TPMS ACURA CSX 2006 Service Manual PDF

Î
(#' .

)
µ
µ
µ
µ µ
µ
µ
µ
DTC B1173:
YES
NO
YES
NO YES
NO
YES
NO
22-266Gauges
DTC Troubleshooting (cont’d)
GAUGE CONTROL MODULE (TACH) 36P CONNECTOR
CAN H (WHT)
CAN L (RED)
TPMS CONTROL UNIT 20P CONNECTOR
Gauge Control Module Lost
Communication with the TPMS Control Unit
(TPMS Message) (’08-09 models)
NOTE: If you are troubleshooting multiple DTCs, be
sure to follow the instructions in B-CAN System
Diagnosis Test Mode A (see page 22-93).
1. Clear the DTCs with the HDS.
2. Turn the ignition switch to LOCK (0) and then back to ON (II).
3. Check for the DTCs with the HDS.
Go to step 4.
Intermittent failure, the F-CAN
communication line is OK at this time. Check for
loose or poor connections. If the connections are
good, check the battery condition (see page 22-67),
and the charging system.
4. Check for DTCs in the TPMS.
Troubleshoot the TPMS DTCs with the
HDS.
Go to step 5.
5. Turn the ignition switch to LOCK (0).
6. Disconnect the gauge control module (tach) 36P connector.
7. Disconnect the TPMS control unit 20P connector. 8. Check for continuity between gauge control
module (tach) 36P connector terminals No. 1 and
No. 19 and TPMS control unit 20P connector
terminals No. 2 and No. 11 respectively.
Go to step 9.
Repair an open in the wire between the gauge
control module and the TPMS control unit.
9. Check for poor connections, power, and ground to the TPMS control unit. If OK, substitute a known-
good TPMS control unit.
10. Check for DTCs with the HDS.
Replace the gauge control module (tach)
(see page 22-277).
Replace the original TPMS control unit.
Wire side of female terminals
Wire side of female terminals
I s DT C B117 3 i nd i cat ed ?
Are any DTCs indicated? Is there continuity?
I s DT C B117 3 i nd i cat ed ?
08/08/21 14:35:19 61SNR030_220_0268
ProCarManuals.com
DYNOMITE -2009-

Î
(#'

)
µµ
µ
22-282 Reminder Systems
Circuit Diagram


MICU







 ORN
(10 A) No. 23
BLK1 2
SRS UNIT
G602
B11
A12
A11 YEL
WHT REDRED
WHT
ORN28
LT GRN BLK16
G504
INDICATOR DRIVE CIRCUIT
MICU
  ECM/PCM MAIN CIRCUIT
21
PNK
124
CAN L
CAN H


 CHIME
WHT
BRN
RED 19
1
WHT No. 2 (IG) (50 A)
GAUGE CONTROL MODULE (TACH) 18
17
IG1
BAT
BLU
WHT
UNDER-HOOD FUSE/RELAY BOX
BATTERY IGNITION SWITCH
No. 1 (BAT) (100 A)
(7.5 A) No. 10UNDER-DASH
FUSE/RELAY
BOX
DRIVE
CIRCUIT
PARKING
BRAKE
REMINDER
SEAT
BELT
REMINDER
KEY-IN
REMINDER
F-CAN
TRANSCEIVER B-CAN
TRANSCEIVERLIGHTS-ON
INDICATOR
(LED)
IG1 HOT in ON (II)
and START (III)
ABS MODULATOR-
CONTROL UNIT*1 LIGHTS-ON INDICATOR
DIMMING CIRCUIT
PARKING
BRAKE
SWITCH
(Closed:
Lever pulled)
DRIVER’S
SEAT BELT
BUCKLE
SWITCH
(Closed:
unbuckled) SEAT BELT
REMINDER
INDICATOR
(LED)
BRAKE
SYSTEM
INDICATOR
(LED)COMPULSORY
TURNING-ON
CIRCUIT
LIGHTS-ON
REMINDER
CLIMATE
CONTROL
UNIT
IMMOBILIZER-
KEYLESS
CONTROL UNIT
HANDSFREELINK
CONTROL UNIT*4
H1
D4 D2
Q1 Q9
G2 :CANline
1
VSA MODULATOR-
CONTROL UNIT*2
YAW RATE-LATERAL
ACCELERATION SENSOR*2
DATA LINK CONNECTOR
EPS CONTROL UNIT
TPMS CONTROL UNIT*3 10 V
STABILIZING
CIRCUIT
*1: ’06 07 Touring and Premium models
*2: ’07 TYPE S and ’08 09 models
*3: ’08 09 models
*4: ’09 model with navigation system
MICU
A
B
08/08/21 14:36:02 61SNR030_220_0284
ProCarManuals.com
DYNOMITE -2009-