checking oil YAMAHA BLASTER 200 2002 Owners Manual

LOCATION OF THE WARNING AND
SPECIFICATION LABELS .......................1-1
SAFETY INFORMATION .........................2-1
DESCRIPTION AND MACHINE
IDENTIFICATION.....................................3-1
Identification number records ...............3-3
Key identification number .....................3-5
Vehicle identification number ...............3-7
Model label ...........................................3-9
CONTROL FUNCTIONS..........................4-1
Main switch ...........................................4-1
Indicator and warning lights ..................4-3
Oil level warning light “OIL” ..................4-3
Oil level warning light checking
method ...............................................4-5
Handlebar switches ..............................4-9Throttle lever ......................................4-11
Throttle Override System ...................4-13
Speed limiter ......................................4-15
Clutch lever ........................................4-17
Front brake lever ................................4-17
Rear brake pedal ................................4-19
Parking brake .....................................4-19
Shift pedal ..........................................4-23
Kick starter .........................................4-23
Fuel tank cap ......................................4-25
Fuel cock ............................................4-25
Starter (choke) ....................................4-27
Seat ....................................................4-29
Front shock absorber adjustment .......4-31
Rear shock absorber adjustment .......4-33
PRE-OPERATION CHECKS ...................5-1
Front and rear brakes ...........................5-5
Fuel ......................................................5-9
EBU00015
CONTENTS
1
2
3
4
5
5KJ-62 (0~3 shou) 4/23/01 3:03 PM Page 12

4-5
EBU00757
Oil level warning light checking method
Start the engine.
Wait a few seconds.
Engine oil level and
electrical circuit are OK.Supply engine oil.
Oil level warning light
does not come on
(see NOTE).
Ask a Yamaha dealer to
inspect the electrical circuit.
NOTE:
If the main switch is turned off after the oil level
warning light goes off and the engine is immedi-
ately started again, the oil level warning light
may not come on. This does not indicate a cir-
cuit failure.
Turn the main switch to
“ON” and the engine
stop switch to“RUN”.
Oil level warning
light comes on.
The oil level warning
light stays on.The oil level warning light
goes off.
5KJ-62 (4~5 shou) 4/23/01 3:04 PM Page 6

8-13
EBU00837
Transmission oil
Transmission oil measurement
1. Place the machine on a level place.
2. Warm up the engine for several minutes,
and stop it.
3. Check the oil level through the level window
located at the right side crankcase cover.
NOTE:
Wait a few minutes until the oil level settles
before checking.
4. The oil level should be between the maxi-
mum and minimum marks. If the level is low,
add oil to raise it to the proper level.
q
qw
e
1. Level window
2. Maximum level mark 3. Minimum level mark
1. Regard
2. Repère de niveau maximum 3. Repère de niveauminimum
1. Mirilla
2. Marca de máximo 3. Marca de mínimo
5KJ-62 (8 shou) 4/23/01 3:08 PM Page 14