Car won’t start ACURA CSX 2006 Service Repair Manual

µ
 
(#' 
)
Intermittent Failures
Service Information
Opens and Shorts
How to Use the HDS (Honda Diagnostic
System)
If the MIL (malfunction indicator lamp) has come on If the MIL did not stay on
If you can’t duplicate the DTC
11-3
General Troubleshooting Information
A
A
The term intermittent failure means a system may have
had a failure, but it checks OK now. If the malfunction
indicator lamp (MIL) on the dash does not come on,
check for poor connections or loose terminals at all
connectors related to the circuit that you are
troubleshooting. If the MIL was on but then went out,
the original problem may have been intermittent.
Periodically, new ECM/PCM software or new service
procedures may become available. Always check
online for the latest software or service information
relatedtotheDTCsorsymptomsyouare
troubleshooting.
Open and short are common electrical terms. An open
is a break in a wire or at a connection. A short is an
accidental connection of a wire to ground or to another
wire. In simple electronics, this usually means
something won’t work at all. With complex electronics
(such as ECMs or PCMs) this can sometimes mean
something works, but not the way it’s supposed to.1. Start the engine, and check the MIL (A). NOTE: If the ignition switch is turned to ON (II), and
the engine is not started, the MIL stays on for
15 20 seconds (see page 11-69). 2. If the MIL stays on, connect the HDS to the data link
connector (DLC) (A) located under the driver’s side
of the dashboard.
3. Turn the ignition switch to ON (II).
4. Make sure the HDS communicates with the ECM/ PCM and other vehicle systems. If it doesn’t, go to
the DLC circuit troubleshooting (see page 11-204).
5. Check the diagnostic trouble code (DTC) and note it. Also check the freeze data and/or on-board
snapshot data, and download any data found. Then
refer to the indicated DTC’s troubleshooting, and
begin the appropriate troubleshooting procedure.
NOTE: Freeze data indicates the engine conditions when the first malfunction, misfire, or fuel trim
malfunction that activated the MIL was detected.
 The HDS can read the DTC, freeze data, on-board snapshot, current data, and other engine control
module (ECM) or powertrain control module
(PCM) data.
 For specific operations, refer to the user’s manual that came with the HDS.
6. If no DTCs are found, go to MIL troubleshooting (see page 11-203).
If the MIL did not stay on but there is a driveability
problem, do the symptom troubleshooting.
Some of the troubleshooting requires you to reset the
ECM/PCM and try to duplicate the DTC. If the problem is
intermittent and you can’t duplicate the code, do not
continue through the procedure. To do so will only
result in confusion and possibly, a needlessly replaced
ECM/PCM. (cont’d)
08/08/21 14:12:32 61SNR030_110_0003
ProCarManuals.com
DYNOMITE -2009-