recommended oil TOYOTA PRIUS 2010 3.G Owners Manual

412
4-2. Maintenance
PRIUS_U (OM47668U) U.S.A.
General maintenance
Engine compartment
Luggage compartment
ItemsCheck points
Brake fluid • At the correct level? (P. 432)
Engine/power control unit coolant • At the correct level? ( P. 430)
Engine oil • At the correct level? (P. 426)
Exhaust system • No fumes or strange sounds?
Radiator/condenser/hoses • Not blocked with foreign matter?

( P. 432)
Washer fluid • At the correct level? (P. 434)
ItemsCheck points
12 volt battery • Maintenance-free ( P. 436)
Listed below are the general maintenance items that should be per-
formed at the intervals specified in the “Scheduled Maintenance
Guide” or “Owner’s Manual Supple ment”. It is recommended that
any problem you notice should be brought to the attention of your
Toyota dealer or qualified service shop for advice.
Listed below are the general maintenance items that should be per-
formed at the intervals specified in the “Owner’s Warranty Informa-
tion”. It is recommended that an y problem you notice should be
brought to the attention of your Toyota dealer or qualified service
shop for advice.

560 6-1. Specifications
PRIUS_U (OM47668U) U.S.A.
Lubrication system■ Engine oil selection
“Toyota Genuine Motor Oil” is used in your Toyota vehicle. Use
Toyota approved “Toyota Genuine Motor Oil” or equivalent to sat-
isfy the following grade and viscosity.
Oil grade: ILSAC multigrade engine oil
Recommended viscosity: SAE 0W-20
SAE 0W-20 is the best choice for
good fuel economy and good
starting in cold weather.
If SAE 0W-20 is not available,
SAE 5W-20 may be used. How-
ever, it must be replaced with
SAE 0W-20 at the next oil
change.
The 0W portion of the oil viscosity rating indicates the characteristic of the
oil which allows cold startability. Oils with a lower value before the W allow
for easier starting of the engine in cold weather.
The 20 in 0W-20 indicates the oil viscosity when the oil is at its operating
temperature. An oil with a higher viscosity may be better suited if the vehi-
cle is operated at high speeds, or under extreme load conditions.
Oil capacity 
Drain and refill 
(reference) With filter
Without filter
4.4 qt. (4.2 L, 3.7 Imp.qt.)
4.1 qt. (3.9 L, 3.4 Imp.qt.)
Outside temperature

579
6-1. Specifications
6
Vehicle specifications
PRIUS_U (OM47668U) U.S.A.
Glossary of tire terminology
Tire related termMeaning
Cold tire inflation 
pressure Tire pressure when the vehicle has been
parked for three hours or more, or has not
been driven more than 1 mile or 1.5 km under
that condition
Maximum inflation
pressure The maximum cold inflated
pressure to which a
tire may be inflated, s hown on the sidewall of
the tire
Recommended 
inflation pressure Cold tire inflation pressure recommended by a
manufacturer.
Accessory weight The combined weight (in excess of those stan-
dard items which may be replaced) of trans-
mission, power steering, power brakes, power
windows, power seats, radio and heater, to the
extent that these items
are available as factory-
installed equipment (whether installed or not)
Curb weight The weight of a motor vehicle with standard
equipment, including the maximum capacity of
fuel, oil and coolant, and if so equipped, air
conditioning and additional weight optional
engine
Maximum loaded 
vehicle weight The sum of:

(a) Curb weight 
(b) Accessory weight 
(c) Vehicle capacity weight 
(d) Production options weight

616
PRIUS_U (OM47668U) U.S.A.
GAS STATION INFORMATION
Auxiliary catch leverP. 420Fuel filler doorP. 104
Fuel filler door opener P. 104Tire inflation pressureP. 565Hood lock release lever
P. 420
Fuel tank capacity11.9 gal. (45 L, 9.9 Imp.gal.)
Fuel typeUnleaded gasoline only P. 105, 568
Cold tire inflation
pressureP. 5 6 5
Engine oil capacity
(Drain and refill)qt. (L, Imp.qt.)
With filter 4.4 (4.2, 3.7) 
Without filter 4.1 (3.9, 3.4)
Engine oil type
“Toyota Genuine Motor Oil” or equivalent
Oil grade: ILSAC multigrade engine oil P. 560
Recommended oil viscosity: SAE 0W-20