display ACURA INTEGRA 2024 Owners Manual

uuWhen Driving uShifting
446
Driving
Use the paddle shifters to change betw een 1st and 7th speeds without releasing
your hands from the steering wheel. The transmission switches to the 7-speed
manual shift mode when you pull a paddle shi fter while driving. This mode is useful
when engine braking is needed.
■When the transmi ssion is in (D:
The shift mode goes into the 7-speed ma nual shift mode temporarily, and the
number is displayed in the shift indicator.
The 7-speed manual shift mode is canceled automatically if you drive at constant
speed or accelerate, and the number in the shift indicator goes off.
You can cancel this mode by pulling the
(+ paddle shifter for a few seconds.
The 7-speed manual shift mode is especially useful when reducing the vehicle speed
temporarily before making a turn.
■When the transmi ssion is in (S:
The shift mode goes into the 7- speed manual shift mode. The M indicator and the
speed number are displayed in the shift indicator. As the vehicle speed slows down,
the transmission automatically shifts down accordingly. When the vehicle comes to
a stop, it automatically shifts down into 1st.
If the vehicle speed increases and the engi ne speed reaches near the tachometer red
zone, the transmission au tomatically shifts up.
You can only pull away in 1st speed.
When canceling the 7-speed manual shi ft mode, move the shift position from
(S to
(D or pull the (+ paddle shifter for a few seconds. When the 7-speed manual shift
mode is canceled, the M indicator and shift in dicator will turn off.
■7-Speed Manual Shift Mode17-Speed Manual Shift Mode
In the 7-speed manual shif t mode, the transmission
shifts up or down by operating either paddle shifter
under the following conditions:
Shift Up; The engine sp eed reaches the lowest
threshold of the hi gher speed position.
Shift Down; The engine sp eed reaches the highest
threshold of the lower speed position.
When the engine speed reaches near the tachometer
red zone, the transmission shifts up automatically.
When the engine speed reaches the lowest threshold
of the selected speed positi on, the transmission shifts
down automatically.
Operating the paddle shifters on slippery surfaces
may cause the tires to lock up. In this case, the 7-
speed manual shift mode is canceled and goes back
to the normal
( D driving mode.
24 ACURA INTEGRA-313S56100.book 446 ページ ２０２３年２月１３日　月曜日　午後２時４１分

455
uuWhen Driving uAcura Integrated Dynamics System
Continued
Driving
■Selecting the Dynamic Mode
INDIVIDUAL Setting screen
2 P. 460 SPORT
Mode
NORMAL Mode
COMFORT Mode
Changing modes by
Dynamic Mode
switch
or INDIVIDUAL button
alters the screen on
the driver information
interface. Audio/Information Screen
INDIVIDUAL Mode
Press and hold the INDIVIDUAL
button or select Customize
2 Customized Features P. 367
Press the or button on the
audio/information screen.
2
Audio System Basic Operation
P. 267
Dynamic Mode
Switch
Press the INDIVIDUAL button
Press the Dynamic Mode switch
up or down
INDIVIDUAL
Button
*1: The display returns to audio/information
screen a few seconds after pressing the
Dynamic Mode switch or INDIVIDUAL button.
*1
*1
1.5 L engine models
24 ACURA INTEGRA-313S56100.book 455 ページ ２０２３年２月１３日　月曜日　午後２時４１分

456
uuWhen Driving uAcura Integrated Dynamics System
Driving
INDIVIDUAL Setting screen
2 P. 460 SPORT+
Mode
SPORT Mode
COMFORT Mode
Changing modes by
Dynamic Mode
switch
or INDIVIDUAL button
alters the screen on
the driver information
interface. Audio/Information Screen
INDIVIDUAL Mode
Press and hold the INDIVIDUAL
button or select Customize
2 Customized Features P. 367
Press the or button on the
audio/information screen.
2
Audio System Basic Operation
P. 267
Dynamic Mode
Switch
Press the INDIVIDUAL button
Press the Dynamic Mode switch
up or down
INDIVIDUAL
Button
*1: The display returns to audio/information
screen a few seconds after pressing the
Dynamic Mode switch or INDIVIDUAL button.
*1
*1
2.0 L engine models
24 ACURA INTEGRA-313S56100.book 456 ページ ２０２３年２月１３日　月曜日　午後２時４１分

uuWhen Driving uAuto Idle Stop
464
Driving
The Auto Idle Stop suspend indicator comes
on and a message appears on the driver
information interface when the Auto Idle Stop
system cannot be activated.
2 Indicators P. 86
2 Auto Idle Stop System ON/OFF P. 464
To turn the Auto Idle Stop system off, press
this button. The Auto Idle Stop system stops.
u Auto Idle Stop system will stop, the
indicator will come on and a message
appears on the driver information
interface.
The Auto Idle Stop syst em is turned on every
time you start the engine, even if you turned it
off the last time you drove the vehicle.
Auto Idle Stop
Suspend Indicator
■Auto Idle Stop System ON/OFF1 Auto Idle Stop System ON/OFF
If you turn off the Auto Id le Stop system while it is
activated, the engine will restart. 2 Auto Idle Stop Activates When: P. 465
If you press and hold the Auto Idle Stop OFF button,
you can select whether to display the status messages
or not.
Auto Idle Stop OFF
Indicator
Auto Idle Stop
OFF Button
24 ACURA INTEGRA-313S56100.book 464 ページ ２０２３年２月１３日　月曜日　午後２時４１分

uuWhen Driving uAuto Idle Stop*
470
Driving
The Auto Idle Stop suspend indicator comes
on and a message appears on the driver
information interface when the Auto Idle Stop
system cannot be activated.
2 Indicators P. 86
2 Auto Idle Stop System ON/OFF P. 470
To turn the Auto Idle Stop system off, press
this button. The Auto Idle Stop system stops.
u Auto Idle Stop system will stop, the
indicator will come on and a message
appears on the driver information
interface.
The Auto Idle Stop syst em is turned on every
time you start the engine, even if you turned it
off the last time you drove the vehicle.
Auto Idle Stop
Suspend Indicator
■Auto Idle Stop System ON/OFF1 Auto Idle Stop System ON/OFF
If you turn off the Auto Id le Stop system while it is
activated, the engine will restart. 2 Auto Idle Stop Activates When: P. 465
If you press and hold the Auto Idle Stop OFF button,
you can select whether to display the status messages
or not.
Auto Idle Stop OFF
Indicator
Auto Idle Stop
OFF Button
24 ACURA INTEGRA-313S56100.book 470 ページ ２０２３年２月１３日　月曜日　午後２時４１分

479
uuWhen Driving uTire Pressure Monitoring System (TPMS) with Tire Fill Assist
Driving
To select the tire pressure monitor, set the power
mode to ON, and roll the right selector wheel
until you see the tire pressure screen.
The pressure for each tire is displayed in psi.
Tire pressures low is displayed when a tire
has significantly low pressure. The specific tire
is displayed on the screen.
■Tire Pressure Monitor1 Tire Pressure Monitor
The pressure displayed on the driver information
interface can be slightly different from the actual
pressure as measured by a gauge. If there is a
significant di fference between the two values, or if
the low tire pressure/TPMS indicator and the message
on the driver information in terface do not go off after
you have inflated the tire to the specified pressure,
have the system checked by a dealer.
Tire pressure monitor system problem. Check
tire pressure. See your dealer. may appear if you
drive with the compact spare tire
*, or there is a
problem with the TPMS.
* Not available on all models
24 ACURA INTEGRA-313S56100.book 479 ページ ２０２３年２月１３日　月曜日　午後２時４１分

Continued483
uuWhen Driving uBlind Spot Information System
Driving
■When the system detects a vehicle
Blind spot information system alert indicator:
Located on the outside door mirror on both
sides.
Comes on when:
•A vehicle approaches you from behind to
overtake you at a speed difference of no
more than about 31 mph (50 km/h).
• You pass a vehicle at a speed difference of
no more than about 12 mph (20 km/h).
Blinks and a beeper sounds when:
You use the turn signal lever to signal a turn in
the direction of the detected vehicle while the
blind spot information system alert indicator is
on. u The beeper sounds three times.1Blind Spot Information System
For proper blind spot information system operation:
•Always keep the rear bumper and area around the
radar sensors clean.
•Do not cover the rear bumper corner area with
labels or sticke rs of any kind.
The system is for your convenience only. Even if an
object is within the alert zone, the following
situations may occur:
•The blind spot informatio n system alert indicator
does not come on and the message Blind spot
information system not available appears on
the driver information interface.
•The blind spot informatio n system alert indicator
may come on even with the message displayed.
Comes On
Blinks
24 ACURA INTEGRA-313S56100.book 483 ページ ２０２３年２月１３日　月曜日　午後２時４１分

uuWhen Driving uBlind Spot Information System
484
Driving
You can turn the system on and off us ing the driver information interface.
2Switching the Display P. 117
2 Safety Support P. 129
The blind spot information system will stay on the previously selected on or off
setting each time you start the engine.
■Blind Spot Information System On and Off1 Blind Spot Information System
You can change the settings for the blind spot
information system.
2 Vehicle Settings
* P. 134
2 Customized Features P. 367
Models with 7-in. Color Touchscreen
Models with 9-in. Color Touchscreen
* Not available on all models
24 ACURA INTEGRA-313S56100.book 484 ページ ２０２３年２月１３日　月曜日　午後２時４１分

uuAcuraWatchTMu
488
Driving
You can see the current state of Adaptive
Cruise Control (ACC) with Low Speed Follow*/
Adaptive Cruise Control (ACC)*, Lane Keeping
Assist System (LKAS) and Traffic Jam Assist*.
aIndicates that ACC with Low Speed
Follow*/ACC* is ready to be activated.
• Green: The system is on.
• White: The system is standby.
• Amber: There is a problem with the system.
bIndicates that LKAS or Traffic Jam Assist* is
ready to be activated.
• Green: The system is on.
• White: The system is standby.
• Amber: There is a problem with the system.
cIndicates that LKAS or Traffic Jam Assist* is
activated and whether or not traffic lane
lines are detected.
• Green lines: The system is on.
• White lines: Traffic lane lines are detected.
• Amber line: Lane departure is detected.
dIndicates whether or not a vehicle is
detected ahead.
• Control target vehicle: White and outlined
in green
• Outside of control target vehicle: Gray
eIndicates that ACC with Low Speed
Follow*/ACC* shows the set vehicle speed.
fIndicates that ACC with Low Speed
Follow*/ACC* shows the set vehicle
interval.
■Gauge Content1 Gauge Content
You can have the head-up display show you the
current state of each function.
2 Head-Up Display
* P. 143
Models with Head-up display
* Not available on all models
24 ACURA INTEGRA-313S56100.book 488 ページ ２０２３年２月１３日　月曜日　午後２時４１分

Continued491
uuAcuraWatchTMuCollision Mitigation Braking SystemTM (CMBSTM)
Driving
■When the system activates
You can change the distance ( Long/Normal /Short ) between vehicles at which the
system’s earliest collision alert will come on.
2 Vehicle Settings* P. 134
2 Customized Features P. 367
1When the system activates
The head-up warning uses a lens located at the front
end of the dashboard.
Do not cover the lens or spill any liquid on it.
Models with Head-up display
Lens
The system provides visual and audible alerts of a possible collision, and stops if the
collision is avoided.
u Take appropriate action to prevent a collision (apply the brakes, change
lanes, etc.)
Visual Alerts
Beep
Audible Alert
Head-up Warning
Lights*
Models with 7-in. Color Touchscreen
Models with 9-in. Color Touchscreen
* Not available on all models
24 ACURA INTEGRA-313S56100.book 491 ページ ２０２３年２月１３日　月曜日　午後２時４１分