ignition Acura RDX 2008 Owner's Guide

µ
Moves the seat
forward and
backward.Raises or lowers
the seat.
The controls f or the power
adjustable driver’s seat are on the
outside edge of the seat bottom. You
can adjust the seat with the ignition
switch in any position. Make all seat
adjustments before you start driving.
Increases or
decreases the
lumbar support.
Moves the f ront
of the seat up or
down. Adjusts the seat-
back angle
forward or
backward.
Moves the whole
seat up and
f orward, or down
and backward.
The front of the
seat also tilts up
or down at the
same time.
See pagesf or important saf ety
inf ormation and warnings about how toproperly position the seats and seat-backs. 1213
Driver’s Seat Adjustments
Seats
Inst rument s and Cont rols
131
\f—\f—\f
y
y
() 
\fy\f
y
2008 RDX

Follow these precautions whenever
you use the seat heaters:Use the HI setting only to heat the
seats quickly, because it draws
large amounts of current f rom the
battery.
If the engine is lef t idling f or an
extended period, do not use the
seat heaters, even on the LO
setting. It can weaken the battery,
causing hard starting.
In the LO setting, the heater runs
continuously. It does not cycle with
temperature changes.
In the HI setting, the heater turns off
when the seat gets warm, and turns
back on after the seat’s temperature
drops.
Both f ront seats are equipped with
seat heaters. The passenger seat is
only heated in the seat bottom
because of the side airbag cutof f
system. The ignition switch must be in the
ON (II) position to use seat heaters.
Push the top of the switch, HI, to
rapidly heat up the seat. Af ter the
seat reaches a comfortable
temperature, select LO by pushing
the bottom of the switch. This will
keep the seat warm.
Seat Heaters
Inst rument s and Cont rols
139
SEAT HEATER SWITCHES
Passenger’s Seat
Driver’s Seat
HEATERS
\f—\f—\f
y
y
() 
\fy\f
y
2008 RDX

Turn the ignition switch to the ON
(II) position to raise or lower any
window. To open the window, push
the switch down and hold it. Release
the switch when you want to stop the
window. To close the window, pull
back on the switch and hold it.When you push the MAIN switch in,
the switch is off, and the passenger
windows cannot be raised or lowered.
To cancel this f eature, push on the
switch again to get it to pop out.
Keep the MAIN switch of f when you
have children in the vehicle so they
do not injure themselves by
operating the windows
unintentionally.
The windows will operate f or up to
10 minutes af ter you turn of f the
ignition switch. Opening either f ront
door cancels this f unction.
Power Windows
140
DRIVER’S WINDOW
SWITCH
MAIN SWITCH
Closing a power window on
someone’s hands or fingers can
cause serious injury.
Make sure your passengers are
away from the windows before
closing them.
\f—\f—\f
y
\fy
() 
\fy\f
y
2008 RDX

Turn the ignition switch to the ON
(II) position bef ore operating the
moonroof switch on the ceiling
console.
To open the moonroof f ully, pull
back the moonroof switch f irmly.
The moonroof opens all the way. To
stop the moonroof f rom opening
f ully, brief ly move the switch in
either direction.
To tilt the moonroof , push the center
of the moonroof switch straight up.
To stop the moonroof f rom tilting
f ully open, push the moonroof switch
forward.To open or close the moonroof
partially, pull or push the moonroof
switch lightly to the f irst detent and
hold it. The moonroof will stop when
you release the switch.To close the moonroof f ully, push
the moonroof switch f orward to the
second detent, then release it. The
moonroof closes all the way. To stop
the moonroof f rom closing all the
way,brieflymovetheswitchin
either direction.
Moonroof
142
MOONROOF SWITCH
Tilt
Open
Close
\f—\f—\f
y

y
() 
\fy\f
y
2008 RDX

The moonroof has a key-of f delay.
You can open and close the
moonroof f or up to 10 minutes af ter
you turn of f the ignition switch. The
key-of f delay cancels as soon as you
open either f ront door. You must
then turn the ignition switch to the
ON (II) position f or the moonroof to
operate.If the moonroof runs into any
obstacle while it is closing
automatically, it will reverse
direction, and then stop. To close the
moonroof , remove the obstacle, then
use the moonroof switch again.
Auto reverse stops sensing when the
moonroof is almost closed. You
should always check that all
passengers and objects are away
f rom the moonroof bef ore closing it.
Auto Reverse
Moonroof
Inst rument s and Cont rols
143
Opening or closing the
moonroof on someone’s hands
or fingers can cause serious
injury.
Make sure all hands and fingers
are clear of the moonroof
before opening or closing it.
If you try to open the moonroof in
below-f reezing temperatures, or when
it is covered with snow or ice, you can
damage the moonroof panel or motor.
\f—\f—\f
y
\fy
() 
\fy\f
y
2008 RDX

Turn the ignition switch to the ON
(II) position.
Move the selector switch to L
(driver’s side) or R (passenger’s
side).
Keeptheinsideandoutsidemirrors
clean and adjusted f or best visibility.
Be sure to adjust the mirrors bef ore
you start driving. The inside mirror can automatically
darken to reduce glare. To turn on
this feature, press the button on the
bottom of the mirror. The AUTO
indicator comes on as a reminder.
When it is on, the mirror darkens
when it senses the headlights of a
vehicle behind you, then returns to
normal visibility when the lights are
gone. Press the button again to turn
of f this f eature.
1.
2.
Adjusting the Power Mirrors
Mirrors
144
SELECTOR SWITCH
INDICATOR
AUTO BUTTON SENSOR
There is also a sensor on the back of
the mirror. Items hung on the mirror
may block this sensor and af f ect its
perf ormance.
\f—\f—\f
y
y
() 
\fy\f
y
2008 RDX

Push the appropriate edge of the
adjustment switch to move the
mirrorright,left,up,ordown.
When you f inish, move the
selector switch to the center (off)
position. This turns the
adjustment switch of f to keep your
setting.The outside mirrors are heated to
remove fog and frost. With the
ignition switch in the ON (II)
position, turn on the heaters by
pressing the button. The indicator in
the button comes on as a reminder.
Press the button again to turn the
heaters off. Pressing this button also
turns the rear window def ogger on
and off.
Outside mirror positions can be
stored in the driving position
memory system (see page ).
The passenger outside mirror has a
reverse tilt f eature. When in reverse,
the mirror will tilt down slightly to
improve your view as you parallel
park. Shif ting out of reverse will
return the mirror to its original
position.
To turn the feature off, place the
switch in the center or lef t position.
To tilt the passenger mirror, place
the selector switch in the right
position.
3.
4. 146
Heated Mirrors
Reverse Tilt Door Mirror
Mirrors
Inst rument s and Cont rols
145
ADJUSTMENT SWITCH HEATED MIRROR BUTTON
\f—\f—\f
y
y
() 
\fy\f
\fy
2008 RDX

Adjust the seat to a comfortable
position (see page ).
Store a driving position only when
the vehicle is parked.
Turn the ignition switch to the ON
(II) position. You cannot add a
new driving position to the
memory unless the ignition switch
is in the ON (II) position. You can
recall a memorized position with
the ignition switch in any position.
Your vehicle has a memory feature
f or the driver’s seat and outside
mirror positions.
Adjust the outside mirrors f or best
visibility (see page ).Press and release the SET button
on the control panel. You will hear
a beep. Immediately press and
hold one of the memory buttons (1
or 2) until you hear two beeps.
The indicator in the memory
button will come on. The current
positions of the driver’s seat and
outside mirrors are now stored.
Seat, except f or power lumbar, and
outside mirror positions, can be
stored in separate memories. You
select a memorized position by
pushing the appropriate button or
using the appropriate remote
transmitter (Memory 1 or
Memory 2).
3.
1.
2.
131
144
Storing a Driving Position in
Memory
Driving Position Memory System
146
MEMORY BUTTONS
SET BUTTON
\f—\f—\f
y
y
() 
\fy\f

y
2008 RDX

Open any door.
Remove the key from the ignition
switch.
Unlock the doors with the key,
locktabonthedriver’sdoor,
master door lock switch, or
remote transmitter.
After all doors are closed tightly, the
light(s) dims slightly, then f ades out
in about 30 seconds. If you do not open any door af ter
unlocking the driver’s door or
removing the key from the ignition
switch, the light(s) f ade out in about
30 seconds. If you leave any door
open without the key in the ignition
switch, the light(s) will go of f af ter 3
minutes.
You can use the f ront ceiling lights
whenever the lights are of f .
To turn a light on or of f , push its lens.
In the door activated position, both
f ront and rear ceiling lights come on
when you:
To change the ‘‘INTERIOR LIGHT
DIMMING TIME’’ setting, see page.
96 Individual Map L ights
Interior Lights
150
LENSES
\f—\f—\f
y
\f
y
() 
\fy\f
y
2008 RDX

The courtesy lights in the ceiling
console come on when the light
switch is in the or theposition. You can adjust their
brightness by turning the Select/
Reset knob on the instrument panel. The cargo area light has a two
position switch. In the OFF (right)
position, the light does not come on.
In the ON (lef t) position, the light
comesonwhenyouopenthetailgate.
Your vehicle also has a courtesy light
in the ignition switch. This light
comesonwhenyou;
Unlock the driver’s door.
Remove the key from the ignition
switch.
Open any door.
The courtesy light in each f ront door
comes on when the door is opened,
and goes out when the door is closed.
After all doors are closed tightly, the
light f ades out in about 30 seconds.
To change the ‘‘INTERIOR LIGHT
DIMMING TIME’’ setting, see page
.
96
Courtesy Lights Cargo Area Light
Interior Lights
Inst rument s and Cont rols
151
COURTESY LIGHTS
ON OFF
\f—\f—\f
y
\fy
() 
\fy\f
y
2008 RDX