ECO mode Acura RDX 2007 Repair Manual

´
CONT INUED
The SH-AWD torque distribution
monitor on the multi-inf ormation
display shows you the amount of
torque being sent to the wheels.
Each wheel: right f ront (RF), lef t
front(LF),rightrear(RR),andleft
rear (LR), has its own torque
indicator.
When you are in sequential shif t
mode, and the vehicle is stopped,
pull the (right) paddle shifter to
shif t to second gear. You will see ‘‘M
2’’ in the display. Starting in second
gear helps to reduce wheelspin in
deep snow or on a slippery surf ace.
The super handling-all wheel drive
(SH-AWD) system is a f ull time all-
wheel-drive system that
automatically controls and transfers
varying amounts of engine torque to
all wheels independently, according
to the driving conditions.
While the SH-AWD system helps to
enhance the vehicle’s driving
stability in all situations, it is still
your responsibility to drive and
corner at reasonable speeds and to
leave a sufficient margin of safety.
On RDX with Technology Package
model
SH-AWD T orque Distribution
Monitor
Super Handling-A ll Wheel Drive
(SH-AWD) system
Driving with the Paddle Shif ter, Super Handling-A ll Wheel Drive (SH-A WD) System
Driving
St art ing in Second Gear
303
TORQUE INDICATOR
TORQUE INDICATOR
——
y
y
() yy

Your vehicle is equipped with a tire
pressure monitoring system (TPMS)
that turns on every time you start the
engine and monitors the pressure in
your tires while driving. Al
though your tire pressure is
monito red, you must manually check
thetirepressuresmonthly.
Each tire, including the spare, should
be checked monthly when cold, and
set to the recommended inflation
pressure as specified on the vehicle
placard and in the owner’s manual
(see page ).
Driving on a signifi cantly under-
inflated tire causes the tire to
ov erheat and can lead to tire failure.
Under-infl ation also reduces fuel
efficiency and tire tread life, and may
affect the vehicle’s handling and
stopping ability. When
the low tire pressure indicator
is on, one or more of your tires is
signifi cantly underinflated. You
should stop and check your tires as
soon as possible, and inflate them to
the proper pressure as indicated on
the vehicle’s tire information placard.
Each
tire has its own pressure
sensor. If the air pressure of a tire
becomes significantly low, the
sensor in that tire immediately sends
a signal that causes the low tire
pressure indicator to come on.
With this indicator on, you will see
which tire is losing the pressu re on
the multi-information display along
with a ‘‘CHECK TIRE PRESSU RE’’
message (see page ).
With
this indicator on, you will see
which tire is losing the pressu re on
thetirepressure monitor(seepage
).
373
311
312
CONT INUED
On RDX with Technology Packagemodel
On RDX model
Tire Pressure Monitoring System (TPMS)
Low Tire Pressure
Indicator
Driving
309
——
y

y
() y
y

Becausetirepressurevariesby
temperature and other conditions,
the low tire pressure indicator may
come on unexp ectedly.
For example, if you check and fill
your tires in a warm area, then drive
in extremely cold weather, the tire
pressure will be lower than
measured and could be underinflated
and cause the low tire pressure
indicator to come on. Or, if you
check and adjust your tire pressure
in cooler conditions, and drive into
extremely hot conditions, the tire
maybecomeoverinflated.However,
the low tire pressure indicator will
not come on if the tires are
overinflated.
Refer to page for tire inflation
guidelines. This
indicator comes on and stays on
if there is a problem with the tire
pressure monitoring system.
If this happens, the system will shut
off and no longer monitor tire
pressures. Have the system checked
by your dealer as soon as possible. If
you have a flat tire, the low tire
indicator and tire pressure monitor
will come on. Replace the indicated
flat tire with the compact spare tire
(see page ).
After you replace the flat tire with
the spare, the low tire pressure
indicator stays on. This is normal;
the system is not monitoring the
spare tire pressure. Manually check
the spare tire pressure to be sure it
is correct.
Never use a puncture-repairing agent
in a f lat tire. If used, you will have to
replace the tire pressure sensor.
Havetheflattirerepairedbyyour
dealer as soon as possible. 383
372
On RDX model only
Tire Pressure Monitoring System (TPMS)
Tire Pressure Monitoring
System (T PMS) Indicator Changing a T ire with T PMS
310
——
y

y
() y
y

Each wheel is equipped with a tire
pressure sensor mounted inside the
tire behind the valve stem. You must
use TPMS specific wheels. It is
recommended that you always have
your tires serviced by your dealer or
qualified technician.
Your vehicle has a tire pressure
monitor on the info rmation display. The
tire pressure monitor uses the
same display as the door and tailgate
open monitor. When any of the tires
has low pressure, the low tire
pressure indicator on the instrument
panel comes on, and you will also see
which tire is losing the pressu re on
the tire pressure monitor.
If the TPMS indicator comes on, the
tire pressure monitor does not work
(see page ).
If the low tire pressure indicator and
the low tire position on the low tire
pressure monitor do not go out af ter
inf lating the tires to the specif ied
values, have your dealer check the
system as soon as possible. 73
CONT INUED
On RDX model
Tire Pressure Monitoring System (TPMS)
Tire Pressure Monitor
Driving
311
LOW PRESSURE TIRE
——
y

y
() y
y

This section explains why it is
important to keep your vehicle well
maintained and how to follow basic
maintenance safety precautions.
This section also includes
instructions on how to read the
maintenance minder messages on
the information display or multi-
info rmation display (dep ending on
models), a mainten ance record, and
instructions for simple maintenance
tasks you may want to take care of
yourself.
If you have the skills and tools to
perform more complex maintenance
tasks on your vehicle, you may want
to purchase the service manual. See
page f or inf ormation on how to
obtain a copy, or see your dealer. ......................
Maintenance Saf ety .328
....................
Maintenance Minder .330
....................
Maintenance Record .344
..............................
Fluid Locations .346
........................
Adding Engine Oil .347
.................
Required Engine Oil .347
.........
Changing the Oil and Filter .349
..............................
Engine Coolant .351
....................
Windshield Washers .353
....
Automatic Transmission Fluid .355
....................................
Brake Fluid .357
....................
Power Steering Fluid .358
.............................................
Lights .359
................
Cleaning the Seat Belts .366
.....................................
Floor Mats .366
..............................
Audio Antenna .367
.....................................
Intercooler .367
..................
Dust and Pollen Filter .367
.................................
Wiper Blades .368
...............................................
Tires .372
...................
Checking the Battery .378
.............................
Vehicle Storage .380
425
Maintenance
Maint enance
327
——
y
y
() yy

ÛÝ
Press
and hold the Select/Reset
knob for about 10 seconds. The
engine oil life and the maintenance
item code(s) will blink. Press
the Select/Reset knob for
another 5 seconds. The
maintenance item code(s) will
disappear, and the engine oil life
will reset to ‘‘100.’’ To
see the current engine oil life,
turn the ignition switch to the ON
(II) position, and push and release
the INFO ( / ) button on the
steering wheel repeatedly, until the
engine oil lif e is displayed (see page ).
3.
4.
80
On RDX with Technology Packagemodel
Maintenance Minder
334
ENGINE OIL
LIFE DISPLAY SEL/RESET BUTTONINFO
BUTTONS
——
y
y
() yy

All maintenance items displayed in
the information display are in code.
For an explanation of these
maintenance codes, see page . Press and hold the SEL/RESET
button on the steering wheel f or
more than 10 seconds. The
remaining engine oil lif e reset
mode will be shown on the multi-
inf ormation display.
Press the SEL/RESET button on
the steering wheel until you see
the engine oil lif e display. Turn the ignition switch to the ON
(II) position.
If maintenance service is done by
someone other than your dealer,
reset the maintenance minder as
f ollows: Your dealer will reset the display
af ter completing the required
maintenance service. You will see
‘‘OIL LIFE 100%’’ on the display the
next time you turn the ignition
switch to the ON (II) position.
1.
2.
3.
343
Maintenance Minder
Maintenance Main Items and Sub
Items Resetting the Engine Oil Lif e
Display
340
MAINTENANCE MAIN ITEMMAINTENANCE SUB ITEM(S)
——
y

y
() yy

ÛÝ
Select ‘‘RESET’’ by pressing the
INFO ( / ) button, then press
the SEL/RESET button to reset
the engine oil lif e display. The
maintenance item code(s) will
disappear, and the engine oil lif e
will reset to ‘‘100.’’ If you want to
cancel the oil lif e reset mode,
select ‘‘CANCEL.’’ If you have the required service
done but do not reset the display, or
reset the display without doing the
service, the system will not show the
proper maintenance intervals. This
canleadtoseriousmechanical
problems because you will no longer
have an accurate record of when
maintenance is needed.
Your authorized Acura dealer knows
your vehicle best and can provide
competent, ef f icient service.
However, service at a dealer is not
mandatory to keep your warranties
in effect. Maintenance may be done
by any qualif ied service f acility or
person who is skilled in this type of
automotive service. Make sure to
have the service f acility or person
reset the display as previously
described. Keep all receipts as proof
of completion, and have the person
who does the work fill out the
maintenance record. Check your
warranty booklet f or more
inf ormation.
We recommend using Acura parts
and fluids whenever you have
maintenance done. These are
manuf actured to the same high-
quality standards as the original
components, so you can be conf ident
of their performance and durability.
4. Important Maintenance
Precautions
Maintenance Minder
Maint enance
341
——
y
y
() yy

Î
Î
Ì Ì
Ì
Î
Maintenance Minder
343
: Maintenance
Main Items
Replace engine oil
Replace engine oil and oil filter
Inspect front and rear brakes
Check parking brake adjustment
Inspect these items:
Tie rod ends, steering gear box, and boots
Suspension components
Driveshaft boots
Brake hoses and lines (including ABS)
All fluid levels and condition of fluids
Exhaust system
Fuel lines and connect ions Maintenance
Sub Items
Rotate tires
Replace air cleaner element
If you drive in dusty conditions, replace
every 15,000 miles (24,000 km).
Replace dust and pollen filter
If you drive primarily in urban areas that have high
concentrations of soot in the air from industry and
from diesel-powered vehicles, replace every 15,000
miles (24,000 km).
Inspect drive belt
Replace transmission and transfer fluid
Driving in mountainous areas at very low vehicle
speeds or trailer towing results in higher
transmission and transfer temperatures. This
requires transmission and transfer fluid changes
more frequently than recommended by the
maintenance minder. If you regularly drive your
vehicle under these conditions, have the transmission
and transfer fluid changed at 60,000 miles
(100,000 km), then every 30,000 miles (48,000 km).
Replace spark plugs
Inspect valve clearance
Replace engine coolant
Replace rear differential fluid
Driving in mountainous areas at very low vehicle
speeds or trailer towing results in higher level of
mechanical (shear) stress to fluid. This requires
differential fluid changes more frequently than
recommended by the Maintenance Minder. If you
regularly drive your vehicle under these conditions,
have the differential fluid changed at 7,500 miles
(12,000 km), then every 15,000 miles (24,000 km).
A
B
Symbol
Symbol
1
2
3
4
5
6
1
1
If the message ‘‘SERVICE’’ does not appear more than 12 months after the
display is reset, change the engine oil every year.
If the message ‘‘SERVICE DUE NOW’’ does not appear more than 12 months
after the display is reset, change the engine oil every year.
See information on maintenance and emissions warranty on page .
Adjust the valves during services A, B, 1, 2, or 3 only if they are noisy. Inspect idle speed every 160,000 miles (256,000 km). Independent of the maintenance items in the information display, replace
the brake fluid every 3 years.
NOTE: 1:
342
On RDX model
On RDX with Technology Package model
Maintenance Minder
——
y
y
() yy

CONT INUED
The transmission should be drained
and ref illed with new f luid when this
service is shown on the inf ormation
display or multi-inf ormation display
(depending on models).Remove the dipstick (yellow loop)
f rom the transmission, and wipe it
with a clean cloth.
If you are not sure how to add f luid
or you do not have the proper
equipment to reach the transmission
f luid f ill hole, you should have this
maintenance done by a skilled
technician.
Park the vehicle on level ground.
Start the engine until the radiator
f an comes on and rotate it once.
Turn of f the engine. For accurate
results, wait at least 60 seconds,
andnomorethan90seconds,
af ter turning of f the engine to
check the f luid level.
Check the f luid level with the engine
at normal operating temperature.
Insert the dipstick all the way into
the transmission securely as
shown in the illustration.
Remove the dipstick and check
the f luid level. It should be
between the upper and lower
marks.
1.
2.
3.
4.
Automatic Transmission Fluid
Maint enance
355
DIPSTICK
LOWER MARK
UPPER MARK
HOT
MARK
——
y
y
() yy