engine VOLVO XC70 2013 Quick Guide

PCC*1 Green light: vehicle is locked.
2 Yellow light: vehicle is unlocked.
3 Red light: alarm has been triggered.
4 Alternatively flashing red lights: the alarm
was triggered less than 5 minutes ago.
3. Press the START/STOP
ENGINE button briefly to start
the engine.
1.
Holding the end of the remote key with the base
of the key blade, insert the remote key into the
ignition slot and press it in as far as possible. 2.
Press the brake pedal.
Locks the doors and tailgate and arms
the alarmA.

Unlocks the doors and tailgate, and
disarms the alarmB.
Tailgate: press to unlock the tailgate.
Approach lighting illuminates lights in door
mirrors, cabin, footwells, license plates. Turn
signals and parking lights illuminate.
“Panic” alarm. – Press and hold to sound the alarm.
Turn off alarm with unlock button.
Information about the vehicle can be
gathered within a range of 300 ft.
(10 0 m).
– Press the button and wait for 7 sec -
onds.
If the vehicle is out of range when the
button is pressed, the most recently
stored status information will be shown.
A The accessory inclination and movement alarm sensors can be turned off. See the “Alarm” section of your owner’s
manual for information.
B Automatic relock occurs if no door/tailgate is opened within
2 minutes after unlock.
REMOTE KEY WITH PCC* – PERSONAl CAR COMMuNICATOR
STARTING THE ENGINE
COLDSTART
NOTE
After cold starts, your engine will idle at a
higher speed for a short time to bring the
engine to normal operating temperature as
quickly as possible, enabling the emission
control system to function optimally.

KEYlESS dRIvE*
On keyless drive vehicles, it is only necessary to
have a remote key in your possession to operate the
central locking system and start the engine.
lOCKING ANd ARMING THE AlARM
– Press the button on any of the outside door
handles. The lock indicator light on the dashboard
will start to flash.
uNlOCKING ANd dISARMING THE AlARM
– Pull a door handle to unlock and open the door.STARTING THE ENGINE
– With a remote key in the passenger’s compart-
ment, depress the brake pedal.
– Press and release the START/STOP ENGINE
button. The autostart function will operate the starter
motor until the engine starts.
SWITCHING OFF THE ENGINE
– Press briefly on the START/STOP ENGINE button.
1.
Park the vehicle and press
the START/STOP ENGINE

button to switch off the
engine.
2. Pull the remote key out of the ignition slot.
If the BLIS indicator lights illuminate even when there
are no vehicles in the blind area, this may be due to
light reflected from a wet road surface, the vehicle’s
own shadow against a large, light, smooth surface,
or sunlight directly in the camera when the sun is low
on the horizon.
If there is a fault with the system, Blind spot syst.
Service required will be displayed.
SWITCHING OFF THE ENGINE ANd RE-
MOvING THE REMOTE KEY BlINd SPOT INFORMATION
SYSTEM (BlIS)*
IGNITION MOdES
To access ignition modes I or II without starting the engine, the brake pedal must not be depressed.
0
Vehicle unlocked.
I Remote key fully pressed into the ignition slot: press START/STOP ENGINE briefly.
II Remote key fully pressed into slot: press START/STOP ENGINE for approx. 2 seconds. Mode II should
only be used for very short periods to help avoid draining the battery.
See also the table in the section “Ignition modes” in your owner’\
s manual for information about which components/
systems can be used in the various ignition modes.
To return to mode
0 from mode II or I, press START/STOP ENGINE briefly.

ElECTRONIC ClIMATE CONTROl—ECC
AUTOMATIC CONTROL
In AuTO mode, ECC controls all functions
automatically and makes driving more pleasant
with optimal air quality.
1 Turn the control to the desired temperature
on the left/right sides of the cabin. The set
temperature is shown in the display.
8 Press to automatically control the tempera-
ture and other functions.
The 12-volt sockets in the cabin function in ignition
modes I or II.
The 12-volt socket* in the cargo area always func -
tions.
AuX/uSB can be used to connect e.g., an mp3
player to the vehicle’s infotainment system.
STORAGE SPACES, 12-vOl T SOCKETS & AuX/uSB CONNECTOR
CA
uTIONUsing the optional 12-volt socket in the cargo
area with the engine switched off will drain the
battery.
MANUAL CONTROL
2 Heated driver/front passenger seat*.
3 Max. defroster. Directs maximum air flow to the
windshield and front side windows.
4 Blower speed.
5 Air distribution.
6 Heated rear window and door mirrors.
7 Recirculation.
9 Air conditioning Off/On to cool the cabin and
defog the windows.