check oil TOYOTA TERCEL 1996 Service Owners Manual

BE0044
Ignition
Switch
BatteryWarning Light
BE0146
BE1217
Ignition
Switch
BatteryWarning Light
BE1601
ON OFF
- BODY ELECTRICALCOMBINATION METER
BE-41
1996 TERCEL (RM440U)
If resistance value is not as specified, replace the receiver
gauge.
9. INSPECT LOW OIL PRESSURE WARNING LIGHT
(a) Disconnect the connector from the warning switch and
ground terminal on the wire harness side connector.
(b) Turn the ignition switch ON, and check that the warning
light lights up.
If the warning light does not light up, test the bulb.
10. INSPECT LOW OIL PRESSURE SWITCH CONTINUITY
(a) Disconnect the connector from the switch.
(b) Check that there is continuity between terminal and
ground with the engine stopped.
(c) Check that there is no continuity between terminal and
ground with the engine running.
HINT:
Oil pressure should be over 49 kPa (0.5 kgf/cm
2, 7.1 psi).
If operation is not as specified, replace the switch.
11. INSPECT BRAKE SYSTEM WARNING LIGHT
(a) Disconnect the connectors from the level warning switch
and parking brake switch.
(b) Connect terminals on the wire harness side connector of
the level warning switch connector.
(c) Turn the ignition switch ON, and check that the warning
light lights up.
If the warning light does not light up, test the bulb.
12. INSPECT BRAKE FLUID LEVEL WARNING SWITCH
CONTINUITY
(a) Check that there is no continuity between terminals with
the switch OFF (float up).
(b) Check that there is continuity between terminals with the
switch ON (float down).
If operation is not as specified, replace the switch.

I01390
Condition: Insufficient cooling
I01392
Condition: Insufficient cooling
NOTE : These gauge indica-
tions are shown when the
refrigeration system has
been opened and the refrig-
erant charged without vacu-
um purging.
- AIR CONDITIONINGAIR CONDITIONING SYSTEM
AC-7
1996 TERCEL (RM440U)
(6) Refrigerant overcharged or insufficient cooling of
condenser
Symptom seen in
refrigeration systemProbable causeDiagnosisRemedy
 Pressure too high on both low
and high pressure sides
 No air bubbles seen through the
sight glass even when the engine
rpm is lowered Unable to develop sufficient per-
formance due to excessive refrig-
erant in system
 Insufficient cooling of condenserExcessive refrigerant in
cycle " refrigerant overcharged
 Condenser cooling "condenser
fins clogged of condenser fan
faulty.(1) Clean condenser
(2) If (1) is normal, check amount
of refrigerant
Charge proper amount or refriger-
ant
(7) Air present in refrigeration system
Symptom seen in
refrigeration systemProbable causeDiagnosisRemedy
 Pressure too high on both low
and high pressure sides
 The low pressure piping hot to
the touch
 Bubbles seen in sight glass
Air entered in refrigeration system
 AIr present in refrigeration sys-
tem
 Insufficient vacuum purging
(1) Check compressor oil to see if
it is dirty or insufficient
(2) Evacuate air and charge new
refrigerant

AC2WN-02
- AIR CONDITIONINGCOMPRESSOR
AC-39
1996 TERCEL (RM440U)
INSTALLATION
1. INSTALL COMPRESSOR WITH 4 MOUNTING BOLTS
Torque: 25 N´m (250 kgf´cm, 18 ft´lbf)
2. INSTALL DRIVE BELT (See page AC-20)
3. CONNECT 2 HOSES TO COMPRESSOR SERVICE VALVES
Torque: 10 N´m (100 kgf´cm, 7 ft´lbf)
HINT:
Lubricate 2 new O-rings with compressor oil and install the tubes.
4. CONNECT MAGNETIC CLUTCH LEAD WIRE TO WIRING HARNESS
5. CONNECT NEGATIVE (-) TERMINAL CABLE TO BATTERY
6. EVACUATE AIR FROM REFRIGERATION SYSTEM AND CHARGE SYSTEM WITH REFRIGERANT
Specified amount:
600 ± 50 g (21.73 ± 1.76 oz.)
7. INSPECT FOR LEAKAGE OF REFRIGERANT
Using a gas leak detector, check for leakage of refrigerant.
If there is leakage, check the tightening torque at the joints.
8. INSPECT A/C OPERATION

AC2WO-02
AC-40
- AIR CONDITIONINGMAGNETIC CLUTCH
1192 Author
: Date
:
1996 TERCEL (RM440U)
MAGNETIC CLUTCH
ON-VEHICLE INSPECTION
INSPECT MAGNETIC CLUTCH
(a) Inspect the pressure plate and the rotor for signs of oil.
(b) Check the clutch bearings for noise and grease leakage.
(c) Connect the positive (+) lead from the battery to the termi-
nal on 4 and the negative (-) lead to the body ground.
(d) Check that the magnetic clutch is energized.
If the magnetic clutch is not energized, replace the magnetic
clutch.