height adjustment YAMAHA TTR50 2006 Owners Manual

4 - 8
ENGCARBURETOR
Float height
1. Measure:Float height a
Out of specification → Adjust.
Float height:
18.5 mm (0.73 in)
Measurement and adjustment steps:
 Hold the carburetor in an upside down
position.
NOTE:
Slowly tilt the carburetor in the opposite
direction, then take the measurement
when the needle valve aligns with the float
arm.
 If the carburetor is level, the weight of the
float will push in the needle valve, resulting
in an incorrect measurement.
 Measure the distance between the mating
surface of the float chamber and top of the
float using a vernier calipers.
NOTE:
The float arm should be resting on the nee-
dle valve, but not compressing the needle
valve.
If the float height is not within specification,
inspect the valve seat and needle valve.
 If either is worn, replace them both.
 If both are fine, adjust the float height by
bending the float tab b on the float.
 Recheck the float height.
a
b
EC464600
Float
1. Inspect:
Float 1
Damage → Replace.
1