headlight bulb YAMAHA BREEZE 2002 Owners Manual

Spark plug inspection .........................8-21
Air filter cleaning .................................8-25
Carburetor settings .............................8-33
Idle speed adjustment ........................8-45
Throttle lever adjustment ....................8-47
Front brake shoe inspection ...............8-49
Rear brake pad inspection .................8-49
Front brake lever free play
adjustment ........................................8-51
Parking brake adjustment ...................8-55
Adjusting the rear brake light switch ...8-57
Clutch adjustment ...............................8-59
Autolube pump adjustment .................8-59
Drive chain slack check ......................8-61
Drive chain slack adjustment ..............8-63
Lubricating the drive chain .................8-65
Cable inspection and lubrication ........8-69
Brake and shift pedal/brake and
clutch lever lubrication ......................8-71
Upper arm and lower arm pivot
lubrication .........................................8-71Steering shaft lubrication ....................8-73
Wheel removal ...................................8-73
Wheel installation ...............................8-73
Replacing the headlight bulb ..............8-75
Headlight beam adjustment ................8-79
Tail/brake light bulb replacement .......8-81
Troubleshooting ..................................8-83
Troubleshooting chart .........................8-87
CLEANING AND STORAGE....................9-1
A. Cleaning ...........................................9-1
B. Storage ............................................9-7
SPECIFICATIONS .................................10-1
HOW TO USE THE CONVERSION
TABLE ....................................................11-1
9
10
11
5KJ-62 (0~3 shou) 4/23/01 3:03 PM Page 14

8-75
EBU00646
Replacing the headlight bulb
If the headlight bulb burns out, replace the bulb
as follows:
1. Remove the screws holding the headlight
unit assembly to the headlight body.
q
1. Screw (×2)1. Vis (×2)1. Tornillo (×2)
5KJ-62 (8 shou) 4/23/01 3:08 PM Page 76

8-77
2. Remove the bulb holder cover, turn the bulb
holder counterclockwise and remove the
defective bulb.
w
The headlight bulb is hot when it is on and
immediately after it is turned off. Wait for the
bulb to cool before touching or removing it.
You can be burned, or a fire could start if the
bulb touches something flammable.
3. Put a new bulb into position and secure it in
place with the bulb holder.
4. Install the bulb holder cover.
cC
Make sure the bulb holder cover is securely
fitted over the bulb holder and seated
against the reflector.
5. Install the headlight unit assembly.
Adjust the headlight beam if necessary.
5KJ-62 (8 shou) 4/23/01 3:08 PM Page 78

10-5
Model YFS200
Suspension:
Front suspension Double wishbone
Rear suspension Swingarm (monocross)
Shock absorber:
Front shock absorber Coil spring/Oil damper
Rear shock absorber Coil spring/Gas-oil damper
Wheel travel:
Front wheel travel 180 mm
Rear wheel travel 180 mm
Electrical:
Ignition system C.D.I.
Generator system C.D.I. magneto
Headlight type: Bulb type
Bulb voltage, wattage ×quantity:
Headlight 12V, 45 W/45 W ×1
Tail/brake light 12V, 5/21 W ×1
Indicator light:
Oil level 12V, 3.4 W ×1
5KJ-62 (9 shou ~) 4/23/01 3:09 PM Page 16