Acura MDX 2008 Manual PDF

This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to the ON (II)
position.
If itcomesonandstaysonatany
other time, or it does not come on
when you turn the ignition switch to
the ON (II) position, there is a
problem with the VSA system. You
will also see a ‘‘CHECK VSA
SYSTEM’’ message on the multi-
inf ormation display (see page ).
Take your vehicle to a dealer to have
it checked. Without VSA, your
vehicle still has normal driving ability,
but will not have VSA traction and
stability enhancement. For more
inf ormation, see page .
This indicator may also come on if
there is a problem with the trailer
stability assist f unction (see page). This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to the ON (II)
position. For more inf ormation, see
page .
This indicator has f our f unctions.
Itcomesonasareminderthatyou
have turned off the vehicle
stability assist (VSA) system.
It flashes when VSA is active (see
page ).
It f lashes when trailer stability
assist is activating (see page ).
It comes on along with the VSA
system indicator if there is a
problem with the VSA system.
You will also see a ‘‘CHECK VSA
SYSTEM’’ message and a
‘‘CHECK TRAILER STABILITY
ASSIST’’ message on the multi- inf ormation display (see page ).
The lef t or right turn signal indicator
blinks when you signal a lane change
or turn. If an indicator does not blink
or blinks rapidly, it usually means
one of the turn signal bulbs is
burned out (see page ). Replace
the bulb as soon as possible, since
other drivers cannot see that you are
signaling.
When you press the hazard warning
button, both turn signal indicators
and all turn signals on the outside of
the vehicle f lash.
1.
2.
3.
4.
81 81
359
375 359
359 375 404
Instrument Panel Indicators
Vehicle Stability Assist
(VSA ) System Indicator
VSA A ctivation Indicator
Turn Signal and
Hazard Warning
Indicators
Inst rument s and Cont rols
67
——yy
()-
yy
2008 MDX

This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to the ON (II)
position.
This indicator has two f unctions:This indicator monitors the
temperature of the automatic
transmission f luid. It should come on
f or a f ew seconds when you turn the
ignition switch to the ON (II)
position. If it comes on while driving,
it means the transmission fluid
temperature is too high. Pull to the
side of the road when it is saf e, shif t
to Park, and let the engine idle until
the indicator goes out.
You will also see an ‘‘A/T TEMP
HIGH’’ message on the multi-
inf ormation display (see page ).
If this happens, pull to the side of
the road when it is saf e, check
which tire has lost pressure on the
multi-inf ormation display, and
determine the cause. If it is
because of a flat tire, have the flat
tire repaired as soon as possible. If
two or more tires are
underinf lated, call a prof essional
towing service. For more
inf ormation, see page .
If this indicator begins to f lash,
there is a problem with the tire
pressure monitoring system
(TPMS). You will also see a
‘‘CHECK TPMS SYSTEM’’
message on the multi-inf ormation
display. The indicator continues to
f lash f or a while (approximately 1
minute), then stays on. If this
happens, have your dealer check
the system as soon as possible.
For more inf ormation, see page
.
Check the tire pressure monitor on
the multi-inf ormation display and
determinethecause(seepage).
You will also see a ‘‘CHECK TIRE
PRESSURE’’ message on the multi-
inf ormation display (see page ). If it comes on while driving, it
indicates that one or more of your
vehicle’s tires are signif icantly low
on pressure.
1.
82
2.
82 446
352 354
Instrument Panel Indicators
Low Tire Pressure/
TPMS Indicator A/T Temperature
Indicator
68
Continuing to drive with the A/T
temperature indicator on may cause
serious damage to the transmission.
\f—\f—\fy\f\fy
()-
\fy\f\fy
2008 MDX

If the indicator blinks while driving,
it indicates the dif f erential
temperature is too high.
TEMP. HIGH’’ message on the
multi-inf ormation display (see page).
Pull to the side of the road when it is
saf e, shif t to Park, and let the engine
idle until the indicator goes out.
This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to the ON (II)
position. If this indicator comes on at
any other time, there is a problem in
display (see page ). Take your
For more inf ormation, see page .
This indicator comes on when there
is a system message on the multi-
inf ormation display. Press the INFO
button on the steering wheel (see
page ) to see the message (see
page ).
Most of the time, this indicator
comes on along with other indicators
in the instrument panel such as the
seat belt reminder indicator, SRS
indicator, VSA system indicator, etc.
81
73
8282
348
Instrument Panel Indicators
Super Handling-All
Indicator
Message Indicator
Inst rument s and Cont rols
69

damage to the system.
——yy
()-
yy
vehicletoadealertohaveitchecked.
indicatorblinkingmaycauseserious
messageonthemulti-information
WheelDrive(SH-AWD®)
®theSH-AWD system. You will also
seea‘‘CHECKSH-AWD®SYSTEM’’
Youwillalsoseea‘‘SH-AWD®DIFF
ContinuingtodrivewiththeSH-AWD®
2008 MDX

This indicator comes on when you
turn on the cruise control system by
pressing the CRUISE button (see
page ).
This indicator comes on when you
set the cruise control. See pagef or inf ormation on operating the
cruise control. This indicator comes on with the
high beam headlights. For more
inf ormation, see page .
This indicator comes on when you
turn on the f og lights. For more
inf ormation, see page . This indicator reminds you that the
exterior lights are on. It comes on
when the light switch is in either the or position. This indicator
will also come on when the light
switch is in AUTO and the lights
turn on automatically. If you turn the
ignition switch to the ACCESSORY
(I) or the LOCK (0) position without
turning of f the light switch, this
indicator will remain on. A reminder
chime will also sound when you open
the driver’s door.
This indicator comes on brief ly when
you turn the ignition switch to the
ON (II) position. It will then go of f if
you have inserted a properly-coded
ignition key. If it is not a properly-
coded key, the indicator will blink,
and the engine’s f uel system will be
disabled (see page).
128
120118
270
270
Instrument Panel Indicators
Cruise Control Indicator Cruise Main Indicator High Beam Indicator
Fog L ight Indicator Lights On Indicator
Immobilizer System
Indicator
70
——yy
()-
yy
2008 MDX

This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to the ON (II)
position. If this indicator comes on at
any other time, there is a problem in
the system. While this indicator is on,
the comfort button will not work, and
the system will remain in the sport
mode. You will also see a ‘‘CHECK
ADS SYSTEM’’ message on the
multi-inf ormation display. Have the
vehicle checked by your dealer as
soon as possible. For more
inf ormation, see page .This indicator comes on as a
reminder that you must ref uel soon.
When the indicator comes on, there
is about 1.8 US gal (7.0
)of fuel
remaining in the tank bef ore the
needle reaches E. There is a small
reserve of f uel remaining in the tank
when the needle reaches E. You will
also see a ‘‘LOW FUEL’’ message on
the multi-information display (see
page ). This indicator comes on when the
security system is set. See page
f or more inf ormation on the
security system.
82
361
269
Active Damper System
Indicator
L ow Fuel Indicator Security System Indicator
Instrument Panel Indicators
Inst rument s and Cont rols
71
LOW FUEL INDICATOR
SECURITY SYSTEM INDICATOR
\f—\f—\fy\f
\f
y
()-
\fy\f\fy
2008 MDX

This shows the temperature of the
engine’s coolant. During normal
operation, the pointer should rise to
about the middle of the gauge. In
severe driving conditions, the pointer
may rise to the upper zone. If it
reaches the red (hot) mark, pull
safely to the side of the road. Forinstructions and precautions on
checking the engine’s cooling
system, see page .This shows how much f uel you
have. It may show slightly more
or less than the actual amount.
434
Gauges
Temperature Gauge Fuel Gauge
72
U.S. model is shown.SPEEDOMETER
FUEL GAUGE
TEMPERATURE
GAUGE TACHOMETER
Avoid driving with an extremely low
f uel level. Running out of f uel could
cause the engine to misf ire, damaging
the catalytic converter.
\f—\f—\fy\f
\fy
()-
\fy\f\fy
2008 MDX

ÛÝÛÝ
ÛÝThe multi-inf ormation display in the
instrument panel displays various
inf ormation and messages when the
ignition switch is in the ON (II)
position. Some of the messages help
you operate your vehicle more
comf ortably.
Others help to keep you aware of the
periodic maintenance your vehicle
needs f or continued trouble-f ree
driving.
When you open the driver’s door, a
‘‘Welcome’’ message is shown on the
multi-inf ormation display. When you
turn the ignition switch from the ON
(II) position to the ACCESSORY (I)
position, a ‘‘Goodbye’’ message is
shownonthedisplay.
To change the display, press the
INFO( / )buttononthesteering
wheel repeatedly until the main
menu appears (see page ).With the ignition switch in the ON
(II) position, the multi-inf ormation
display changes as shown in the next
page each time you press the INFO
( / ) button or SEL/RESET
button.
When you turn the ignition switch to
the ON (II) position, what you last
selected is displayed.
In the multi-information display, the
system message is also displayed
(see page ) and you can
customize your vehicle control
settings (see page ).
74 83
80
CONT INUED
Multi-Inf ormation Display
Inst rument s and Cont rols
73
INFO ( / )
BUTTON
SEL/
RESET
BUTTON
\f—\f—\fy\f

y
()-
\fy\f\fy
2008 MDX

Multi-Inf ormation Display
74
Main MenuINFO buttonSEL/RESET button
(See page75)
Go to Customize Menu (See page83)
Trip Computer (See page78)(See page75)
(See page75)
Tire Pressure for each tire (See page77) Go to HandsFreeLink Menu (See page280)
\f—\f—\fy\f

y
()-
\fy\f\fy
2008 MDX

When the main menu is blank,
pressing the SEL/RESET button
changes the display to ‘‘trip meter/
odometer’’ ‘‘outside temperature/
odometer’’ and ‘‘engine oil lif e/
odometer’’.The odometer shows the total
distance your vehicle has been
driven. It measures miles in U.S.
models and kilometers in Canadian
models. It is illegal under U.S.
federal law and Canadian provincial
regulations to disconnect, reset, or
alter the odometer with the intent to
change the number of miles or
kilometers indicated.This meter shows the number of
miles (U.S.) or kilometers (Canada)
driven since you last reset it. There
are two trip meters: Trip A and Trip
B. Each trip meter works
independently, so you can keep track
of two dif f erent distances.
To reset a trip meter, display it, and
then press and hold the SEL/RESET
button until the number resets to
‘‘0.0.’’
CONT INUED
Multi-Inf ormation Display
Trip Meter
Odometer
Inst rument s and Cont rols
75
ODOMETER TRIP METER
\f—\f—\fy\f

y
()-
\fy\f\f\fy
SH-AWD®or TIRE PRESSURE,
2008 MDX

The temperature sensor is in the
f ront bumper. The temperature
reading can be affected by heat
ref lection f rom the road surf ace,
engine heat, and the exhaust f rom
surrounding traf f ic. This can cause
an incorrect temperature reading
when your vehicle speed is under
19 mph (30 km/h). When you start
your trip, the sensor is not f ully
acclimatized, theref ore it may take
several minutes until the proper
temperature is displayed.
In certain weather conditions,
temperature readings near f reezing
(32°F, 0°C) could mean that ice is
f orming on the road surf ace.
You can adjust the outside
temperature display (see page ).
This shows the outside Fahrenheit
temperature in U.S. models, and
Centigrade temperature in Canadian
models.
When you reset Trip A, average f uel
economy A is reset at the same time.
When you reset Trip B, average f uel
economy B is reset.
In the customizing mode, you can set
Trip A and average f uel economy A
to reset at the same time when you
ref uel your vehicle (see page ).
92
91
Outside Temperature
Multi-Inf ormation Display
76
OUTSIDE TEMPERATURE
U.S.
CANADA
\f—\f—\fy\f
y
()-
\fy\f\f
y
2008 MDX