oil pressure TOYOTA LAND CRUISER 1998 Factory Workshop Manual

F17279
Pressure Port Union
69 (700, 51)

O-Ring
Flow Control Valve
Spring

O-Ring Suction Port Union
12 (120, 9)
Vane Pump with Shaft
Vane Pump Pulley

Oil SealFront Housing

Gasket
22 (225, 16)
Rear Housing

O-Ring
Side Plate
Cam Ring
Vane Pump
Rotor

Snap Ring x10Vane Plate
N´m (kgf´cm, ft´lbf): Specified torque

Non-reusable part
Power steering fluid
- STEERINGPOWER STEERING VANE PUMP
SR-39
2248 Author
: Date
:
2004 LAND CRUISER (RM1071U)

SA1DA-04
F05258
RH Case:LH Case:
X
X
F05259
SST
Y SA-150
- SUSPENSION AND AXLEREAR DIFFERENTIAL CARRIER (w/ LSD)
2100 Author
: Date
:
2004 LAND CRUISER (RM1071U)
REASSEMBLY
HINT:

When reusing the side gear, thrust washers and clutch
plates, skip the STEP 1.

Using a shop rag, clean off any foreign object from the
parts.

Apply all of the sliding and rotating surfaces with LSD oil.
1. SELECT ADJUSTING SHIM
(a) Measure the RH and LH differential case dimensions ºXº,
as shown in the illustration.
(b) Install the thrust washers and clutch plates on the side
gear.
(c) Using SST to press down the thrust washers and clutch
plates with about pressure of 10 kgf (22 lbf), measure di-
mension ºYº, as shown in the illustration.
SST 09649-17010
(d) Referring to the following selection table on the next
page, select the proper adjusting shim.
Adjust shim thickness =
X - Y - 19.08 mm (0.7511 in.)