vent ACURA CSX 2006 Service Repair Manual

Î
ÎÎ
Î
Checking and Adjusting the Headliner/Pillar
Trim Overlap
24-187
A
B
EDGE OF HEADLINER
LESS THAN
15 mm (0.6 in.)
MASKING TAPE
To prevent the side curtain airbag from deploying and
damaging the pillar trim, the overlap between the
headliner and pillar trim must be less then 15 mm
(0.6 in.). To check the overlap, do this:
1. Install the headliner (A) and the pillar trims (B).
2. Apply masking tape to the headliner to mark the upper edge of each p illar trim. 3. Remove the pillar trim, and measure the headliner
overlap.
 If the overlap is less than 15 mm (0.6 in.), remove the tape, and install the pillar trim.
 If the overlap is more than 15 mm (0.6 in.), go to step 4.
4. Carefully trim the headliner with a utility knife, reducing the overlap to less than 15 mm (0.6 in.).
5. Remove the tape, and install the pillar trim.
This illustration shows the A-pillar.
This illustration shows the A-pillar. This illustration shows the A-pillar.
This illustration shows the A-pillar.
08/08/21 14:01:54 61SNR030_240_0187
ProCarManuals.com
DYNOMITE -2009-


Î
(#'
 )
Removal Installation
24-191
Side Airbag Replacement
AB
A
B
6.3 N·m
(0.64 kgf·m, 4.65 lbf·ft)
NOTE: If replacing the side airbag after deployment,
refer to Component Replacement/Inspection After
Deployment (see page 24-185) for a complete list of
other parts that must also be replaced. 1. Do the battery terminal disconnection procedure (see page 22-68), then wait at least 3 minutes
before starting work.
2. Remove the seat assembly (see page 20-118) and seat-back cover (see page 20-123).
3. Remove the mounting screws (A) and the side airbag (B). NOTE:
 If the side airbag lid is secured by tape, remove the tape.
 Do not open the lid of the side airbag cover.
 Use new mounting screws tightened to the specified torque. When you replace a side airbag, make sure
that the seat-back cover is installed properly.
Improper installation may prevent proper
deployment.
 Be sure to install the harness wires so that they are not pinched or interfering with other parts.
1. Place the side airbag on the seat-back frame (A). Install new side airbag mounting screws (B).
2. Install the seat-back cover in the reverse order of removal (see page 20-123).
3. Install the seat assembly (see page 20-118).
4. Move the front seat and the seat-back through their full ranges of movement, making sure the harness
wires are not pinched or interfering with other parts.
5. Do the battery terminal reconnection procedure (see page 22-68).
6. Clear any DTCs (see page 24-23).
7. After installing the side airbag, confirm proper system operation: Turn the ignition switch to ON
(II); the SRS indicator should come on for about
6 seconds and then go off.
Replace.
08/08/21 14:01:56 61SNR030_240_0191
ProCarManuals.com
DYNOMITE -2009-