Time Acura RDX 2008 Service Manual

Each f ront door has a master door
lock switch. Either switch locks and
unlocks all doors and the tailgate.
Push the top of the switch to lock all
doors and the tailgate; push the
bottom to unlock them.Each door has a lock tab next to the
inside door handle. When you pull
backward on the lock tab on the
driver’s door, all the doors and the
tailgate lock. Pushing f orward on the
lock tab on the driver’s door unlocks
only that door. The lock tab on the
each passenger’s door locks and
unlocks only that door.When the door is unlocked, you can
seetheredindicatoronthelocktab
next to the inside door handle.
All doors and the tailgate can be
locked f rom the outside by using the
key in the driver’s door lock. To
unlock only the driver’s door, insert
the key, turn the key, and release it.
The remaining doors and the tailgate
unlock when you turn the key a
second time within a f ew seconds.
You can change the ‘‘DOOR LOCK
MODE’’ setting on the multi-
inf ormation display (see page ).
103
CONT INUED
Door L ocks
Power Door L ocks
Inst rument s and Cont rols
123
To unlock
To lock
LOCK TAB
Passenger’s Side MASTER DOOR
LOCK SWITCH
Driver’s Side
Lock Lock
Unlock
Unlock
\f—\f—\f
y
y
() 
\fy\f
y
2008 RDX

To open the tailgate, press and hold
the switch, then lift up.To close the tailgate, hold the
tailgate handle, lower the tailgate,
then press down on the back edge.
Keep the tailgate closed at all times
while driving to avoid damaging the
tailgate and to prevent exhaust gas
f rom getting into the interior. See
on page
.
The tailgate will lock when you lock
the driver’s door, and will unlock
when you unlock all doors.
You can change the ‘‘DOOR LOCK
MODE’’ setting on the multi-
inf ormation display (see page ).
56
103
Carbon Monoxide Hazard
Tailgate
Inst rument s and Cont rols
125
SWITCH TAILGATE
HANDLE
\f—\f—\f
y
\fy
() 
\fy\f
\fy
2008 RDX

µµ
µ
When you press the UNLOCK
button, the ceiling lights (if the f ront
and rear ceiling light switches are in
the door activated position) will
come on. If you do not open any door,
the lights stay on for about 30
seconds, then f ade out. If you relock
the doors with the remote
transmitter before 30 seconds have
elapsed, the lights go of f
immediately.
Press this button once to
lock all doors and the tailgate. Some
exterior lights will f lash. When you
push LOCK twice within 5 seconds,
you will hear a beep to verify that the
doors and tailgate are locked and the
security system has set. This button
does not work if any door or tailgate
is not f ully closed.
To change the ‘‘KEYLESS LOCK
ACKNOWLEDGEMENT’’ setting,
see page . Press this button once
to unlock the driver’s door. Push it
twice to unlock the other doors.
Some exterior lights will f lash twice
when you push the button. If you do
not open any door or the tailgate
within 30 seconds, they will
automatically relock.
To change the ‘‘DOOR LOCK
MODE’’ setting, see page .
To change the ‘‘SECURITY
RELOCK TIMER’’ setting, see page . To change the ‘‘INTERIOR LIGHT
DIMMING TIME’’ setting, see page
.
Pressthisbuttonfor
about 1 second to attract attention;
the horn will sound, and the exterior
lights will f lash f or about 30 seconds.
To cancel panic mode, press any
button on the remote transmitter, or
turn the ignition switch to the ON
(II) position.
105 103
10796
LOCK UNL OCK
PA NIC
Remote Transmitter
Inst rument s and Cont rols
127
UNLOCK
BUTTONLOCK
BUTTON
PANIC
BUTTON
\f—\f—\f
y
y
() 
\fy\f
y
2008 RDX

Here are the settings activated with
the remote;
When you unlock the driver’s door
with your remote, each remote
activates the keyless memory
settings related to that remote. The
driver’s ID (MEMORY 1 or
MEMORY 2) is shown on the back
of each remote. To turn of f this f eature, press and
hold the LOCK and UNLOCK
buttonsatthesametime.TheLED
in the remote will blink twice. Then
release the buttons. Doing this
cancels the keyless memory settings
f or that remote.
Driving position memory
(see page ).
To turn the keyless memory settings
back on, repeat this procedure. The
LED will blink once to indicate the
f eature has been turned on.
When you unlock and open the
driver’s door with the remote
transmitter, the driver’s seat (except
the power lumbar feature) and
outside mirrors start to move to the
positions stored in memory. The
indicator in the related memory
button to the remote comes on. 146
K eyless Memory Settings
Remote Transmitter
130
TM
\f—\f—\f
y
y
() 
\fy\f
y
2008 RDX

µ
Moves the seat
forward and
backward.Raises or lowers
the seat.
The controls f or the power
adjustable driver’s seat are on the
outside edge of the seat bottom. You
can adjust the seat with the ignition
switch in any position. Make all seat
adjustments before you start driving.
Increases or
decreases the
lumbar support.
Moves the f ront
of the seat up or
down. Adjusts the seat-
back angle
forward or
backward.
Moves the whole
seat up and
f orward, or down
and backward.
The front of the
seat also tilts up
or down at the
same time.
See pagesf or important saf ety
inf ormation and warnings about how toproperly position the seats and seat-backs. 1213
Driver’s Seat Adjustments
Seats
Inst rument s and Cont rols
131
\f—\f—\f
y
y
() 
\fy\f
y
2008 RDX

Each f ront and rear ceiling light has
a three-position switch.
Front ceiling lights:
In the ‘‘ ’’ position, both f ront
and rear ceiling lights are on all the
time except when the rear ceiling
light switch is in the OFF position.In the ‘‘ ’’ position, both f ront
and rear ceiling lights are of f all the
time.
With the f ront ceiling lights switch in
this position, the rear ceiling light
does not work, and both f ront and
rear ceiling lights do not come on
when you open any door.
Rear ceiling light:
You can use the rear ceiling light
independently. In the OFF position,
the light does not come on even if
the f ront ceiling light switch is in the
‘‘ ’’ position. In the ON position,
the light stays on continuously
except when the f ront ceiling light
switch is in the ‘‘ ’’ position.
CONT INUED
Ceiling L ights
Interior Lights
Inst rument s and Cont rols
149
FrontDOOR ACTIVATED DOOR ACTIVATED
Rear OFF
ON
\f—\f—\f
y
\f

y
() 
\fy\f
y
2008 RDX

Open any door.
Remove the key from the ignition
switch.
Unlock the doors with the key,
locktabonthedriver’sdoor,
master door lock switch, or
remote transmitter.
After all doors are closed tightly, the
light(s) dims slightly, then f ades out
in about 30 seconds. If you do not open any door af ter
unlocking the driver’s door or
removing the key from the ignition
switch, the light(s) f ade out in about
30 seconds. If you leave any door
open without the key in the ignition
switch, the light(s) will go of f af ter 3
minutes.
You can use the f ront ceiling lights
whenever the lights are of f .
To turn a light on or of f , push its lens.
In the door activated position, both
f ront and rear ceiling lights come on
when you:
To change the ‘‘INTERIOR LIGHT
DIMMING TIME’’ setting, see page.
96 Individual Map L ights
Interior Lights
150
LENSES
\f—\f—\f
y
\f
y
() 
\fy\f
y
2008 RDX

The courtesy lights in the ceiling
console come on when the light
switch is in the or theposition. You can adjust their
brightness by turning the Select/
Reset knob on the instrument panel. The cargo area light has a two
position switch. In the OFF (right)
position, the light does not come on.
In the ON (lef t) position, the light
comesonwhenyouopenthetailgate.
Your vehicle also has a courtesy light
in the ignition switch. This light
comesonwhenyou;
Unlock the driver’s door.
Remove the key from the ignition
switch.
Open any door.
The courtesy light in each f ront door
comes on when the door is opened,
and goes out when the door is closed.
After all doors are closed tightly, the
light f ades out in about 30 seconds.
To change the ‘‘INTERIOR LIGHT
DIMMING TIME’’ setting, see page
.
96
Courtesy Lights Cargo Area Light
Interior Lights
Inst rument s and Cont rols
151
COURTESY LIGHTS
ON OFF
\f—\f—\f
y
\fy
() 
\fy\f
y
2008 RDX

If you press the OFF button, the
climate control system shuts of f
completely.
Air flows from the center
and corner vents in the dashboard.
Airf low is divided between
the vents in the dashboard and the
f loor vents.
Air f lows f rom the f loor
vents.
Airf low is divided between
the f loor vents and the def roster
vents at the base of the windshield. To keep stale air and mustiness
f rom collecting, you should have
the f an running at all times.
Keep the system of f f or short
periods only.
The mode indicator in the display
changes to the current mode each
time you press the button.
When the climate control system is
turned off, the temperature in the
display will also turn of f .
Use the MODE button to select the
vents the air flows from. Some air
will f low f rom the dashboard corner
vents in all modes.
To Turn Everything Off
Mode Button
Climate Control System
164
\f—\f—\f
y

y
() 
\fy\f
y
2008 RDX

To load a single disc:Press and release the LOAD
button on the changer unit. You
will see ‘‘BUSY’’ on the center
display, and the disc load indicator
turns red and starts blinking.
Insert a disc into the disc slot
when the disc load indicator turns
green and ‘‘LOAD’’ appears on the
center display at the same time.
Insert the disc only about half way;
the drive will pull it in the rest of
the way. You will see the disc
indicator blinking on the center
display.
To load multiple discs in one
operation:
When the disc load indicator turns
green and ‘‘LOAD’’ appears on the
center display again, insert the
next CD in the slot.
Do not try to insert a disc until
‘‘LOAD’’ appears. You could
damage the audio unit.
Repeat steps 1 through 3 until all
six positions are loaded. If you are
not loading all six positions, press
the LOAD button again after the
last CD has loaded. ‘‘DISC READ’’
appears on the center display, then
the system begins playing the last
CD loaded.
If you stop loading discs bef ore all
six positions are f illed, the system
will wait f or 10 seconds, stop the load
operation, and begin playing the last
disc loaded.
Press and hold the LOAD button
on the changer unit until you hear
a beep. You will see ‘‘BUSY’’ on
the center display, and disc load
indicator turns red and starts
blinking.
Insert the disc into the disc slot
when the disc load indicator turns
green and ‘‘LOAD’’ appears on the
center display at the same time.
Insert it only half way; the drive
will pull it in the rest of the way.
You will see ‘‘BUSY’’ on the center
display, and the disc load indicator
turns red again and blinks as the
CD is loaded.
Do not try to insert a disc until
‘‘LOAD’’ appears. You could
damage the audio unit.
1.
2.
3.
1.
2. 4.
Audio System
L oading CDs in the Changer
176
\f—\f—\f
y
y
() 
\fy\f

y
2008 RDX