Acura MDX 2017 Manual Online
Manufacturer: ACURA, Model Year: 2017, Model line: MDX, Model: Acura MDX 2017Pages: 581, PDF Size: 32.65 MB
Page 81 of 581

80
uuIndicators u
Instrument Panel
IndicatorNameOn/BlinkingExplanationMessage
Transmission 
Indicator
●The indicated current gear 
selection blinks if there is a 
problem with the transmission 
system.●Avoid sudden start and acceleration, and stop 
in a safe place immediately. 
Have your vehicle checked by a dealer.
●All the gear positions may light 
for several seconds, and go off.●When all the gear positions light, immediately 
stop your vehicle  in a safe place.
●Indicators go off if there is no problem.
However, even if they go off, take your vehicle 
to a dealer for inspection.
●The indicated current gear 
selection or all the gear positions 
blink if there is a problem with 
the transmission system, and the 
vehicle no longer moves.●Immediately stop in a safe place.
2Emergency Towing P. 554●Have your vehicle checked by a dealer.
●The indicated current gear 
selection or all the gear positions 
blink if you cannot select 
(P due 
to the transmission system 
failure.
●The engine can be activated as a temporary 
measure.
2 If the Transmission Indicator Blinks along 
with the Warning Message  P. 545
●Set the parking brake when parking.●Have your vehicle checked by a dealer 
immediately.
17 ACURA MDX-31TZ56300.book  80 ページ  2016年5月13日 金曜日 午後7時46分 
Page 82 of 581

81
uuIndicators u
Continued
Instrument Panel
IndicatorNameOn/BlinkingExplanationMessage
Seat Belt 
Reminder 
Indicator
●Comes on and the beeper sounds 
if you are not wearing a seat belt 
when you set the power mode to 
ON.
●If the front passenger is not 
wearing a seat belt, the indicator 
comes on about a few seconds 
later.
●Blinks while driving if either you 
or the front passenger has not 
fastened a seat belt. The beeper 
sounds and the indicator blinks at 
regular intervals.
●The beeper stops and the indicator goes off 
when you and the front  passenger fasten their 
seat belts.
●Stays on after you or the front passenger 
has fastened the seat belt  - A detection 
error may have occurred in the sensor. Have 
your vehicle checked by a dealer.
2 Seat Belt Reminder  P. 34
Low Fuel Indicator
●Comes on when the fuel reserve 
is running low (approximately 2.5 
U.S. gal./9.5 Liter left).
●Blinks if there is a problem with 
the fuel gauge.
●Comes on - Refuel your vehicle as soon as 
possible.
●Blinks - Have your vehicle checked by a 
dealer.
17 ACURA MDX-31TZ56300.book  81 ページ  2016年5月13日 金曜日 午後7時46分 
Page 83 of 581

82
uuIndicators u
Instrument Panel
IndicatorNameOn/BlinkingExplanationMessage
Anti-lock Brake 
System (ABS) 
Indicator
●Comes on for a few seconds 
when you set the power mode to 
ON, then goes off.
●If it comes on at any other time, 
there is a problem with the ABS.
●Stays on constantly  - Have your vehicle 
checked by a dealer. Wi th this indicator on, 
your vehicle still has normal braking ability but 
no anti-lock function.
2 Anti-lock Brake System (ABS) P. 434
Supplemental 
Restraint System 
Indicator
●Comes on for a few seconds 
when you set the power mode to 
ON, then goes off.
●Comes on if a problem with any 
of the following is detected:
-Supplemental restraint system
- Side airbag system
- Side curtain airbag system
- Seat belt tensioner
●Stays on constantly or does not come on 
at all - Have your vehicle checked by a dealer.
Auto High-Beam 
Indicator●Comes on when all the operating 
conditions of the Auto high-
beam are met.
2 Auto High-Beam  P. 171—
17 ACURA MDX-31TZ56300.book  82 ページ  2016年5月13日 金曜日 午後7時46分 
Page 84 of 581

83
uuIndicators u
Continued
Instrument Panel
IndicatorNameOn/BlinkingExplanationMessage
Vehicle Stability 
Assist (VSA ®) 
System Indicator
●Comes on for a few seconds 
when you set the power mode to 
ON, then goes off.
●Blinks when VSA ®, or trailer 
stability assist is active.
●Comes on if there is a problem 
with the VSA ®, hill start assist, 
trailer stability assist or brake 
lighting system.
●Stays on constantly  - Have your vehicle 
checked by a dealer.
2 Vehicle Stability Assist (VSA® ), aka 
Electronic Stability Control (ESC), System  
P. 418
2 Trailer Stability Assist P. 362
2 Hill start assist system  P. 371
●When Trailer Stability Assist Problem  is 
displayed on the MID, the VSA ® does not 
activate.
VSA ® OFF 
Indicator
●Comes on for a few seconds 
when you set the power mode to 
ON, then goes off.
●Comes on when you partially 
disable VSA®.
2 VSA ® On and Off  P. 419—
17 ACURA MDX-31TZ56300.book  83 ページ  2016年5月13日 金曜日 午後7時46分 
Page 85 of 581

84
uuIndicators u
Instrument Panel
IndicatorNameOn/BlinkingExplanationMessage
Speed-sensitive 
Electric Power 
Steering (EPS) 
System Indicator●Comes on when you set the 
power mode to ON, and goes off 
when the engine starts.
●Comes on if there is a problem 
with the EPS system.
●Stays on constantly or does not come on 
at all - Have your vehicle checked by a dealer.
2If the Speed-Sensitive Electric Power 
Steering (EPS) System Indicator Comes 
On  P. 543
Low Tire Pressure/
TPMS Indicator
●Comes on for a few seconds 
when you set the power mode to 
ON, then goes off.
●Comes on if the tire pressure of 
any of the tires becomes 
significantly low.
●Blinks for about one minute, and 
then stays on if there is a problem 
with the TPMS, or when a spare 
tire
* is temporarily installed.
●Comes on while driving  - Stop in a safe 
place, check tire pres sures, and inflate the 
tire(s) if necessary.
●Blinks and remains on - Have your vehicle 
checked by a dealer. If the vehicle is fitted with 
a spare, get your regular tire repaired or 
replaced and put back on your vehicle as soon 
as you can.
Turn Signal and 
Hazard Warning 
Indicators
●Blinks when you operate the turn 
signal lever.
●Blinks along with all turn signals if 
you press the hazard warning 
button.
●Does not blink or blinks rapidly
2 Replacing Light Bulbs  P. 481
—
High Beam 
Indicator●Comes on when the high beam 
headlights are on.——
* Not available on all models
17 ACURA MDX-31TZ56300.book  84 ページ  2016年5月13日 金曜日 午後7時46分 
Page 86 of 581

85
uuIndicators u
Continued
Instrument Panel
IndicatorNameOn/BlinkingExplanationMessage
Lights On 
Indicator
●Comes on whenever the light 
switch is on, or in  AUTO when 
the exterior lights are on.●If you set the power mode to ACCESSORY or 
VEHICLE OFF (LOCK) while the lights are on, a 
chime sounds when the driver’s door is 
opened.
—
Fog Light 
Indicator*
●Comes on when the fog lights 
are on.
——
Immobilizer 
System Indicator
●Comes on briefly when you set 
the power mode to ON, then 
goes off.
●Comes on if the immobilizer 
system cannot recognize the key 
information.
●Blinks  - You cannot start the engine. Set the 
power mode to VEHICL E OFF (LOCK), then 
select the ON mode again.
●Repeatedly blinks  - The system may be 
malfunctioning. Have your vehicle checked by 
a dealer.
●Do not attempt to alter this system or add 
other devices to it. Electrical problems can 
occur.
—
* Not available on all models
17 ACURA MDX-31TZ56300.book  85 ページ  2016年5月13日 金曜日 午後7時46分 
Page 87 of 581

86
uuIndicators u
Instrument Panel
IndicatorNameOn/BlinkingExplanationMessage
Security System 
Alarm Indicator
●Blinks when the security system 
alarm has been set.
2Security System Alarm  P. 157—
System Message 
Indicator
●Comes on for a few seconds 
when you set the power mode to 
ON, then goes off.
●Comes on along with a beep 
when a problem is detected. A 
system message on the MID 
appears at the same time.
●While the indicator is on, roll the multi-
function steering wheel control to see the 
message again.
●Refer to the Indicators information in this 
chapter when a system message appears on 
the MID. Take the appropriate action for the 
message.
●The MID does not return to the normal screen 
unless the warning is canceled, or the multi-
function steering-wheel controls is rolled.
—
17 ACURA MDX-31TZ56300.book  86 ページ  2016年5月13日 金曜日 午後7時46分 
Page 88 of 581

87
uuIndicators u
Continued
Instrument Panel
IndicatorNameOn/BlinkingExplanationMessage
Keyless Access 
System Indicator
●Comes on for a few seconds 
when you set the power mode to 
ON, then goes off.
●Comes on as soon as a problem is 
detected in the keyless access 
system or keyless starting system.
●Have your vehicle checked by a dealer.
Super Handling-
All Wheel DriveTM 
( SH-AWD ®) 
Indicator
*
●Comes on for a few seconds 
when you set the power mode to 
ON, then goes off.
●Comes on if there is a problem 
with the SH-AWD ® system.
●Blinks when the differential 
temperature is too high.
●Stays on constantly  - The engine drives the 
front wheels only in this state. Have your 
vehicle checked by a dealer.
●Blinks while driving  - Stop in a safe place, 
change to 
(P, and idle the engine until the 
indicator goes off. If  the indicator does not 
stop blinking, take your vehicle to a dealer.
2 Super Handling-All Wheel DriveTM (SH-
AWD® )* P. 423
* Not available on all models
17 ACURA MDX-31TZ56300.book  87 ページ  2016年5月13日 金曜日 午後7時46分 
Page 89 of 581

88
uuIndicators u
Instrument Panel
IndicatorNameOn/BlinkingExplanationMessage
Auto Idle Stop 
Indicator (Green)*
●Comes on when Auto Idle Stop is 
in operation. The engine 
automatically shuts off.
2Auto Idle Stop* P. 382—
Auto Idle Stop 
System Indicator 
(Amber)
*
●Comes on for a few seconds 
when you set the power mode to 
ON, then goes off.
●Blinks if there is a problem with 
the Auto Idle Stop System.
●Blinks  - Have your vehicle checked by a 
dealer.
●Comes on when Auto Idle Stop 
System has been turned off by 
Auto Idle Stop OFF  Button.
2Auto Idle Stop System ON/OFF  P. 382
* Not available on all models
17 ACURA MDX-31TZ56300.book  88 ページ  2016年5月13日 金曜日 午後7時46分 
Page 90 of 581

89
uuIndicators u
Continued
Instrument Panel
IndicatorNameOn/BlinkingExplanationMessage
Lane Keeping 
Assist System 
(LKAS ) Indicator 
(Amber)●Comes on for a few seconds 
when you set the power mode to 
ON, then goes off.
●Comes on if there is a problem 
with the LKAS.
●Stays on constantly  - Have your vehicle 
checked by a dealer.
Lane Keeping 
Assist System 
( LKAS ) Indicator 
(Green)
●Comes on when you press the 
MAIN  button.2Lane Keeping Assist System (LKAS) 
P. 410—
●Comes on when the LKAS is in 
operation, or the LKAS button is 
pressed, but the temperature 
inside the front sensor camera is 
too high. The LKAS cancels 
automatically. The beeper sounds 
simultaneously.●Use the climate control  system to cool down 
the camera.
●Goes off  - The camera has been cooled down 
and the system activates normally.
2 Front Sensor Camera  P. 388
●Comes on when the area around 
the camera is blocked by dirt, 
mud, etc. Stop your vehicle in a 
safe place, and wipe it off with a 
soft cloth.
●May come on when driving in 
bad weather (rain, snow, fog, 
etc.)
●Have your vehicle checke d by a dealer if the 
indicator and message come back on after 
you cleaned the area around the camera.
17 ACURA MDX-31TZ56300.book  89 ページ  2016年5月13日 金曜日 午後7時46分