turn signal Acura MDX 2005 Owner's Manual

Î
Î
To use the horn, press the pad around the ‘‘A’’ logo.
:
Your Vehicle at a Glance
Your Vehicle at a Glance
5
HEADLIGHTS/
TURN SIGNALS
FOG LIGHTS REMOTE AUDIO
CONTROLS STEERING WHEEL
ADJUSTMENT CRUISE CONTROL
HORN
WINDSHIELD WIPERS/WASHERS
VEHICLE STABILITY
ASSIST SYSTEM
OFF SWITCH
CRUISE CONTROL INSTRUMENT PANEL BRIGHTNESS
REAR WINDOW
DEFOGGER
VTM-4
LOCK
PASSENGER AIRBAG OFF
INDICATOR
HAZARD WARNING
BUTTON
(P.74)
(P.212)
(P.146)
(P.77) (P.130) (P.78) (P.147)
(P.71) (P.
77)
(P.
33)
(P.204)
(P.76)
(P.76)

CONT INUED
Automatic front seat belt
tensioners (see page ).Weight sensors that monitor the
weight on the f ront passenger’s
seat. If the weight of an inf ant or
small child is detected, the
passenger’s f ront airbag will be
turned of f (see page ).
Sensors that can detect a
moderate to severe front impact or
side impact.
Height and position sensors that
can detect whether a child is in the
passenger’s side airbag path and
signal the control unit to turn the
airbag off (see page ).
A driver’s seat position sensor that
monitors the distance of the seat
from the front airbag. If the seat is
too f ar f orward, the airbag will
inf late with less f orce (see page
). A rollover sensor that can detect if
your vehicle is about to roll over
and signal the control unit to
deploy both side curtain airbags
and f ront seat belt tensioners (see
page ).
A sophisticated electronic system
that continually monitors and
records inf ormation about the
sensors, the control unit, the
airbag activators, the seat belt
tensioners, and driver and f ront
passenger seat belt use when the
ignition is in ON (II). Emergency backup power in case
your vehicle’s electrical system is
disconnected in a crash.
An indicator on the instrument
panel that alerts you that the
passenger’s side airbag has been
turned of f (see page ).
An indicator on the dashboard that
alerts you that the passenger’s
f ront airbag has been turned of f
(see page ).
22
33
28 33
3332
31
Additional Inf ormation About Your Airbags
Driver and Passenger Saf ety
25

When the airbag is turned of f , an
indicator in the center of the
dashboard will come on indicating
passenger airbag ‘‘OFF’’ (see page).
If there is no passenger in the f ront
seat, the airbag will be off. However,
the Passenger Airbag Of f indicator
will not come on.
Objects placed on the f ront
passenger seat can also cause the
passenger airbag to be shut of f .
To ensure that the passenger’s
advanced front airbag system will
work properly,
This includes: A rear passenger pushing or
pulling on the back of the
passenger’s seat. Moving the f ront seat f orcibly
back against cargo on the seat or
f loor behind it.
Hanging heavy items on the f ront
passenger seat, or placing heavy
items in the seat-back pocket.
If you ever have a moderate to
severe side impact, sensors will
detect rapid deceleration and signal
the control unit to instantly inf late
either the driver’s or the passenger’s
side airbag.
33
CONT INUED
Additional Inf ormation About Your Airbags
do not do anyt hing
t hat would increase or decrease t he weight on t he f ront passenger’s seat .
How Your Side A irbags Work
Driver and Passenger Saf ety
29

This section gives inf ormation about
the controls and displays that
contribute to the daily operation of
your vehicle. All the essential
controls are within easy reach............................
Control Locations .58
............................
Instrument Panel .59
....................
Instrument Indicators .60
.............................................
Gauges .68
Controls Near the Steering ...........................................
Wheel .70
Windshield Wipers and ...................................
Washers .71
Rear Window Wiper and .....................................
Washer .73
...........
Turn Signal and Headlights . 74
........
Instrument Panel Brightness . 76
.................
Hazard Warning Button . 76
.................
Rear Window Def ogger . 77
.........................................
Fog Light .77
..........
Steering Wheel Adjustment . 78
..................................................
Keys .79
........................
Immobilizer System .80
................................
Ignition Switch .81
......................................
Door Locks .82
.......................
Remote Transmitter .83
.................................................
Seats .86
....................................
Seat Heaters .91
..............................
Power Windows .92
.........................................
Moonroof .93
.................................
Parking Brake .94 .............................................
Mirrors .95
Driving Position Memory ..........................................
System .97
.................................
Interior Lights .99
.........
Interior Convenience Items . 101
.....................
Beverage Holders .102
.............
Console Compartment . 102
..................................
Glove Box .102
...................
Rear Compartment . 103
.............................
Cargo Hooks .103
...................................
Sun Visor .103
............................
Vanity Mirror .103
........
Accessory Power Sockets . 104
Instruments and Controls
Inst rument s and Cont rols
57

If a brake light does not work, theindicator comes on
when you push the brake pedal with
the ignition switch to ON (II).
A burned out brake light is a hazard
when drivers behind you cannot tell
you are braking. Replace the bulb as
soon as possible (see page ). The appropriate indicator comes on
in this display if the tailgate or any
door is not closed tightly.
All of the indicators in the monitor
display come on f or a f ew seconds
when you turn the ignition switch to
ON (II).
When you press the Hazard Warning
button, both turn signal lights blink.
All turn signals on the outside of the
vehicle should f lash. The lef t or right turn signal indicator
blinks when you signal a lane change
or turn. If the indicator does not
blink or blinks rapidly, it usually
means one of the turn signal bulbs is
burned out (see page ). Replace
the bulb as soon as possible, since
other drivers cannot see that you are
signaling. 246
247
Turn Signal and
Hazard Warning
Indicators
Brake L amp Indicator Door and Tailgate Open Monitor
Instrument Panel Indicators
62
BRAKE LAMP

Î
Î
To use the horn, press the pad around the ‘‘Acura’’ logo.
Controls Near the Steering Wheel
70
REAR WINDOW
DEFOGGER
VTM-4
LOCK
INSTRUMENT PANEL
BRIGHTNESS
FOG LIGHTS HEADLIGHTS/TURN SIGNALS
REMOTE AUDIO
CONTROLS HORN
CRUISE CONTROL
VEHICLE STABILITY
ASSIST SYSTEM OFF
SWITCH
STEERING WHEEL ADJUSTMENT WINDSHIELD WIPERS/WASHERS
CRUISE CONTROL
PASSENGER AIRBAG OFF INDICATORHAZARD WARNING
BUTTON
(P.74)
(P.77)
(P.146)
(P.212)
(P.130)
(P.78) (P.146)
(P.33)
(P.71) (P.77)
(P.204)
(P.76)
(P.76)

µµ
µ Push down on the
lef t lever to signal a lef t turn and up
to signal a right turn. To signal a lane
change, push lightly on the lever and
hold it. The lever will return to
center when you release it or
complete a turn. When the light switch is in either of
these positions, the Lights On
indicator comes on as a reminder.
This light remains on if you leave the
light switch on and turn the ignition
switch to ACCESSORY (I) or LOCK
(0).
To turn on, pull the
lever back until you hear a click. The
blue high beam indicator will come
on (see page ). Pull it back again
to return to low beams.
To f lash the high beams, pull the
lever back lightly, then release it.
The high beams will stay on as long
as you hold the lever back.
Turning the switch to the ‘‘ ’’
position turns on the headlights. If
you leave the lights on with the key
removed f rom the ignition switch,
you will hear a reminder chime when
you open the driver’s door.
Turn signal
Of f
Parking and indicator lights
AUTO
Headlights on
High beams
Flashhighbeams Turning the switch to
the ‘‘ ’’ position turns on the
parking lights, taillights, instrument
panel lights, side-marker lights, and
rear license plate lights.
1.
2.
3.
4.
5.
6.
7. 63
Turn Signal and Headlights Turn Signal
High Beams
Headlights
Turn Signal, Headlights
74

With the headlight switch off, the
high beam headlights come on with
reduced brightness when you turn
the ignition switch to ON (II) and
release the parking brake. They
remain on until you turn the ignition
of f , even if you set the parking brake.
The headlights revert to normal
operation when you turn them on
with the switch.Push the red button to the right of
the display to turn on the hazard
warning lights (f our-way f lashers).
This causes all f our outside turn
signals and both indicators in the
instrument panel to f lash. Use the
hazard warning lights if you need to
park in a dangerous area near heavy
traf f ic, or if your vehicle is disabled.
The dial on the instrument panel
controls the brightness of the
instrument panel lights, the blue
lighting in the upper console and the
f ront f oot wells.
Canadian Models
Daytime Running L ights
Instrument Panel Brightness Hazard Warning Button
Headlights, Instrument Panel Brightness, Hazard Warning Button
76
INSTRUMENT PANEL BRIGHTNESS
CONTROL DIAL

µµ
´µ µ
µ
The ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Turn the system on by pushing the
PWR/VOL knob. Adjust the volume
by turning the same knob.
The band and f requency that the
radio was last turned to is displayed.
To change bands, press the AM or
FM button. On the FM band, ST will
be displayed if the station is
broadcasting in stereo. Stereo
reproduction in AM is not available.
Use the TUNE knob to
tune the radio to a desired f requency.
Turn the knob right to tune to a
higher f requency, or lef t to tune to a
lower f requency. The SEEK f unction
searches up and down from the
current f requency to f ind a station
with a strong signal. To activate it,
press the or SEEK button, then
release it. Each preset button can
store one f requency on AM, and two
f requencies on FM.
Select the desired band, AM or
FM. FM1 and FM2 let you store
two f requencies with each preset
button.
UsetheTUNE,SEEK,orSCAN
function to tune the radio to a
desired station.
Pick a preset button, and hold it
until you hear a beep.
Repeat steps 1 through 3 to store a
total of six stations on AM and
twelve stations on FM.
You can use these five methods to
f ind radio stations on a selected
band: the
preset buttons, and .The SCAN f unction
samples all stations with strong
signals on the selected band. To
activate it, press the SCAN button,
then release it. You will see SCAN in
the display. The system will scan f or
a station with a strong signal. When
it f inds one, it will stop and play that
station f or about 10 seconds.
If you do nothing, the system will
then scan f or the next strong station
andplayitfor10seconds.Whenit
plays a station that you want to listen
to, press the SCAN button again. 1.
2.
3.
4.
To Play the Radio
TUNE SEEK
Preset
To Select a Station TUNE,SEEK,SCAN, AUTO SELECT SCAN
Playing the Radio
114

You can use the instrument panel
brightness control knob to adjust the
illumination of the audio system (see
page ). The audio system
illuminates when the parking lights
are on, even if the radio is turned of f .
Those bands cover these f requen-
cies:
AM band: 530 to 1,710 kilohertz
FM band: 87.7 to 107.9 megahertzStations must use these exact
f requencies. It is f airly common f or
stations to round-of f the f requency in
their advertising, so your radio could
display a f requency of 100.9 even
though the announcer may identif y
the station as ‘‘FM101.’’
A radio station’s signal gets weaker
as you get f arther away f rom its
transmitter. If you are listening to an
AM station, you will notice the sound
volume becoming weaker and the
stationdriftinginandout.If youare
listening to an FM station, you will
see the stereo indicator f lickering of f
and on as the signal weakens.
Eventually, the stereo indicator willgo of f and the sound will f ade
completely as you get out of range of
the station’s signal.
Driving very near the transmitter of
a station that is broadcasting on a
f requency close to the f requency of
the station you are listening to can
also af f ect your radio’s reception.
You may temporarily hear both
stations,orhearonlythestationyou
are close to.
Your vehicle’s radio can receive the
complete AM and FM bands.
How well your vehicle’s radio
receives stations is dependent on
many f actors, such as the distance
from the station’s transmitter,
nearby large objects, and
atmospheric conditions.
Radio stations on the AM band are
assigned f requencies at least ten
kilohertz apart (530, 540, 550).
Stations on the FM band are
assigned f requencies at least 0.2
megahertz apart (87.9, 88.1, 88.3). 76
A udio System L ighting
Radio Frequencies
Radio Reception
Radio Reception
116