light Acura Integra 2000 Hatchback User Guide

Contro
l Location s

DOO R LOC K SWITCHES /
HATC H LOC K SWITC H
(P . 75 )
POWE R WINDO W
SWITCHE S

(P .
84 )
FUE L FIL L
DOO R RELEAS E
(P . 124 )
HEATING/COOLIN
G
CONTROL S

(P . 94 )

AUDI O SYSTE M

(P .
102 )

SHIF T LEVE R
(P . 138 , 140 )
HOO D RELEAS E HANDL E
(P . 125 ) PARKIN
G BRAK E
(P . 87 )

Instrument s an d Control s
MIRRO
R CONTROL S
(P . 86 ) DIGITA
L CLOC K
(P . 88 )
INDICATO R LIGHT S (P . 53 )
GAUGE S (P . 58 )

Indicato
r Light s
The instrument panel has many indicators to give you important
information about your car.
* The U.S. instrument panel is shown. Differences for Canadian models are
noted in the text.

Instruments an d Control s

CHARGIN
G SYSTEM
INDICATO R
LO W OI L PRESSUR E INDICATO R
MALFUNCTIO N
INDICATO R LAM P HIG
H BEA M INDICATO R
PARKIN G BRAK E AN D
BRAK E SYSTE M INDICATOR *
DOOR-OPE N
INDICATO R
ANTI-LOC K BRAK E
SYSTE M INDICATOR *
SUPPLEMENTA L
RESTRAIN T
SYSTE M
INDICATO R
LO W FUE L INDICATO R
SEA
T BEL T
REMINDE R LIGH T
HATCH-OPE
N
INDICATO R
CRUIS
E CONTRO L
INDICATO R

MAINTENANC E
REQUIRE D INDICATO R

IMMOBILIZE R SYSTE M INDICATO R

Indicato
r Light s
Sea t Bel t Reminde r Ligh t
This indicator lights when you turn the ignition switch ON (II). It is areminder to you and your passengers
to protect yourselves by fastening
the seat belts. A beeper also soundsif you have not fastened your seat
belt.
If you do not fasten your seat belt,
the beeper will stop after a fewseconds but the light stays on until
you do. Both the light and the beeper stay off if you fasten your seat belt
before turning on the ignition. Lo
w Fue l Indicato r
This light comes on as a reminder that you must refuel soon. Parkin
g Brak e
an d Brak e

Syste m

Indicato r
This light has two functions:
1. It lights as a reminder that youhave not released the parking
brake. Driving with the parking
brake applied can damage the
brakes and tires.
2. If it remains lit after you release
the parking brake while the engine is running, or comes on while
driving, it can indicate a problem
in the brake system. For complete
information, see page 238.
Instrument s an d Control s Malfunction
Indicator
Lam p

See page 237.
Canad
a

U.S .

BRAK E

Indicato
r Light s
Supplementa l Restrain t
Syste m Indicato r
This indicator lights when you turn the ignition switch ON (II). If itcomes on at any other time, it
indicates a problem in the supplemental restraint system. For
complete information, see page 47. Chargin
g Syste m
Indicato r
If this light comes on when the
engine is running, the battery is not
being charged. For complete
information, see page 236.
Low Oi l Pressur e
Indicato r
The engine can be severely damaged if this light flashes or stays on when
the engine is running. For complete
information, see page 235.
Anti-loc
k Brak e
Syste m (ABS )
Indicato r

Only on models equipped with ABS (see
page 146)
This light normally comes on for a few seconds when you turn theignition switch ON (II), and when
the ignition switch is turned to START (III).
If this light comes on at any other
time, there is a problem in the ABS. If this happens, take the car to your
dealer to have it checked. With the
light on, your car still has normal
braking ability but no anti-lock. For complete information, see page 146.

Instrument s an d Control s

S

R
S


U.S
.

Canad a

A
B S

Indicato
r Light s
Turn Signa l an d
Hazar d Warnin g
Indicator s
The left or right turn signal light blinks when you signal a lane changeor turn. If the light does not blink or
blinks rapidly, it usually means one of the turn signal bulbs is burned out (see page 208). Replace the bulb as
soon as possible, since other drivers
cannot see that you are signalling.
When you turn on the Hazard
Warning switch, both turn signal lights blink. All turn signals on theoutside of the car should flash.
Cruis e Contro l Indicato r

Only on models equipped with Cruise

Control System

This lights when you set the cruise control. See page 67 for information
on operating the cruise control. Hatch-ope
n Indicato r
This light comes on if the hatch is not closed tightly.
Door-ope n Indicato r
This light comes on if either door is not closed tightly.
Instrument s an d Control s
CRUIS
E

CONTRO L

Indicato
r Light s
Hig h Bea m Indicato r
This light comes on with the high beam headlights. See page 62 forinformation on the headlight
controls.
On Canadian models, this indicator
comes on with reduced brightness
when the Daytime Running Lights (DRL) are on (see page 62). Immobilize
r Syste m
Indicato r
This indicator comes on for a few seconds when you turn the ignition
switch ON (II). It will then go off if
you have inserted a properly-coded ignition key. If it is not a properly-coded key, the indicator will blink
and the engine will not start (see
page 70 ).
This indicator also blinks several times when you turn the ignitionswitch from ON (II) to ACCESSORY (I) or LOCK (0).
Instruments an d Control s

Gauge
s

Fue l Gaug e
This shows how much fuel you have. It is most accurate when the car is on
level ground. It may show slightly
more or less than the actual amount
when you are driving on curvy or hilly roads. The gauge stays at the same fuel
level reading after you turn off theignition. When you add fuel, the
gauge slowly changes to the new
reading after you turn the ignitionswitch back ON (II).
Temperatur e Gaug e
This shows the temperature of the engine's coolant. During normal
operation, the pointer should rise
from the bottom white mark to about
the middle of the gauge. In severe driving conditions, such as very hot
weather or a long period of uphill driving, the pointer may rise to near
the upper white mark. If it reaches
the red (Hot) mark, pull safely to the side of the road. Turn to page 233 for
instructions and precautions on
checking the engine's cooling
system.

Instrument s an d Control s

TEMPERATUR
E

GAUG E
TACHOMETE
R


SPEEDOMETE R

FUEL GAUG
E

TRI P METE R
ODOMETE R
TRI
P METE R

RESE T BUTTO N

Gauge
s

Maintenanc e Require d Indicato r
This indicator reminds you that it is time to take your car in for
scheduled maintenance.

Refer to the Maintenance Schedules
for Normal and Severe Driving Conditions on pages 162 — 166 .
For the first 6,000 miles (9,600 km) after the Maintenance Required
Indicator is reset, it will come on for
two seconds when you turn the ignition switch ON (II). Between 6,000 miles (9,600 km) and
7,500 miles (12,000 km) this
indicator will light for two seconds
when you first turn the ignition switch ON (II), and then flash for
ten seconds.
If you exceed 7,500 miles (12,000
km) without having the scheduled
maintenance performed, this
indicator will remain on as a constant
reminder.
Your dealer will reset this indicatorafter completing the scheduled
maintenance. If this maintenance is done by someone other than your
Acura dealer, reset the indicator by pressing the reset button. This
button is located on the bottom of
the dashboard to the right of the
steering column.

Instrument s an d Control s

MAIN
T

REQ D

Control
s Nea r th e Steerin g Whee l
The two levers on the steering column contain controls for driving
features you use most often. The left lever controls the turn signals,
headlights, and high beams. The
right lever controls the windshield
washers and wipers.
The controls on the dashboard to the right of the steering column are for
the instrument panel brightness,
hazard warning lights and rear
window defogger.
The moonroof switch and cruise control switch are to the left of the
steering column.
The tilt adjustment lever on the underside of the steering columnallows you to tilt the steering wheel.

Instruments an d Control s
WINDSHIEL
D

WIPERS/WASHER S

HOR
N
BUTTON S

TIL T ADJUSTMEN T

HEADLIGHTS /

TUR N SIGNAL S
MOONROO
F
HAZAR
D WARNIN G
LIGHT S REA
R WINDO W

DEFOGGE R

INSTRUMEN
T PANE L

BRIGHTNES S

CRUIS
E
CONTRO L

Control
s Nea r th e Steerin g Whee l
Headlight s
The rotating switch on the left lever controls the lights. Turning this switch to the position turns
on the parking lights, taillights,
instrument panel lights, side-marker
lights, and rear license plate lights. Turning the switch to the
position turns on the headlights. If you leave the lights on with the
ignition switch in ACCESSORY (I)

or LOCK (0), you will hear a
reminder beeper when you open the driver's door.
To change between low beams and high beams, pull the turn signal leveruntil you hear a click, then let go.
The blue high beam indicator will light (see page 57). To flash the high beams, pull the
turn signal lever back lightly, thenrelease it. The high beams will come
on and go off.
The high beams will stay on for as long as you hold the lever back, no
matter what position the headlightswitch is in.
Daytim e Runnin g Light s
(Canadia n Models )
With the headlight switch off, the high beam headlights come on with reduced brightness when you turn
the ignition switch to ON (II) and
release the parking brake. They
remain on until you turn the ignition off, even if you set the parking brake.
The headlights revert to normal operation when you turn them on
with the switch.

Instrument s an d Control s