fuel pump CHRYSLER 200 2012 1.G Warranty Booklet

•All-Wheel Drive (AWD)(If equipped)- Power transfer unit and all internal parts; driveshaft and
axle shaft assemblies; constant velocity joints and boots; axle housing and all internal parts;
differential carrier assembly and all internal parts; output ball bearing; output flange; end cover;
viscous converter clutch; overrunning clutch; vacuum motor; torque tube; pinion spacer and shim;
seals and gaskets for these parts only.
5/100 DIESEL ENGINE WARRANTY
(IF EQUIPPED)
The diesel engine parts are covered for5 years or 100,000 kilometres,whichever occurs first.
•Diesel Engine- Cylinder block and all internal parts; cylinder head assemblies; core plugs; fuel
injection pump and injectors; intake and exhaust manifolds; oil pan; oil pump; timing gear drive
belts and/or chains and cover; turbocharger housing and internal parts; valve covers; water pump
and housing; seals and gaskets for listed components.
8/160 HYBRID SYSTEM WARRANTY
(IF EQUIPPED)
These hybrid system parts are covered for8 years or 160,000 kilometres,whichever occurs first.
•TPIM Fan
•TPIM Pump
•TPIM Assembly
•Transmission and all internal components•APM Assembly
•HV AC Cables
•HV DC cables
•Hybrid Battery
CORROSION WARRANTY
For 3 years, regardless of distance driven,your Corrosion Warranty covers any body sheet metal
panel which develops a hole caused by corrosion.
In addition, outer body panels are covered against holes caused by corrosion up to5 years or 160,000
kilometres,whichever occurs first. An outer body panel is a sheet metal panel which can be seen
while walking around the vehicle, and which is painted body colour.
This warranty applies only to holes caused by corrosion. Cosmetic or surface corrosion (resulting
from stone chips or scratches in the paint, for example) will not be repaired under this warranty.
If corrosion damage is obviously neglected and allowed to worsen until a hole develops, this warranty
will not cover the repair.
EMISSION WARRANTIES
Chrysler Canada warrants that your new vehicle was designed, built and equipped to conform at the
time of sale with applicable federal and provincial emissions standards, and that the vehicle is, at the
time of sale, free from defects in material and workmanship which would cause it to fail to conform
to the applicable emission standards within the warranty periods specified. A covered defect is one
which causes your vehicle to fail to meet applicable emission control regulations.
To keep your vehicle operating properly and in conformance with emission regulations, see the
Scheduled Maintenanceinstructions in your Owner’s Manual and herein. Only Chrysler parts
should be used for maintenance and repair of your vehicle’s emission control systems.
You should keep any receipts for maintenance service and pass them on to the next owner of your
vehicle, in case questions arise concerning maintenance. Chrysler Canada has the right to deny
warranty coverage if your vehicle has not been properly maintained, or if repairs are needed because
parts other than Chrysler parts were used; however, denial will not be based on the lack of
maintenance records alone.
Warranty service must be performed by an authorized Chrysler or Dodge Retailer.
If emergency warranty service is required and an authorized retailer is not available, contact Chrysler
Canada Customer Assistance (page 9) and request emission warranty service help.
5