plugs
IGNITION
CHASSISBRAKES ENGINESystem
EVAPFUEL
± MAINTENANCEMaintenance ScheduleMA±3
Page 2253 of 2389

Line pressure (wheel locked)
Engine idling
At stall (Throttle valve fully opened)
Engine stall revolution
Time lag
Engine idle speed (A/C OFF)
Throttle cable adjustment (Throttle valve fully opened)
* O/D main switch OFF
NOTE:
(1) In the 2 and L ranges, all stages lock±up is OFF.
(2) In the following cases, the lock±up will be released regardless of the lock±up pattern.
wWhen the throttle is completely closed.
wWhen the brake light switch is ON.
Body clearance
Tip clearance
Side clearance
Pump body bushing inside diameter
Stator shaft bushing inside diameter
AUTOMATIC TRANSAXLE (A140E)
Specifications
Throttle valve fully open [ ] Fully closed
Piston stroke
Piston rod lengthThrottle valve opening 5 %
Second
coast brake
km/h (mph) Shift
schedule
Lock±up
point
Lock±up OFFkm/h (mph)
Lock±up ON NORM
P'WR NORM
PWR
Oil pumpD range
D range 2 range
L range
NORMNORM
O/D O/D
PWRPWR
2nd 3rd
2nd3rd
± SERVICE SPECIFICATIONSAutomatic Tiransaxle Al 40E)A±16
Page 2257 of 2389

At stall
(Throttle valve fully opened)
Engine stall revolution
Time lag N range ±
N range ±
Engine idling speed (A/C OFF)
Throttle cable adjustment (Throttle valve fully opened)
*1 3 ± O/D up±shift point with closed accelerator pedal is at 32 ± 45 km/h (20 ± 28 mph).
*2 Lock±up ºONº point with closed accelerator pedal is at 64 ± 73 km/h (40 ± 45 mph).
*3 Lock±up ºOFFº point with closed accelerator pedal is at 60 ± 68 km/h (37 ± 42 mph).
*4 O/D ± 3 down±shift is possible up to maximum speed.Governor pressure
Drive pinion rpm
1,000
1,800
3,500
Line pressure (wheel locked)
Engine idling
AUTOMATIC TRANSAXLE (A140L)
Specifications
Same the A140E automatic transaxle specifications (seepage A±16)
Same the A140E automatic trransaxle specifications (see page A± 17) D range (throttle valve fully open) (Vehicle speed reference)
Rear plane-
tary gearFront
planetary
gear
Differential
gear ratio
Second coast
brake
Overdrive
unitShift
schedule
Forward
clutchkm/h (mph)
Direct
clutchOil pumpL range
3.736
± SERVICE SPECIFICATIONSAutomatic Transaxle (A140L)A±20
Page 2259 of 2389

Line pressure (wheel locked)
Engine idling
At stall
Engine stall revolution
Time lag N range ±
N range ±
Engine idle speed (A/C OFF)
Throttle cable adjustment (Throttle valve fully opened)
Body clearance
Tip clearance
Side clearance
Pump body bushing inside diameter
Stator shaft bushing inside diameter
Front side
Rear side
AUTOMATIC TRANSAXLE (A540E)
Specifications
Between boot end face and inner cable stopper
Throttle valve fully open [Fu lly closed]
Piston stroke
Piston rod lengthThrottle valve opening 5%
Second
coast brake
* O/D switch OFF Shift
schedule
Lock±up
pointkm/h (mph)
Lock±up OFFkm/h (mph)
Lock±up ON NORM
PWR
NORM
PWR
Oil pumpD range
D range2 range
L rangeNORM
NORM
PW RPWR
± SERVICE SPECIFICATIONSAutomatic Transaxle (A540E)A±22
Page 2263 of 2389

Line pressure (wheel locked)
Engine idling
At stall
Engine stall revolution
Time lag
Engine idle speed (A/C OFF)
Throttle cable adjustment (Throttle valve fully opened)
AUTOMATIC TRANSAXLE (A540H)
Specifications
Center differential control pressure (D range)
Throttle valve fully open [Fully closed]
Throttle valve opening 5%
* O/D switch OFF Shift
scheduleEngine R.P.M.
Lock±up
pointSolenoid valve
km/h (mph)
Lock±up OFFkm/h (mph)
Lock±up ONPressure
No. 2 No. 1
± SERVICE SPECIFICATIONSAutomatic Transaxle (A540H)A±26